四磺酸基酞菁锌在水和非水溶剂中的电化学性质研究

在非水溶剂（二甲基亚砜（ＤＭＳＯ）及Ｎ,Ｎ＿二甲基甲酰胺（ＤＭＦ））中的伏安曲线．呈现三对电流峰,表明存在三个可逆或准可逆酞菁配体的单电子转移过程,而在水溶液中则不呈现准可逆行为,且波形改变很大．此外,还比较了四磺酸基酞菁锌的水溶液在自然光和红光（６００～７００ｎｍ）照射下的循环伏安曲线,其氧化还原峰的数目和峰电位基本不变,但在红光照射下比自然光照射下的峰电流明显增大．     

Synthesis and characterization of Cu,Ni and Zn binding capability of some amino- and imidazole hydroxamic acids: Effects of substitution of side chain amino-N for imidazole-N or hydroxamic-N-H for -N-CH3 on metal complexation

Solution equilibrium studies on Cu(II)-, Ni(II)- and Zn(II)-N-Me-β-Alaninehydroxamic acid (N-Me-β-Alaha), -N-Me-α-alaninehydroxamic acid (N-Me-α-Alaha), -Imidazole-4-carbohydroxamic acid (Im-4-Cha), -N-Me-imidazole-4-carbohydroxamic acid (N-Me-Im-4-Cha) and -Imidazole-4-acetohydroxamic acid (Im-4-Aha) systems have been performed by pH-potentiometry, UV–Vis spectrophotometry, EPR, CD, ESI-MS and ¹H NMR methods. According to the results: (i) the amino-N atoms are more basic in N-Me-α-Alaha and N-Me-β-Alaha than the hydroxamate function, but the trend is just the opposite between the imidazole-N(3) and hydroxamate. (ii) The metal ion anchor is always the hydroxamate part in the amino acid derivatives, while it is always the imidazole-N(3) in the studied imidazolehydroxamic acids. (iii) The three studied N-Me derivatives do not form metallacrowns. Only hydroxamate type chelate is formed with N-Me-β-Alaha, but with N-Me-α-Alaha a new type of coordination mode (via amino-N and hydroxamate-O) also exists. N-Me-Im-4-Cha also forms a dinuclear complex, [M₂L₃], with Cu(II) and Ni(II) (but not with Zn(II)). In this complex, one of the three ligands might bridge the two metal ions (five-membered hydroxamate-(O,O) plus five-membered (N_im, O_carb) bridging bis-chelating mode), while each of the additional two ligands binds to one metal. (iv) The two studied N–H derivatives, having dissociable proton on the hydroxamic-N, are able to form metallacrown species. A pentanuclear complex, [M₅L₄H₋₄], is exclusively formed above pH 4 between Cu(II) and Im-4-Aha. Interestingly, this 12-metallacrown-4 type complex, although together with various mononuclear binding isomers, appears also with Ni(II) and Zn(II). Unfortunately, the complexes of Im-4-Cha are not soluble in water at physiological pH at all.     

共沉淀浸渍法制备由合成气直接合成二甲醚的Cu-Mn催化剂

采用共沉淀浸渍法,制备了直接合成二甲醚的Cu-Mn-Zn催化剂,通过对组成成分及其配比的研究,发现Cu含量一定的条件下,n(Zn)/n(Mn)摩尔比对催化剂性能有较大的影响,当n(Zn)/n(Mn)=1/3～1/2时,催化剂对CO的转化率和对二甲醚的选择性达到最佳,分别为53.6%和63.5%；如锰添加比例过大,对催化剂催化合成二甲醚有微弱抑制；添加锌比例过大,会大大降低CO的转化率。载体Y分子筛的含量对催化剂性能也有影响,用量过大将降低催化剂的活性和对二甲醚的选择性,当其含量为33%时,催化剂上CO转化率和选择性可分别达到66%和68%,且催化剂活性随分子筛含量减少不再有明显的变化。     

Electroreduction of α-glucose on CNT/graphite electrode modified by Zn and Zn–Fe alloy

Electroreduction of -glucose to form sorbitol on Zn/CNTs and Zn alloy/CNTs electrodes has been investigated in this paper. Carbon nanotubes (CNTs) used in this paper are grown directly on graphite disks by chemical vapor deposition. Zn and Zn alloy are electrodeposited on the activated CNTs/graphite electrode by pulse galvanostatic method. The micrographs of Zn/CNTs and Zn alloy/CNTs electrodes are characterized by scanning electron microscopy. The results show that the current efficiency of -glucose reduction on CNTs electrodes is much better than that on flat Zn electrodes. The order of the current efficiency on different electrodes is as follows: Zn/CNT (0.58) Zn–Fe/CNT (0.57)>Zn–Ni/CNT (0.43) Zn/graphite (0.42)>Zn (0.40). It indicates that CNTs have good potential application in electrosynthesis. Additionally, effects of some operating parameters, such as pH, temperature and -glucose concentration, on the current efficiency of -glucose reduction are also discussed.     

ICP-AES法测定锌阳极中的铝、镉、铁、铜、铅

通过分析高频功率、雾化压力、辅助气流量和泵速等试验条件，建立了ICP-AES法测定锌阳极中铝、镉、铁、铜、铅的方法。用该方法测定锌阳极中的铝、镉、铁、铜、铅，其RSD分别为0.17%、0.63%、2.7%、5.2%、2.5%，回收率分别为99.3%-101.2%，99.3%-100.3%、97.1%-102.2%、97.8%-102.9%。对锌阳极试样进行测定，该方法的测定结果与GB4951-85方法的测定结果基本一致。     

Structure and Magnetic Properties of Nickel–Zinc Ferrite Nanoparticles Prepared by Glass Crystallization Method

Summary. The magnetic and microstructure properties of Fe₂O₃–0.4NiO–0.6ZnO–B₂O₃ glass system, which was subjected to heat treatment in order to induce a magnetic crystalline phase (Ni_0.4Zn_0.6-Fe₂O₄ crystals) within the glass matrix, were investigated. DSC measurement was performed to reveal the crystallization temperature of the prepared glass sample. The obtained samples, produced by heat treatment at 765°C for various times (1, 1.5, 2, and 3 h), were characterized by X-ray diffraction, IR spectra, transmission electron microscopy, and vibrating sample magnetometer. The results indicated the formation of spinel Ni–Zn ferrite in the glass matrix. Particles of the ferrite with sizes ranging from 28 to 120 nm depending on the sintering time were observed. The coercivity values for different heat-treatment samples were found to be in the range from 15.2 to 100 Oe. The combination of zinc content and sintering times leads to samples with saturation magnetization ranging from 12.25 to 17.82 emu/g.     

Pulse plating effect on microstructure and corrosion properties of Zn–Ni alloy coatings

The influence of pulse plating parameters on the surface morphology, grain size, lattice imperfection and corrosion properties of Zn–Ni alloy has been studied. The coatings were electrodeposited in an alkaline cyanide-free solution. AFM was applied for surface morphology examination, XRD measurements were carried out for phase composition and texture analysis, electron probe microanalysis was used for alloy chemical composition studies, while electrochemical techniques were applied for corrosion performance evaluation. The pulse plated Zn–Ni coatings appeared to consist of the γ-Zn₂₁Ni₅ phase and the composition of the alloy depended on the plating parameters. The grain size, lattice imperfection and homogeneity of grain distribution were established to be the main factors determining corrosion behaviour of the coating. Presented at the 4th Baltic Conference on Electrochemistry, Greifswald, March 13–16, 2005     

Acceleration of the Passerini reaction in the presence of nucleophilic additives

An accelerating effect of nucleophilic additives was revealed for the Passerini multi-component reaction. The influence of aqueous solutions on the reaction rate was studied in detail and the direct involvement of water in the bond-making step was attributed as the basis of an accelerating effect. Other nucleophiles were tested as alternatives to water; as a result N-hydroxysuccinimide is proposed as an accelerant of the Passerini reaction.     

Hygrometric Determination of Water Activities and Osmotic and Activity Coefficients of NH4Cl–LiCl–H2O at 25°C

The mixed aqueous electrolyte system of ammonium and lithium chlorides has been studied by the hygrometric method at 25°C. The relative humidities of this system are measured at total molalities from 0.3 to 6 mol-kg^{– 1} for different ionic-strength fractions y of NH₄Cl with y = 0.33, 0.50, and 0.67. The data obtained allow the deduction of new water activities and osmotic coefficients. The experimental results are compared with the predictions of the ECA (extended composed additivity) law proposed in our previous work. The Zdanovskii–Stokes–Robinson (ZSR), the Robinson–Stokes (RS), Reilly–Wood–Robinson (RWR), the Pitzer, and the Lietzke–Stoughton (LS II) models are also compared with our results. Predictions made using these models are, in general, consistent with our results. From these measurements, new Pitzer mixing ionic parameters are determined and used to predict the solute activity coefficients in the mixture for different ionic-strength fractions.     

Spectroscopic investigation of Rose Bengal/cyclodextrin interactions in aqueous solution: the case of the hydroxypropyl-cyclodextrins

The interaction of Rose Bengal (RB) with hydroxypropyl-α-cyclodextrin (HP-α-CD), hydroxypropyl-β-cyclodextrin (HP-β-CD) and hydroxypropyl-γ-cyclodextrin (HP-γ-CD) has been studied in water and in acetate buffer at pH 4.5 by UV–Vis absorption, fluorescence spectroscopy and Induced Circular Dichroism at 298 K. Evidence of the complex formation between the RB and all HP-CDs have been obtained both in water and in buffer. Binding constants and stoichiometry of RB/HP-CD complexes in water have been determined by applying the modified Benesi-Hildebrand equation to the fluorescence measurements.