Limit behavior of the global solutions to the Degasperis-Procesi-type equation

In this paper, we study the Degasperis-Procesi equation with a physically perturbation term—a linear dispersion. Based on the global existence result, we show that the solution of the Degasperis-Procesi equation with linear dispersion tends to the solution of the corresponding Degasperis-Procesi equation as the dispersive parameter goes to zero. Moreover, we prove that smooth solutions of the equation have finite propagation speed: they will have compact support if its initial data has this property.     

基于和积和最大积的信念传播算法的收敛性分析

在介绍马尔可夫网络和标准信念传播(Belief Propagation,BP)算法的基础上,以具有4个隐含结点的无环马尔可夫网络为例,详细分析了基于和积和最大积的BP算法收敛性,结果表明,在网络为无环马尔可夫网络时,基于和积的BP算法收敛于全局最优解,而基于最大积的BP算法在任何初值条件下,只要经过有限次迭代,BP算法必收敛到唯一固定点,若算法有唯一最优点,则此固定点为最优点.以实证分析为工具,研究BP算法收敛性,可作为BP算法基础理论研究的一次有益尝试.     

Minimizing UV noise in supercritical fluid chromatography. I. Improving back pressure regulator pressure noise

Pressure fluctuations and resulting refractive index changes, induced by the back pressure regulator (BPR) can be a significant source of UV detector noise in supercritical fluid chromatography (SFC). The refractive index (RI) of pure carbon dioxide (CO(2)) changes ≈0.2%/bar at the most commonly used conditions in supercritical fluid chromatography (SFC) (40 °C and 100 bar), compared to 0.0045%/bar for water (CO(2) IS 44× worse). Changes in RI cause changes in the focal length of the detector cell which results in changes in UV intensity entering the detector. The change in RI (ΔRI/bar) of CO(2) decreases 8-fold at 200 bar, compared to 100 bar. A new back pressure regulator (BPR) design representing an order of magnitude improvement in the state of the art is shown to produce peak to peak pressure noise (PN(p-p)) as low as 0.1 bar, at 200 bar, and 20Hz, compared to older equipment that attempted to maintain PN(p-p)<1bar, at <5Hz. With this lower PN(p-p), changes in baseline UV offsets could be measured as a function of very small changes in pressure. A pressure change of ±1 bar at 100 bar, common with some older BPR's, produced a UV baseline offset >0.5 mAU. A pressure change of ±0.5 bar representing the previous state-of-the-art, resulted in a UV offset of 0.3m AU. Baseline noise <0.05 is required to validate methods for trace analysis. The new BPR, with a PN(p-p) of 0.1 bar, demonstrated UV peak to peak noise (N(p-p))<0.02 mAU with a >0.03 min (10Hz) electronic filter under some conditions. This new low noise level makes it possible to validate SFC methods for the first time.     

On the use of some numerical damping methods of spurious oscillations in the case of elastic wave propagation

The use of finite element and finite difference methods of spatial and temporal discretization for solving structural dynamics problems gives rise to purely numerical errors. Among the many numerical methods used to damp out the spurious oscillations occurring in the high frequency domain, it is proposed here to analyse and compare the well-known Bulk Viscosity method, which modifies the stresses calculations and a method recently presented by Tchamwa and Wielgosz, which is based on a modification of an explicit time integration algorithm. The efficiency of both methods is evaluated in a 2-D axisymmetric compressive test.     

Bauschinger and size effects in thin-film plasticity due to defect-energy of geometrical necessary dislocations

The Bauschinger and size effects in the thinfilm plasticity theory arising from the defect-energy of geometrically necessary dislocations (GNDs) are analytically investigated in this paper. Firstly, this defect-energy is deduced based on the elastic interactions of coupling dislocations (or pile-ups) moving on the closed neighboring slip plane. This energy is a quadratic function of the GNDs density, and includes an elastic interaction coefficient and an energetic length scale L. By incorporating it into the work- conjugate strain gradient plasticity theory of Gurtin, an energetic stress associated with this defect energy is obtained, which just plays the role of back stress in the kinematic hardening model. Then this back-stress hardening model is used to investigate the Bauschinger and size effects in the tension problem of single crystal Al films with passivation layers. The tension stress in the film shows a reverse dependence on the film thickness h. By comparing it with discrete-dislocation simulation results, the length scale L is determined, which is just several slip plane spacing, and accords well with our physical interpretation for the defect- energy. The Bauschinger effect after unloading is analyzed by combining this back-stress hardening model with a friction model. The effects of film thickness and pre-strain on the reversed plastic strain after unloading are quantified and qualitatively compared with experiment results.     

Probing the nature of the contact between fine particles by using ultrasound propagation

The propagation velocity (vs) of an ultrasonic signal through a granular material depends on the type of interparticle contact. For noncohesive glass beads, a power law behavior for consolidation stresses applied (σc) above 1 MPa has been measured in previous work. This equation is compatible with Hertz's interaction law between elastic solids. In the present work, we have tested the propagation velocity of ultrasound signals through a sample of fine powder. The tensile strength and compactivity of the powder were previously measured by means of the Seville powder tester (SPT), indicating plastic deformation of the surface asperities in contact for small to moderate consolidation stresses. However, the measurements of ultrasound propagation at high consolidations presented here are compatible with Hertz's law. This finding suggests that for high consolidation stresses, surface asperities are flattened, and it is therefore the elastic deformation of the bulk of the particles that determines the transmission of ultrasonic pulses.     

矿尘影响下生态系统脆弱性级联传播模型分析

为了解决矿尘连续排放并迁移对地表生态系统造成的脆弱性问题,提出了基于函数地理Petri网的脆弱性级联传播模型。综合考虑污染物迁移方向和生态环境在地理空间上的关联关系,直观地构造了基于级联传播的污染Petri网。在此基础上,定义了基于VCPM的脆弱度和阈值的概念,利用两者的关系进行脆弱性级联传播分析,从而明确级联传播的三种状态。最后,以神府煤田矿尘迁移作为污染物连续排放的污染源,通过模型方法的模拟仿真分析,对生态环境系统在级联传播下的脆弱性进行了深入探讨。已有的研究方法和结果不仅在生态环境脆弱性研究领域做出了新的贡献,而且为环境的修复和重建提供了参考价值。     

Trapping of electromagnetic wave in single-negative metamaterial waveguides

We study the trapping properties of transverse magnetic (TM) waves in single-negative metamaterial waveguides including epsilon-negative (ENG) metamaterial and mu-negative (MNG) metamaterial. The relationship between effective refractive index and reduced core width is analyzed when the permittivities of ENG and MNG metamaterials are different, and the inflection on this curve can be regarded as the trapping point. Simulation results show that the properties in an ENG–MNG–ENG metamaterial waveguide are contrary to that in a MNG–ENG–MNG metamaterial waveguide. The sensitivity of trapping point to the change of permittivity makes the single-negative metamaterial waveguides to be an effective method to detect the permittivity variation and can be used as a new kind of waveguide sensor.     

Image segmentation using adaptive loopy belief propagation

Loopy belief propagation (LBP) algorithm over pairwise-connected Markov random fields (MRFs) has become widely used for low-level vision problems. However, Pairwise MRF is often insufficient to capture the statistics of natural images well, and LBP is still extremely slow for application on an MRF with large discrete label space. To solve these problems, the present study proposes a new segmentation algorithm based on adaptive LBP. The proposed algorithm utilizes local region information to construct a local region model, as well as a local interaction region MRF model for image segmentation. The adaptive LBP algorithm maximizes the global probability of the proposed MRF model, which employs two very important strategies, namely, “message self-convergence” and “adaptive label pruning”. Message self-convergence can improve the reliability of a pixel in choosing a label in local region, and label pruning can dismiss impossible labels for every pixel. Thus, the most reliable information messages transfer through the LBP algorithm. The experimental results show that the proposed algorithm not only obtains more accurate segmentation results but also greater speed.