Synthesis and spectroscopic properties of highly water-soluble perylene derivatives

Most known perylene diimides are lipophilic, with few exceptions of hydrophilic derivatives. Even in the latter case, the compounds have limited water solubility and show a strong tendency to self-aggregation. In this paper we present the synthesis of four new perylene derivatives with three and four basic side chains, obtained by functionalizing the bay-area of perylene. These molecules show great solubility in aqueous media as hydrochlorides and their tendency to self-aggregate is remarkably reduced with respect to the previously synthesized two-chained perylene diimides. Their different spectroscopic properties in various solvents and conditions are reported and discussed.     

Comparison of pre-reducing agents for antimony determination by hydride generation atomic fluorescence spectrometry

A systematic study of antimony reduction prior to its determination by hydride generation atomic fluorescence spectrometry (HG-AFS) was carried out. The efficiency of l-cysteine, potassium iodide and potassium iodide/ascorbic acid was studied for this purpose. The hydride generation step was optimised in the presence of those pre-reductors. From the results, l-cysteine was found to be the most suitable pre-reducing agent. Methodology was validated, obtaining detection limits lower than 90 ng l⁻¹ and repeatability and reproducibility better than 3% R.S.D. and 5% R.S.D., respectively, in all cases. In order to evaluate the methodology developed and the influence of the matrix, recovery from waters from different sources was tested by HG-AFS and also by inductively coupled plasma mass spectrometry (ICP-MS). Accuracy was assessed by analysing three water reference materials at different antimony concentration levels. The high sensitivity of the developed methodology enables it to be applied for monitoring drinking waters according to the maximum admissible concentration of antimony established by the EU Directives.     

Trace elemental determination in alcohol automotive fuel by electrothermal atomic absorption spectrometry

Suitable analytical methodologies were developed allowing direct determination of As, Cu, Fe, Pb, Sb and Sn in alcohol fuel samples by electrothermal atomic absorption spectrometry. Different chemical modification approaches were tested and compared in terms of analytical performance and in practical terms. Experimental conditions were optimized allowing little sample dilution and use of calibration curves prepared with aqueous inorganic analyte standards. Methodologies were tested with analyte spiked alcohol samples. Good analyte recoveries from spiked alcohol samples, precision better than 10% and limits of detection in the sub μg l⁻¹ range were achieved.     

Thermal lens spectrometric determination of hexavalent chromium

The applicability of thermal lens spectrometry (TLS) for quantification and routine determination of hexavalent chromium was investigated by using a collinear dual beam thermal lens spectrometer. In aqueous solutions the LOD of 0.1 μg l⁻¹ was obtained for Cr(VI) by using 160 mW laser power. The performance of the technique was verified by the determination of hexavalent chromium in standard reference water samples (NIST SRM 1643a and NIST SRM 1643c) and comparing the results for Cr(VI) in CCA (Cr, Cu, As)-treated timber extracts to concentrations obtained by atomic absorption spectrometry (AAS). Good agreement between the TLS results and reported values for Cr(VI) in SRMs as well as AAS results for Cr(VI) in CCA-treated timbers confirmed that TLS is a reliable and accurate analytical technique applicable for the determination of Cr(VI) in aqueous solutions at concentration levels 0.5–100 μg l⁻¹.     

Comparison of the Hartree-Fock,Møller-Plesset,and Hartree-Fock-Slater method with respect to electrostatic properties of small molecules

Summary The results of various quantum chemical calculations, the Hartree-Fock (HF) method, the Møller-Plesset perturbation theory (MP2), and the Hartree-Fock-Slater (HFS) method are compared. Atomic charges, dipole moments, topological properties of the electron density distribution and polarizabilities, and first hyperpolarizabilities are calculated. Atomic charges obtained with the HFS method are found to be very close to those calculated with the MP2 method, from which we conclude that the HFS method describes to some extent electron correlation effects. Performing an MP2 calculation after an HF calculation improves the molecular dipole moments considerably, yielding values close to the experimental ones. HFS calculations are computationally less demanding than MP2 and yield comparable results for the electron density distributions, dipole moments and polarizabilities.     

取代基对卟吩结构和性质的影响

运用密度泛函理论(DFT) B3LYP/6-31G(d, p)方法, 对卟吩及其被取代基—CH=CH₂、—COCH₃、—CHOHCH₃、—CHNH₂CH₃或—CHSHCH₃所修饰后的分子构型进行了优化. 同时, 对其电子吸收光谱与核磁共振氢谱也进行了量化计算. 结果表明, 这些取代基有着各自不同的空间构象, 对卟吩环的整体结构没有很大的扰动. 然而, 它们重新调整了卟吩环中原子电荷的分布, 改变了前线分子轨道(LUMO-HOMO)能隙, 结果导致卟吩的吸收光谱与¹H NMR均发生了相应的改变.     

Photolytic oxidation of As species for determination of total As (including the ‘hidden’ As fraction) in coastal seawater by hydride generation-atomic fluorescence spectrometry

Ultraviolet irradiation (photolysis) in alkaline medium was applied for pretreatment of seawater samples so as to accurately determine total As by continuous-flow hydride generation-atomic fluorescence spectrometry. This sample pretreatment is meant to convert non-reducible As forms into inorganic As, which easily forms arsine. The optimised parameters were the treatment time and the pH of the medium. The behaviour of four hydride-reactive As species [As(III), As(V), MMA, DMA], and AsB, i.e. a typical non-hydride-reactive As species, when subjected to UV irradiation was studied. UV irradiation at pH 1 lead to conversion of all species into As(V) with the exception of AsB and DMA. Conversions of DMA and AsB into As(V) at pH 11 in less than 30 min were observed under UV irradiation. The limit of detection of As (measured as As(V)) by hydride generation-atomic fluorescence spectrometry was 0.1 μg/L and the repeatability of the oxidation procedure was about 10%. The method was applied to determination of total and directly reducible As at 11 sampling points of the Galician Coast (Atlantic Ocean, Spain). Total As concentrations were in the range 1.4-4.8 μg/L. A significant As fraction, between 20 and 44%, depending on the sampling point, corresponded to non-reducible As which was converted by UV irradiation into hydride-reactive As. This fraction should represent the sum of DMA, which yields a low sensitivity in the continuous flow-AFS system, and the hidden As fraction.     

Hydrogen peroxide in basic media for whole blood sample dissolution for determination of its lead content by electrothermal atomization atomic absorption spectrometry

Hydrogen peroxide in basic media is proposed as a means for dissolving whole blood samples to be analyzed by electrothermal atomization atomic absorption spectrometry, ET AAS. Approximately 2 g of the whole blood sample were directly weighed in a 150 mL volumetric flask; 3 mL of a NaOH 0.2 mol L⁻¹ solution, two drops of 1-octanol, as an antifoaming agent, and 1 mL of 30% volume hydrogen peroxide were added to the flask to promote oxidation. The solution was then manually shaken and after approximately three minutes of shaking, a clear solution, with no apparent suspended solids or greasy layers, was obtained. Distilled-deionized water was used to complete the volume. Ten μL of the resulting solution along with 10 μL of a solution containing 5000 mg L⁻¹ of NH₄H₂PO₄ and 300 mg L⁻¹ of Mg(NO₃)₂ as a modifier, were injected into transversely heated graphite tubes for lead determination. Both aqueous standards and standard addition calibration curves produced results not significantly different at a 95% confidence limit level. Accuracy of the measurements was assessed by analysis of the IAEA A-13 (concentration of trace and minor elements in freeze dried animal blood) standard reference material containing 0.18 mg L⁻¹ lead on a dry basis and by means of recovery tests. Analysis of the IAEA A-13 standard produced 0.17 ± 0.02 mg L⁻¹ lead on a dry basis; recovery tests afforded values from 95 to 105%. Ten consecutive measurements of a 5 ppb lead solution gave a characteristic mass of 47.2 pg and a (3S) detection limit of 1.77 μg L⁻¹ Pb. Results obtained from analysis of whole blood samples of volunteer donors covered a lead concentration range between 8 and 21 μg L⁻¹ with a mean value of 11.9 ± 4.7 μg L⁻¹.     

Effect of monomer concentration on characteristics of methacrylic acid-grafted polyethylene film prepared by photografting

The effect of monomer concentration on photografting of methacrylic acid (MAA) onto linear low-density polyethylene (PE) film (thickness=30 μm) was investigated at 60 °C in water solvent together with the location of MAA-grafted chains. Xanthone was used as a photoinitiator which was coated on the film sample earlier. The higher percentage of grafting and graft efficiency were afforded for the system with the higher monomer concentration. The resultant MAA-grafted films were subjected to measurements of pH-responsive character and ability to adsorb cupric ion in order to understand the characteristics of function introduced. The grafted samples exhibited the pH-responsive character, where they shrank and swelled in acidic and alkaline media, respectively. The pH-responsive character of the grafted films was higher for the samples prepared in the system with a higher monomer concentration. Moreover, the grafted samples exhibited the ability to adsorb cupric ion, and the ability was reduced when the sample was prepared in the system with a higher monomer concentration. The different extents of the pH-responsive character and ability to adsorb cupric ion of the resulting grafted PE films were discussed in terms of location of grafted chains in the film substrate, which was determined by a scanning electron microscope and an attenuated total reflection infrared spectroscopy.     

非线型缩聚物的重均分子量

本文用数学期望方法研究了非线型共缩聚物的重均分子量,并推导出重均分子量表达式,将3种特例的理论曲线与实验结果相比较,两者基本相符。