Tuning the properties of a black TiO2-Ag visible light photocatalyst produced by a rapid one-pot chemical reduction

A highly efficient black TiO₂-Ag photocatalytic nanocomposite, active under both UV and visible light illumination, was synthesized by decorating the surface of 25 nm TiO₂ particles with Ag nanoparticles. The material was obtained via a rapid, one-pot, simple (surfactant and complexing agent free) chemical reduction method using silver nitrate and formaldehyde as a metal salt and reducing agent, respectively. The nanocomposite shows an increase of over 800% in the rate of photocatalytic methylene blue dye degradation, compared to commercial unmodified TiO_2, under UV-VIS illumination. Unlike pure TiO₂, the nanocomposite exhibits visible light activation, with a corresponding drop in optical reflectance from 100% to less than 10%. The photocatalytic properties were shown to be strongly enhanced by post-reduction annealing heat treatments in air, which were observed to decrease, rather than coarsen, silver particle size, and increase particle distribution. This, accompanied by a variation in the silver surface oxidation states, appear to dramatically affect the photocatalytic efficiency under both UV and visible light. This highly active photocatalyst could have wide ranging applications in water and air pollution remediation and solar fuel production.     

辛巴蓝F-3GA修饰的啤酒废酵母菌亲和吸附溶菌酶

利用j嗪染料辛巴蓝F-3GA修饰经戊二醛交联的啤酒废酵母菌,得到一种新型染料亲和吸附剂.辛巴蓝F-3GA的固载量为161.1 mg/g.以溶菌酶为研究对象,考察吸附时间、酶初始浓度、pH值、离子强度等因素对吸附率的影响.结果表明:当pH=7.0时,其对溶菌酶有较高的吸附量(229.1 mg/g),吸附性能明显优于未接枝...     

Synthesis of Patent Blue derivatized hydrophilic dendrons dedicated to sentinel node detection in breast cancer

In the last decade, methods for the precise localization of sentinel lymph node (SLN) have drawn tremendous attention by oncology surgeons and researchers in the field of medical diagnosis. The accurate identification and characterization of lymph nodes by imaging has important therapeutic and prognostic significance in patients with newly diagnosed cancers. The SLN is the first lymph node that receives lymphatic drainage from the site of a primary tumor. Two biocompatible dendronized phosphonates, one bearing a Patent Blue (PB VF) dye at its periphery, where synthesized. Indeed, such a blue dye is currently injected to label the lymph node system for its per-operative detection. Therefore, developing chemistry of Patent Blue VF to optimize early diagnosis is of great current interest.     

Thermal expansion in 3d-metal Prussian Blue Analogs—A survey study

We present a comprehensive study of the structural properties and the thermal expansion behavior of 17 different Prussian Blue Analogs (PBAs) with compositions M^II₃[(M′)^III(CN)₆]₂·nH₂O and M^II₂[Fe^II(CN)₆]·nH₂O, where M^II=Mn, Fe, Co, Ni, Cu and Zn, (M′)^III=Co, Fe and n is the number of water molecules, which range from 5 to 18 for these compounds. The PBAs were synthesized via standard chemical precipitation methods, and temperature-dependent X-ray diffraction studies were performed in the temperature range between −150 °C (123 K) and room-temperature. The vast majority of the studied PBAs were found to crystallize in cubic structures of space groups Fm3?m, F4?3m and Pm3?m. The temperature dependence of the lattice parameters was taken to compute an average coefficient of linear thermal expansion in the studied temperature range. Of the 17 compounds, 9 display negative values for the average coefficient of linear thermal expansion, which can be as large as 39.7×¹0⁻⁶ K⁻¹ for Co₃[Co(CN)₆]₂·12H₂O. All of the M^II₃[Co^III(CN)₆]₂·nH₂O compounds show negative thermal expansion behavior, which correlates with the Irving–Williams series for metal complex stability. The thermal expansion behavior for the PBAs of the M^II₃[Fe^III(CN)₆]₂·nH₂O family are found to switch between positive (for M=Mn, Co, Ni) and negative (M=Cu, Zn) behavior, depending on the choice of the metal cation (M). On the other hand, all of the M^II₂[Fe^II(CN)₆]·nH₂O compounds show positive thermal expansion behavior.     

Study on Adsorption States by Surface-Enhanced Raman Spectroscopy

Abstract

SERS has been used as a state-resolving probe to study the adsorption states. in the case of pyridine (Py) adsorbed on the Ag electrode surface, the equilibrium and transition between two adsorbed states, i.e., the perpendicular mode adsorbed through the nitrogen lone-pair electrons and the flat mode through the π electrons of the aromatic ring, were studied. It was found that in the low pyridine concentration or the initial stage of adsorption, the flat mode was favored. While the concentration became higher and the adsorption tended to equilibrium, the adsorbed molecules would transit to the perpendicular mode. The similar phenomenon was also observed when changing the applied electric potential and the pH value of the solution. In the case of the adsorption of Methylene Blue (MB) on the HNO₃-etched silver surface, the influence of Cl^? ions on the adsorption states of MB was investigated. It showed that MB molecules adsorbed on the silver surface tended to transform from the “lying-down” state to the “end-on” state while adding Cl^? ions.     

Electrophoretic isolation of membrane proteins from acrylamide gels

Protocols for the optimal resolution of membrane and watersoluble proteins in SDS-denatured state (Tricine SDS-PAGE and Blue Tricine SDS-PAGE; Laemmli SDS-PAGE and Blue Laemmli SDSPAGE) and in the native state (Blue Native PAGE) are presented. The protocols for protein recovery from these gels include techniques of electroelution and electroblotting optimized to the type of the preceding electrophoresis system. Native and denatured proteins thus are obtainable in near quantitative yield in soluble and in immobilized form. These techniques can optionally be performed in the milligram range, e.g., for the use of immunization and N-terminal protein sequencing, or in the analytical range.     

High performance liquid chromatographic analysis of Patent Blue V in cheese

Summary The HPLC method developed for the analysis of the dye Patent Blue V in extracts from cheese is sufficiently sensitive to detect and measure concentrations above 0.1 ppm with a standard deviation of 3%. The extraction procedure described gives a recovery from cheese of about 80%. The method has been applied to commercial samples of cheese and a concentration of the dye of about 0.12 ppm was measured in one case.     

Synthesis of nano-size BaMgAl10O17:Eu blue phosphor by a rapid exothermic reaction

Ultrafine particles of BaMgAl₁₀O₁₇:Eu²⁺ (BAM) phosphor were synthesized by a solid-state combustion reaction in a powder bed of 0.9BaCO₃+MgO+5Al₂O₃+0.05Eu₂O₃+k(KClO₃+1.5C) composition. A large exothermic reaction of the mixture (KClO₃+1.5C) leads to a self-sustaining combustion mode. Under optimized combustion conditions, the product consisted of BAM powder and KCl was obtained. BAM ultrafine particles resulting from the combustion process were easily obtained by simply washing the salt by-product with water. Combustion-processed BAM phosphor shows a homogeneous grain size of 100-500 nm, good dispersity, regular morphology, and improved luminescence properties.