修饰聚合物液-固亲和萃取体系纯化大豆中的组氨酸

聚乙二醇(PEG)6000经亚氨基二乙酸(IDA)修饰后和CuSO4反应,形成PEG修饰聚合物PEG-(IDA-Cu)2 ,与吐温80、磷酸盐混合,构成液-固亲和萃取体系,直接从大豆蛋白匀浆中提取氨基酸.选定萃取条件为磷酸盐摩尔比n(K2HPO4)∶n(NaH2PO4)为4.8∶1,体系pH值 7.70,总盐浓度为1.60 mol·L-1;吐温80的体积分数为10.5%.结果表明该体系对大豆蛋白匀浆中氨基酸的二次萃取率为66.5%,用离子交换技术后继处理,得纯度较高的组氨酸.     

Resonant-cavity-enhanced photodetectors and LEDs in the mid-infrared

In this paper we outline the use of resonant-cavity enhancement for increasing the exterior coupling efficiency of photodetectors and light-emitting diodes (LEDs) in the mid-infrared (MIR) spectral region. This method is potentially very important in the MIR because encapsulation is not presently feasible due to the lack of suitable materials. Among other potential applications, resonant-cavity-enhanced (RCE) photodetectors and LEDs could be particularly suitable for greenhouse gas detection because of their ‘pre-tunable’ spectrally narrowed resonantly enhanced peaks. We also present the optical characterization of an InAs RCE photodetector aimed at the detection of methane gas (λ≈3.3 μm), and an InAs/InAs_0.91Sb_0.09 resonant-cavity LED (RCLED) aimed at carbon dioxide gas (λ≈4.2 μm). The high peak responsivity of the RCE photodetector was 34.7 A/W at λ=3.14 μm, and the RCLED peaked at λ=3.96 μm. These are among the longest operating wavelengths for III–V RCE photodetectors and RCLEDs reported in the literature.     

Immobilized polysiloxanes as stationary phases for high-performance liquid chromatography and solid phase extraction

Polysiloxanes immobilized onto the surfaces of porous silica particles have proven to be good stationary phases for the separation of multiresidues of pesticides and their metabolic/degradation products by reversed-phase high-performance liquid chromatography (RP-HPLC). Similar materials have proven effective for pre-concentration and clean-up procedures using solid phase extraction. The present paper describes the preparation and some applications of several of these packing materials.     

Reagent concentration effects in the REM resin solid phase synthesis of tertiary amines

The use of reagent concentration has resulted in increased rates for all stages of the REM resin synthesis of tertiary amines. These increases in rate translate into faster reaction times, higher yields and lower reagent consumption. Of the methods examined, the most successful was the use of perfluorous solvents, either alone or with a small amount of organic co-solvent.     

Solid-phase oxidative halodecarboxylation of β-arylacrylic acids with the ceric ammonium nitrate—alkali halide system

The solid-phase oxidation of cinnamic, 4-methoxy- and 3,4-dimethoxycinnamic acids with Ce(NH₄)₂(NO₃)₆—MHal system leads to β-halostyrenes. Similar procedure in the absence of a metal halide results in a cleavage of the C=C bond giving the corresponding benzaldehydes. Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 1, pp. 114–118, January, 2008.     

Synthesis and simple separation of β-pyrrole sulfonated porphycenes

New water-soluble porphycenes having sulfonic acid groups at the β-pyrrolic positions were synthesized and characterized by UV-vis, NMR, IR, and mass spectroscopy as well as elemental analyses. The series of mono- to tri-sulfonato derivatives were simply separated by the extraction method.     

双（十二烷基亚磺酰）乙烷溶剂萃取钯及其机理的研究

本文研究用双（十二烷基亚磺酰）乙烷萃取钯的性能，在ＫＩ存在下从７ｍｏｌ／Ｌ盐酸介质中用含有ＢＤＳＥ的氯仿能定量萃取钯，有机的钯可被硫脲或氨溶液反萃继之用ＴＭＫ－ＴｒｉｔｏｎＸ－１００光度法测定，研究了萃取的最佳条件及干扰情况，斜率法测得萃合物组成为Ｐｄ：Ｉ：ＢＤＳＥ＝１：２：１，红外光谱证实萃合物中ＢＤＳＥ的二个亚砜以硫原子与钯配位，萃合物为异位体络合物，提出了选择性萃取分离钯的新方法。     

Automated derivatization for on-line solid-phase extraction-gas chromatography; phenolic compounds

An automated system for derivaatization was coupled on-line with solid-phase extraction-gas-chromatography (SPE-GC). The system was optimized for the determination of phenol and chlorinated phenols in aqueous samples. The test analytes were acetylated with acetic anhydride; proper buffering of the sample was a critical factor. Next, the phenol acetates were enriched on a SPE cartridge and transferred to a GC; two appraoaches were studied. In the first approach, the derivatives were enriched on disposable C18 cartridges (ASPEC type) and desorbed with methylacetate. Aan aliquot of the final eluate was injected on-line the GC by means of a loop-type interface. In the second approach, trace enrichment was performed on 10 × 2 mm i.d. LC-type precolumn packed with polystyrenedivinylbenzene copolymer (PLRP-S) this precolumn was dried with a mitrogen purge and the phenol acetates were desorbed with ethyl acetate which was injectedon-line into the retention gap of the GC under partially concurrent solvent evaporation (PCSE) conditions. The Derivatization-SPE-GC system which was based on the loop-type interface has the advantage of simplicity and easy operation, the main drawback is the impossibility to determine phenol acetates which elute prior to trichlorophenol acetates. With the derivatization-SPE-GC approach using PCSE-based desorption, even the most volatile analyte of the test series, phenol acetate, can be determined successfully. The entire procedure, including the derivatization step, was fully automated and integrated in one set-up. The precision data for the integrated on-line derivatization-SP-FID system were fully satisfactory, with RSD values of 1–12 % at the 1 μg/1 level. When a sample volume of 2.2 ml was analyzed, The detection limits for the chlorinated phenol acetates were in the 0.1–0.3 μg/1 range.     

Normalization and noise-reduction algorithm for fringe patterns

This paper presents a fringe pattern normalization and noise-reduction algorithm. Locally the background noise is suppressed, the modulation normalized and the noise smoothed. An expression to calculate the cosine-only term is formulated. It is related to the directional derivatives of the intensity fringes. Two-dimensional Fourier series are used to calculate the parameters needed for the algorithm. Experimental work is presented using diffraction and ESPI images. The programming is relatively simple and involves mainly local convolutions. The processing time using a 2 GHz computer to normalize an image of 256 × 256 pixels is approximately one second.