Negative Charging of Au Nanoparticles during Methanol Synthesis from CO2/H2 on a Au/ZnO Catalyst: Insights from Operando IR and Near‐Ambient‐Pressure XPS and XAS Measurements

The electronic and structural properties of Au/ZnO under industrial and idealized methanol synthesis conditions have been investigated. This was achieved by kinetic measurements in combination with time‐resolved operando infrared (DRIFTS) as well as in situ near‐ambient pressure X‐ray photoelectron spectroscopy (NAP‐XPS) and X‐ray absorption near‐edge spectroscopy (XANES) measurements at the O K‐edge together with high‐resolution electron microscopy. The adsorption of CO during the reaction revealed the presence of negatively charged Au nanoparticles/Au sites during the initial phase of the reaction. Near‐ambient‐pressure XPS and XANES demonstrate the build‐up of O vacancies during the reaction, which goes along with a substantial increase in the rate of methanol formation. The results are discussed in comparison with previous findings for Cu/ZnO and Au/ZnO catalysts.     

Selective Oxidation of Aldehyde over Hydroxymethyl Group Catalyzed by Gold Nanoparticles in Aqueous Phase

A protocol for selectively oxidizing aldehyde over hydroxymethyl group is developed, using biomass starch protected gold nanoparticles (NPs) as catalyst. The Au NPs show high selectivity that aldehyde is oxidized into carboxylic acid while alcoholic hydroxyl group stays intact in selective oxidation of 4-(hydroxymethyl)-benzaldehyde. The heterogeneous catalysis system is composed of soluble catalysts and insoluble substrate. The gold catalyst is prepared, preserved and applied for catalytic oxidation all in water. After reaction conditions are optimized, H\begin{document}$_2$\end{document}O\begin{document}$_2$\end{document} is found to be the best oxidizing agent with complete conversion. Besides, the gold catalyst displays good versitility for aldehyde derivatives. After reaction completes, organic components are extracted by organic solvent and gold NPs in water are separated and recycled.     

Photodegradation of CH3I on mesoporous TiO2-B nanofibers with Au nanoparticles

Au nanoparticles deposited on mesoporous TiO₂-B nanofibers have been prepared, characterized, and used to catalyze photoreactions of iodomethane. High-density gold-particle deposition on TiO₂-B is obtained by electrostatic and/or chemical force between the particles of TiO₂-B and Au capped with -SC(H)(CO₂H)(CH₂CO₂H) through pH control. The capping groups on the gold particles can be removed after 400 °C calcination. It is found that the nature of the inorganic acids used for pH adjustment has effects on particle morphology and deposition. Two other methods, i.e., preparation of TiO₂-B nanofibers in the presence of gold particles and preparation of gold nanoparticles in the presence of TiO₂-B particles (deposition-precipitation method), are also investigated. However, the former method produces a low-density deposition and the latter one induces a morphology change of the TiO₂-B and an increase of the Au in size. Fourier transform infrared spectroscopy has been employed to study and to compare the photoreactions of CH₃I on TiO₂-B and Au/TiO₂-B and the effect of O₂. The presence of gold particles on TiO₂-B increases the efficiency of CH₃I photodegradation, forming adsorbed methoxy and formate. The role of gold is also discussed.     

Zirconia-based planar NO2 sensor using ultrathin NiO or laminated NiO–Au sensing electrode

The nanostructured thin NiO films with the thicknesses of 30–180 nm were examined as a sensing electrode (SE) for the planar mixed-potential-type yttria-stabilized zirconia (YSZ)-based NO₂ sensor. The sensing characteristics were examined in the temperature range of 600–800 °C under the wet condition (5 vol.% water vapor). Among the NiO-SEs tested, the 60 nm-thick NiO-SE sintered at 1,000 °C was found to give the highest NO₂ sensitivity in the NO₂ concentration range of 50–400 ppm accompanying with fast response/recovery at the operating temperatures of 600–700 °C. The high NO₂ sensitivity was attributed to the high catalytic activity for both electrochemical reactions of O₂ and NO₂ at the interface of NiO-SE/YSZ. The ultrathin gold layer with the thickness of about 60 nm was additionally formed on the 60 nm-thick NiO-SE to fabricate the laminated-type (60 nm NiO/60 nm Au)-SE. It was demonstrated that the use of this laminated (NiO–Au)-SE improved both the sensitivity and the selectivity to NO₂.     

金纳米颗粒的有序制备及其光学特性

采用纳米球蚀刻技术在石英衬底上制备了不同高度的金纳米颗粒阵列.通过扫描电子显微镜对其表面形貌进行了观测,表明金纳米颗粒为有序分布的三棱柱结构.通过红外—紫外吸收光谱仪在190—900nm波长范围内对其光吸收特性进行了测量, 并成功观测到了金纳米颗粒表面等离子体振荡效应引起的光吸收峰,结果表明随着金纳米颗粒高度的增加,其吸收峰的位置向短波方向移动(蓝移).同时对金纳米颗粒的光吸收特性进行了基于离散偶极子近似的理论计算,并与实验结果进行了比较. 关键词： 纳米球蚀刻技术 金纳米颗粒 离散偶极子近似     

Au在Zr掺杂的CeO2(110)面吸附的第一性原理研究

采用基于广义梯度近似的投影缀加平面波(projector augmented wave)雁势和具有三维周期性边界条件的超晶胞模型,用第一性原理方法,计算并分析了Au在CeO₂(110)和Zr掺杂的CeO₂(110) 面的吸附能,吸附结构和电子结构等特征.从而得出Zr掺杂对Au/CeO₂(110)吸附体系的影响.结果表明：Zr的掺杂增大了Au在CeO₂(110) 面的吸附能,并改变了最强吸附位置,且导致了吸附体系中衬底结 关键词： Au Zr掺杂 2')" href="#">CeO₂ 吸附     

Adsorption of 2‐amino‐5‐cyanopyridine on a gold surface as probed by surface‐enhanced Raman spectroscopy

The adsorption of 2‐amino‐5‐cyanopyridine (2‐ACP) was investigated in solution at different pH values by i n situ surface‐enhanced Raman scattering (SERS) spectroscopy combined with the electrochemical method. The assignments of the main bands were first performed on the basis of the spectral features of similar compounds and with the help of density functional theory calculations. The results revealed that the adsorption and the interfacial structure of 2‐ACP on the Au electrode depended on the applied potential and the pH values of the solution. In the natural solution, 2‐ACP was adsorbed on the surface with a vertical orientation by the CN group from − 0.4 to − 1.0 V, whereas in the − 0.4 to 0.8 V range, the N atom of the pyridine ring was bound to the surface. A transition region for the reorientation of the two adsorption modes was observed from − 0.8 to − 0.4 V. A flat configuration was preferred at an extremely negative potential. A similar surface adsorption behavior was observed in the alkali environment, while the Stark effect slope decreased because of the adsorption of OH⁻. Due to the protonation of N atom in the acidic solution, the potential region for the coexistence of two configurations ranged from − 0.4 to 0.2 V. Additionally, a similar adsorption configuration was proposed on the Au colloids at various pH values. The results revealed that the adsorption behavior became more complex on colloidal surfaces than that on a rigid electrode surface. Copyright © 2010 John Wiley & Sons, Ltd.     

消光式核壳二聚体传感器的设计与光谱特性分析

根据ITO/Au纳米核壳二聚体粒子在生物医学领域的应用合理性,设计了一种实时检测生物液体的核壳二聚体探针消光式传感器;由偶极子理论推导出输出波长与外界环境折射率关系;利用MATLAB设计ITO/Au纳米核壳二聚体粒子结构;采用软件DDSCAT7.3结合离散偶极近似法,利用二聚体有效半径模拟计算了300~950nm可见光到红外光波段不同核壳比、二聚体间距、以及不同介质折射率的消光光谱;根据传感芯片折射率与偶极共振、耦合八级共振的响应关系得出ITO/Au二聚体的折射率灵敏特性。与传统Ag/Au核壳纳米粒子相比,ITO/Au纳米核壳二聚体结构引入了可作为传感芯片灵敏性自参考参数的耦合八级共振峰,同时ITO/Au二聚体结构的折射率灵敏度可达到419nm/RIU。这些工作及其结果对制作消光式传感器具有重要的意义。     

Solid-state luminescence of Au(I) complexes with external stimuli-responsive properties

In the last decade, the field of stimuli-responsive luminescent materials have been intensely emerged because of the high potential application to functional sensors or photoelectronic devices. In particular, luminescent molecular crystals constructed from Au(I) complexes have produced a wide range of examples of luminescent alterations when some external stimulations, such as heat, mechanical stress, vapor (or solvents), were applied to the solid samples. In this review, we describe the recent progress through a summary of the reported Au(I) complexes based on their utilized stimuli-responsive mechanisms, which are categorized in crystal phase transitions (“crystal-to-amorphous”, “crystal-to-crystal” and “single-crystal-to-single-crystal” transitions) and molecular rotation in crystalline media, respectively.