用两端对称缺陷复合光子晶体实现多通道滤波和光开关

用传输矩阵法计算了两端对称缺陷复合光子晶体结构的光传输特性。计算结果表明:两端对称缺陷复合光子晶体[D(AB)mD]2结构中的禁带出现两个完全共振透射峰。通过控制入射光强来微调光子晶体材料的介电常数,使得完全共振透射峰移动,且介电常数变化越大,共振透射峰偏移越大,从而形成高效率的双通道光开关。当光子晶体为[D(AB)mD]N结构时,每个完全共振透射峰都分裂为N-1条,这样可通过调节N同时实现所需要通道数目的高效多通道光开关和多通道滤波器。     

Groove-type channel enhancement-mode Al GaN/GaN MIS HEMT with combined polar and nonpolar AlGaN/GaN heterostructures

A novel groove-type channel enhancement-mode AlGaN/GaN MIS high electron mobility transistor(GTCE-HEMT)with a combined polar and nonpolar AlGaN/GaN heterostucture is presented. The device simulation shows a threshold voltage of 1.24 V, peak transconductance of 182 m S/mm, and subthreshold slope of 85 m V/dec, which are obtained by adjusting the device parameters. Interestingly, it is possible to control the threshold voltage accurately without precisely controlling the etching depth in fabrication by adopting this structure. Besides, the breakdown voltage(VB) is significantly increased by 78% in comparison with the value of the conventional MIS-HEMT. Moreover, the fabrication process of the novel device is entirely compatible with that of the conventional depletion-mode(D-mode) polar AlGaN/GaN HEMT. It presents a promising way to realize the switch application and the E/D-mode logic circuits.     

Parameter allocation of parallel array bistable stochastic resonance and its application in communication systems

In this paper, we propose a parameter allocation scheme in a parallel array bistable stochastic resonance-based communication system(P-BSR-CS) to improve the performance of weak binary pulse amplitude modulated(BPAM) signal transmissions. The optimal parameter allocation policy of the P-BSR-CS is provided to minimize the bit error rate(BER)and maximize the channel capacity(CC) under the adiabatic approximation condition. On this basis, we further derive the best parameter selection theorem in realistic communication scenarios via variable transformation. Specifically, the P-BSR structure design not only brings the robustness of parameter selection optimization, where the optimal parameter pair is not fixed but variable in quite a wide range, but also produces outstanding system performance. Theoretical analysis and simulation results indicate that in the P-BSR-CS the proposed parameter allocation scheme yields considerable performance improvement, particularly in very low signal-to-noise ratio(SNR) environments.     

Properties on the distant distribution of entanglement for arbitrary two-qubit pure states via noisy quantum channels

This paper investigates the change of entanglement for transmitting an arbitrarily entangled two-qubit pure state via one of three typical kinds of noisy quantum channels: amplitude damping quantum channel, phase damping quantum channel and depolarizing quantum channel. It finds, in all these three cases, that the output distant entanglement (measured by concurrence) reduces proportionately with respect to its initial amount, and the decaying ratio is determined only by the noisy characteristics of quantum channels and independent of the form of initial input state.     

侧链型聚合物DANS-PMMA脊形条波导的制备

有机聚合物的紫外漂白,经过一系列复杂的光化学反应,会使聚合物薄膜的折射率和厚度降低。在此基础上,利用金属掩模对聚合物薄膜进行选择性紫外漂白,制备出了聚合物脊形条波导。紫外漂白不需要对聚合物薄膜进行光刻和腐蚀便可获得边缘和表面比较整齐和光滑的脊形条波导,对减少波导的散射损耗十分有利。本文介绍了利用紫外漂白和金属掩模方法制备侧链型聚合物DANS（4－dimethylamino-4’nitro-stlibene)-PMMA(polymethyl methacrylate)脊形条波导的工艺过程,并对关键工艺进行了讨论。     

低密度等离子体融断开关的粒子模拟研究

 采用2.5维柱坐标粒子模拟程序研究了低密度等离子体融断开关（PEOS）工作过程中的物理现象,介绍了计算模型的建立和复杂边界的算法处理。模拟结果表明,在PEOS导通电流的过程中,电流通道最初在等离子体的发生器端形成,并且随着导通时间的增大而向负载端漂移。离子的空间分布并没有明显的变化,当PEOS发生断路时,等离子体离子的密度会迅速降低,并最终导致PEOS阴极附近的等离子体的密度已接近为零,此时,阴极电子完全受磁场箍缩作用而不能到达阳极,PEOS完全断开。     

基于腔QED的多用户间的多原子量子信道的建立

提出基于腔QED技术的多用户间的多原子W态和GHZ态量子信道的建立方案.在量子网络的空闲时段,各个用户和量子交换机共享EPR对.量子交换机通过原子和腔场的相互作用将两个EPR对制备成W态,再与另一个EPR对进行纠缠交换,经过直接测量后为用户建立三原子W态量子信道;同时讨论了四用户间的W态量子信道的建立方案.量子交换机对三个EPR对进行纠缠交换,将三个原子同时与腔场作用,经过直接测量后为用户建立三原子GHZ态量子信道;并将此方法推广到N个用户间的GHZ态量子信道的建立. 关键词： 腔QED 量子信道 量子交换机 纠缠交换     

环形磁场金属等离子体源冷却流场的数值模拟与优化

环形磁场金属等离子体源作为一种全新的等离子体源结构,可用于产生高度离化、无大颗粒、高密度的离子束流,但传统流道结构不能保证其高效、均匀散热,大功率工作时可能引起密封胶圈的烧蚀失效,需对其冷却流场进行优化设计.利用Solidworks Flow Simulation软件对等离子体源冷却流道进行模拟,分析出入水孔分布角度、...     

改进的信道稀疏度检测正交多载波多普勒估计方法

针对正交频分复用水声移动通信中频域变采样技术联合信道稀疏度检测的多普勒估计算法在冰水混合区复杂信道环境下多普勒估计效果欠佳且计算量大的问题,提出了一种改进的多普勒估计算法。采用时域重采样技术对信号进行不同压缩因子的补偿,避免了频域变采样技术中的高阶快速傅里叶变换运算,从而降低了算法复杂度。利用梳状导频位置向量结合时域变采样技术更准确提取的导频子载波,进而获得更加精确的信道估计和信道稀疏度检测结果,提高了多普勒估计精度。仿真结果和冰下试验结果表明,与原始算法相比,改进的方法在冰水混合水域复杂多径时变信道环境下可以有效实现对信号多普勒畸变的跟踪并且计算量显著下降,能够保障正交频分复用水声移动实时通信。     

Controlled quantum teleportation of an unknown single-qutrit state in noisy channels with memory

This paper proposes a three-dimensional(3 D) controlled quantum teleportation scheme for an unknown single-qutrit state. The scheme is first introduced in an ideal environment, and its detailed implementation is described via the transformation of the quantum system. Four types of 3 D-Pauli-like noise corresponding to Weyl operators are created by Kraus operators: trit-flip, t-phase-flip, trit-phase-flip, and t-depolarizing. Then, this scheme is analyzed in terms of four types of noisy channel with memory. For each type of noise, the average fidelity is calculated as a function of memory and noise parameters, which is afterwards compared with classical fidelity. The results demonstrate that for trit-flip and t-depolarizing noises, memory will increase the average fidelity regardless of the noise parameter. However, for t-phase-flip and trit-phaseflip noises, memory may become ineffective in increasing the average fidelity above a certain noise threshold.