Efficient synthesis of p-bis-(chlorodifluoromethyl)benzene

Selective, high yield partial fluorination of p-bis-(trichloromethyl)benzene to p-bis-(chlorodifluoromethyl)benzene has been accomplished by warming a slurry of the p-bis-(trichloromethyl)benzene in anhydrous HF which also contains a small quantity of inert solvent, such as 1,2-dichloroethane.     

Degradation-fragmentation of marine plastic waste and their environmental implications: A critical review

This review critically evaluates the plastic accumulation challenges and their environmental (primarily) and human (secondarily) impacts. It also emphasizes on their degradation and fragmentation phenomena under marine conditions. In addition, it takes into account the leachability of the various chemical substances (additives) embedded in plastic products to improve their polymeric properties and extend their life. Regardless of their effectiveness in enhancing the polymeric function of plastic products, these additives can potentially contaminate air, soil, food, and water. Several findings have shown that, regardless of their types and sizes, plastics can be degraded and/or fragmented under marine conditions. Therefore, the estimation of fragmentation and degradation rates via a reliable developed model is required to better understand the marine environmental status. The main parameter, which is responsible for initiating the fragmentation of plastics, is sunlight/UV radiation. Yet, UV- radiation alone is not enough to fragment some plastic polymer types under marine conditions, additional factors are needed such as mechanical abrasion. It should be also mentioned that most current studies on plastic degradation and fragmentation centered on the primary stages of degradation. Thus, further studies are needed to better understand these phenomena and to identify their fate and environmental effects.     

酚醛型氰酸酯与双酚A型环氧共固化反应的FTIR研究

在恒温固化条件下,通过FTIR跟踪方法,研究了酚醛型氰酸酯与双酚A型环氧共固化反应的路径及其反应机理.共固化体系的反应过程包括在150℃及其以下温度,主要发生的是氰酸酯的三嗪环化固化反应,其中三嗪环化固化反应由于环氧的加入,反应速率被极大地提高了;同时,酚醛型氰酸酯中的氨基甲酸酯类杂质与环氧发生开环聚合反应,引起环氧官能团产生弱而持续的消耗.但在此阶段,酚醛型氰酸酯与环氧之间没有化学反应发生;在180℃及其以上温度,三嗪环和环氧发生反应,异构为异氰脲酸环结构,并进一步反应生成唑啉酮环结构,由于该反应的发生,促进了环氧官能团的消耗速度,在环氧官能团的转化率-时间图中,出现倒S曲线;在三嗪环的转化率图中,出现一个极大值后再降落的曲线.反应温度的提高有利于促进酚醛型氰酸酯与环氧之间的共固化反应,特别是当反应温度为220℃时,氰酸酯官能团和环氧官能团的消耗、三嗪环和唑啉酮环的生成均以较快的速率进行,—OCN生成三嗪环的转化率可以较容易地达到1,而唑啉酮环的转化率不超过0.5.     

Evaluation of an on-line coupled continuous flow liquid membrane extraction and precolumn system as trace enrichment technique by liquid chromatographic determination of bisphenol A

An on-line coupled continuous flow liquid membrane extraction (CFLME) and C₁₈ precolumn system was developed for sample preconcentration in liquid chromatography determination. After preconcentration by CFLME, which is based on the combination of continuous flow liquid–liquid extraction and supported liquid membrane, bisphenol A (BPA) was enriched in 960 μl of 1 mol l⁻¹ NaOH used as acceptor. This acceptor was on-line neutralized and transported onto the C₁₈ precolumn where analytes were absorbed and focused. Then the focused analytes were injected onto a C₁₈ analytical column for separation and detected at 220 nm with a diode array detector. CFLME related parameters such as flow rates, pH of donor and acceptor, and enrichment time were optimized. The proposed method presents a detection limit of 0.03 μg l⁻¹ (S/N=3) when 60 ml samples was enriched with an enrichment time of 30 min. Compared with C₁₈ based column-switching procedure, this proposed procedure presents similar sample throughput and lower detection limits. The proposed method was successfully applied to determine BPA in tap water, river water, and municipal sewage effluent samples.     

Chemical analysis for small amounts of horseradish peroxidase using “porphyrinogen” as a chromogenic reagent

The properties of porphyrinogen as a new chromogenic reagent were examined. 5,10,15,20-Tetrahydro-tetraphenylporphyrinogen (TPPN) is changed to 5,10,15,20-tetraphenylporphine (TPP) by the oxidative reaction involving six electrons, and its formation of the porphine ring significantly increased the absorbance in the Soret band.The horseradish peroxidase (HRP) accelerated the oxidative reaction as a catalyst and the increment of absorbance depended upon the increase in the concentration of HRP. The reaction proceeded in the presence of dissolved oxygen and in the neighborhood of pH 7. Based on these findings, a chemical analysis by catalytic action using HRP was developed.In the procedure for this determination, the difference in absorbance at 419 nm (ΔA₄₁₉=A_s−A_b, where A_s and A_b are the absorbances of the sample solution containing HRP and the blank solution without HRP after 30 min, respectively), was measured. The determination range of HRP, which was obtained from the ΔA₄₁₉—HRP concentration curve, was 0.05-1.0 mg/l. The relative standard deviation in the median of the calibration curve was 3.19% (seven determinations), and the detection limit (S/N=3) was 29 ng/l. Furthermore, when the proposed method was applied to the enzyme immunoassay, bisphenol A (BPA) was selectively and sensitivity determined.     

Two-dimensional TiO2 (001) nanosheets as an effective photo-assisted recyclable sensor for the electrochemical detection of bisphenol A

Electrochemical detection is an efficient method for the detection of Bisphenol A (BPA). Herein, a sensitive photo-electrochemical sensor based on two-dimensional (2D) TiO₂ (001) nanosheets was fabricated and then used for BPA electrochemical detection. Upon light irradiation, the 2D TiO₂ (001) nanosheets electrode provided a lower detection limit of BPA detection compared with an ambient electrochemical determination. The low detection limit is ∼5.37 nmol/L (S/N = 3). Furthermore, profiting from the photoelectric characteristics, the 2D TiO₂ (001) nanosheets electrode exhibits a nice regeneration property. After 45 min of light irradiation, the electrochemical signal was regenerated from 14.7% to 82.9% of the original signal at the 6^th cycle. This is attributed to the non-selective OH mediation produced by the 2D TiO₂ (001) nanosheets mineralizing anodic polymeric products and resuming surface reactive sites. This investigation indicates that photo-assistance is an efficient method to improve the electrochemical sensor for detecting BPA in water environments.     

Continuous solid-phase extraction and preconcentration of bisphenol A in aqueous samples using molecularly imprinted columns

A bisphenol A (BPA) molecularly imprinted polymer, the composition of which was optimised using a chemometric approach, has been applied to the selective preconcentration of the template from aqueous samples. The selectivity of the polymer toward BPA and related compounds was evaluated chromatographically. The BPA-imprinted polymer was packed in a column and used for continuous on-column solid-phase extraction (MISPE) of aqueous samples followed by subsequent analysis by HPLC with fluorescence detection of the eluted fractions. The composition of the washing solvent applied in the MISPE procedure was optimised to favour the specific interactions of the MIP with BPA and to remove the non-selectively bound matrix components. The MISPE method has proven to be effective for selective preconcentration of BPA in aqueous samples (recoveries >84% obtained in the eluate for 10–100 mL sample volumes) enabling detection and quantification limits of 1.0 and 3.3 ng mL^–1, respectively (based on 25 mL sample size). Analytical recoveries were between 92 and 101% for river water samples spiked with known amounts of BPA (30, 60, and 80 ng mL^–1); relative standard deviations (RSD) were lower than 5.0%.     

CHARACTERIZATION OF MELT-MIXED POLY(ETHYLENE-2,6-NAPHTHALATE) (PEN)/POLYCARBONATE (PC) BLENDS

ABSTRACT

Melt blending of poly(ethylene naphthalate) (PEN) and bisphenol A polycarbonate (PC) was performed without the addition of catalyst in a batch mixer at 290°C at various compositions. All the blends prepared exhibited a biphasic character and had very good mechanical properties, in some cases, even better than those of the respective pure constituents. This behavior was attributed to a copolymer formation in the mesophase, which effectively compatibilizes the system. The formation of a PEN/PC block copolymer was considered to be due to transesterification reactions between PEN and PC and was verified by extraction experiments and examination of the soluble and insoluble fractions by various spectroscopic techniques.     

pTSA-catalyzed condensation of xylenols and aldehydes under solvent-free conditions: One-pot synthesis of 9H-xanthene or bisphenol derivatives

A simple and efficient procedure for the synthesis of 9H-xanthene or bisphenol derivatives has been developed by one-pot condensation of xylenols with aromatic aldehydes in the presence of p-toluenesulfonic acid (pTSA) as a catalyst under solvent-free conditions at 100 °C. It is noteworthy that the condensation reaction of 3,5-xylenol with aldehydes produces 9H-xanthene derivatives, while the reaction with other xylenols leads to the corresponding bisphenol derivatives. Different types of aromatic aldehydes are used in the reaction and in every case the products were obtained in good to excellent yields. The structures of these compounds were established on the basis of IR, ¹H NMR, ¹³C NMR and CHN data.     

Synergistic Effect of Lithium Perchlorate and Sodium Hydroxide in the Preparation of Electrochemically Treated Pencil Graphite Electrodes for Selective and Sensitive Bisphenol A Detection in Water Samples

In this study, pencil graphite electrodes were activated electrochemically in the presence of different supporting electrolytes and used for the selective and sensitive determination of bisphenol A (BPA) in water samples. Synergistic effects of both LiClO₄ and NaOH supporting electrolytes on the performance of the electrochemically treated pencil graphite electrode (ETPGE) were demonstrated in the oxidation of BPA. The electrochemical behavior of BPA on the ETPGE showed two irreversible oxidation peaks at 0.744 V and 0.877 V (vs. SCE). The detection limit was determined to be 3.1 nM. This single‐use electrode is a very promising candidate to overcome the passivation problems arising from the oxidation of BPA. The analytical application of the ETPGE was performed in tap and river water samples.