氯化钠团簇的形成规律与结合能计算

当离子蒸气冷凝形成团簇时，其结构表现出特定的规律。文中对不同大小不同形状的氯化钠团簇结构与结合能进行了计算，以求揭示离子蒸气冷凝形成团簇的一些规律，并与实验结果进行对照。     

Mg-Nd-Zr-Zn合金的制备及钕对合金组织性能的影响

在RJ-2溶剂和Be的联合保护下制备了Mg-Nd-Zr-Zn系合金. 通过对合金组织的分析, 以及Nd对组织性能影响的研究, 试制出了Nd添加量合理的Mg-Nd-Zr-Zn合金. 经过测试, 认为Nd添加量的增加提高了合金的250 ℃高温抗拉强度, 当Nd添加量超过2.8%时, 合金的高温强化作用不十分显著. Mg-Nd-Zr-Zn合金在250 ℃时的拉伸断裂方式主要是韧性断裂.     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Early-stage flocculation kinetics of polystyrene latex particles with polyelectrolytes studied in the standardized mixing: Contrast of excess and moderate polyelectrolyte dosage

Standardized mixing procedure was applied to the analysis of flocculation of polystyrene latex (PSL) particles with polyelectrolytes. After confirming the initial enhancement of flocculation rate in the very beginning followed by abrupt stop with excess dosage, attention was shifted to the system of moderate dosage. In the former, effects of ionic strength were further analyzed to find the consistency with adsorption isotherm. In the latter, flocculation started slowly in the beginning, sometime slower than salt-induced rapid coagulation, however, the rate gradually increases in the middle stage. Often, the increased rate exceeds that of salt-induced rapid coagulation. This behavior emerged more clearly in the case of lower ionic strength. This is the indication that the rate of relaxation of polymer on the colloidal surface is a function of surface coverage and ionic strength. The ultimate degree of flocculation is usually higher than that observed for excess dosage. The size distribution of flocs was also examined, however, no clear difference between different experimental conditions was confirmed for the same degree of flocculation.     

Studies on the Spectral Behavior between Protein with Poniacyl Carmine 2B and its Analytical Application

In this paper, the spectral behavior of protein and Poniacyl Carmine 2B (PC 2B) has been studied by spectrophotometric method. The conditional constants, apparent combination constant K and maximum binding number n, were used to express the combination ability of the reactions between PC 2B and protein under a set of given conditions. The Sandell index s was used to express the sensitivity of the determination of protein. The factors, acidity, PC 2B concentration and the ionic strength, were discussed by the change of apparent combination constant and maximum binding number. It was found that acidity of the solution, PC 2B concentration and ionic strength had a significant effect on the sensitivity of the assay of protein. Under the optimal conditions, the apparent combination constant K and the maximum binding number n were 2.36 × 10⁶ L mol^?1 and 95, respectively. With further investigation, it was found that the Scatchard model was suitable in treating the data obtained in the experiments. In the buffer medium of HCl‐KCl at 1.87, the addition of protein made the maximum absorption of the system move from 527 nm to 513 nm. Its apparent molar absorptivity is 4.46 × 10⁵ Lmol^?1 cm^?1 at 513 nm. Beer's law is obeyed in the range of 0 ? 55 μg mL^?1. The system developed in this paper has been used for the determination of protein in milk powder successfully.     

电沉积羟基磷灰石/TiO2复合涂层

结合强度;电沉积羟基磷灰石/TiO2复合涂层     

Second Dissociation Constants of 4-[N-morpholino]butanesulfonic Acid and N-[2-hydroxyethyl]piperazine-N′-4-butanesulfonic Acid from 5 to 55°C

The values of the second dissociation constant, pK ₂, for the dissociation of the NH⁺ charge center of the zwitterionic buffer compounds 4-(N-morpholino)butanesulfonic acid (MOBS), and N-(2-hydroxyethyl)piperazine-N-4-butanesulfonic acid (HEPBS) have been determined from 5 to 55°C, including, 37°C at intervals of 5°C. The electromotive-force (emf) measurements have been made utilizing hydrogen electrodes and silver–silver chloride electrodes. The value of pK ₂ for MOBS was found to be 7.702 ± 0.0005, and 8.284 ± 0.0004 for HEPBS, at 25°C, respectively. The related thermodynamic quantities, G ^o, H ^o, S ^o, and C _p ^o for the dissociation processes of MOBS and HEPBS have been derived from the temperature coefficients of pK ₂. Both the MOBS and HEPBS buffer materials are useful as primary pH standards for the control of pH 7.3 to 8.6 in the region close to that of physiological fluids.     

羟丙基甲基纤维素作为水泥添加剂研究(四)

以萘磺酸甲醛缩合物为分散剂，水溶性羟丙基甲基纤维素衍生物为粘稠剂，研究了它们的混合物对混凝土材料的分散性与粘稠性及其它性能的影响，并探索了其作用机理。     

JD树脂刻蚀及涂层的XPS研究

ＪＤ光学树脂表面刻蚀过程的ＸＰＳ研究表明，引进树脂遥ＣＯＨ，Ｃ＝Ｏ，Ｃ－ＳＯ３Ｈ，ＣＯＯＨ等基因随刻蚀温度的提高或时间的延长而增加，对其相对含量进行了计算，固化后的耐磨涂层具有ＳｉＯ２结构，ＪＤ板材的最佳刻蚀条件为２０℃，２０ｍｉｎ。