Influence of target surface degradation on the properties of r.f. magnetron‐sputtered calcium phosphate coatings

This paper reports a detailed study of how repeated r.f. magnetron sputtering from a hydroxyapatite (HA) powder target affects the nature and reproducibility of a sequential series of thin‐film coatings deposited onto Ti6Al4V substrates. An evaluation of the effective lifespan of the HA sputter targets and the reproducibility of the calcium phosphate (CaP) coatings produced from them has been made from Fourier transform infrared spectroscopy, XPS and, as appropriate, atomic force microscopy and SEM/energy dispersive x‐ray analyses. The annulus region of the target surface, from which sputtering under r.f. magnetron conditions normally occurs, showed severe surface degradation after only one deposition run, as indicated by significant PO₄^3? and OH^? depletion. This deterioration continued after each subsequent deposition cycle but to a much lesser extent than that observed in the initial sputtering period. The layers produced from all of the sputter runs contained the expected Ca²⁺ and PO₄^3? species characteristic of a CaP system but were OH^? deficient in the as‐deposited state. However, the chemical and morphological properties of the coatings did not change significantly until after the third consecutive sputter cycle. Hence, these data indicate that, even though a significant level of degradation of the HA target occurs at the outset of the sputtering procedure, the general plasma conditions employed here have a dominant influence on the coating properties until a critical degradation condition is met. As such, the compacted HA powder targets of interest can have a life‐cycle greater than single usage without detriment to the chemistry and morphology of the coatings produced from them. Copyright © 2003 John Wiley & Sons, Ltd.     

微乳液法合成LiFePO4 / C正极材料及其电化学性能

本文采用微乳液方法合成了纳米LiFePO₄ / C正极材料。制备样品分别用XRD和SEM进行表征，充放电测试其电化学性能。600 ℃制备样品为单一物相，平均粒径90 nm，在室温2.0～4.0 V (vs Li) 放电电压范围和15 mA·g^-1放电速率下，首次放电容量达到159 mAh·g^-1。制备样品同样展现良好的循环性能。在15 mA·g^-1速率下40次循环后，制备样品放电容量仍保持首次放电容量的98.9%。优异的电化学性能得益于样品颗粒的纳米尺寸、均匀分布以及表面碳层包覆提高了活性材料的电子电导率。     

桑蚕丝素蛋白初始结构对其矿化作用的影响

以碱金属离子诱导桑蚕丝素蛋白溶液发生构象转变, 研究了蛋白质初始结构对其矿化作用的影响. FT-IR, XRD和SEM等测试结果显示, 未经任何处理的桑蚕丝素蛋白溶液矿化后形成片状复合物, 其无机相以二水磷酸氢钙(DCPD)为主; 而经过K^＋和Na^＋金属离子处理后, 桑蚕丝素溶液的结构由无规线团/螺旋构象向β-折叠发生转变, 矿化后成纤维状, 并相互结合呈现纳米级的三维多孔结构, 其无机相以热力学稳定的羟基磷灰石(HA)为主. 可以认为, 丝素蛋白结构转化为较伸展的β-折叠后, 使得更多的亲水基团暴露在外面, 在丝素蛋白分子不断凝聚成纤过程中, HA结晶快速生长并附着在这些微纤上, 最终形成纤维状的丝素蛋白/HA复合物. 该结果为阐明蛋白质的生物矿化过程及其调控机理提供了理论依据, 同时可以从矿化复合物的形成来反映这些微量元素可能对骨组织形成的影响, 为临床骨组织的修复提供一定的参考.     

Intercalation of 1,2-Alkanediols into α-Zirconium Hydrogenphosphate

Intercalation compounds of α-Zr(HPO₄)₂ · H₂O with 1,2-alkanediols (from C3 to C16) have been prepared by replacing 1-propanol in α-Zr(HPO₄)₂ · 2C₃H₇OH with the desired 1,2-alkanediols by a treatment in a microwave field. It was found that the intercalates contain 1.5 molecules of diol per formula unit. The diol molecules are placed between the host layers in a bimolecular way with their aliphatic chains tilted at an angle of 51°. The diol molecules are anchored in the interlayer space by H-bonds. A mixed intercalate, containing 1,2-butanediol and 1,2-decanediol in a roughly equimolar ratio, is formed when the α-Zr(HPO₄)₂ · 2C₃H₇OH intercalate, suspended in a mixture of 1,2-butanediol and 1,2-decanediol, is exposed to microwave radiation. No new phase containing both types of the guest molecules was observed when the 1-propanol intercalate, suspended in a mixture of 1-propanol and 1,2-octanediol, is exposed to microwave radiation.     

Equations for calculation of the pH of buffer solutions containing sodium or potassium dihydrogen phosphate, sodium hydrogen phosphate, and sodium chloride at 25°C

Published thermodynamic data measured in aqueous mixtures of sodium or potassium dihydrogen phosphate with hydrogen phosphate and chloride at 25°C were used to test recently developed methods for calculation of the pH of phosphate buffer solutions. Equations for ionic activity coefficients are used in these methods. It is shown that all data used in the tests up to an ionic strength of about 0.5 mol-kg^-1 can be accurately predicted by the two methods recommended. In one of these methods, equations of the Hückel type are used for ionic activity coefficients and in the other equations of the Pitzer type. Several sets of phosphate buffer solutions are recommended,e.g., for calibrations of glass electrode cells. In the recommended sets, the pH of the buffer solutions can be calculated either by the Hückel or Pitzer method, and the pH predictions of these methods agree in most cases within 0.005 at least up to ionic strengths of about 0.2 mol-kg^-1. The pH values of the two primary pH standards endorsed by IUPAC based on aqueous mixtures of KH₂PO₄ and Na₂HPO₄,i.e., pH values of 6.865 and 7.413, can also be accurately predicted by the equations recommended in this study.     

Acoustic absorption in aqueous potassium phosphate

Measurements of acoustic absorption and velocity as a function of frequency and concentration in KH₂PO₄–K₂HPO₄ buffers at 4°C and pH 5-7 are reported. The dependence of the observed acoustic relaxation parameters on concentration is consistent with that to be expected from perturbation of a monomer-dimer equilibrium with an equilibrium constant [for 2H₂PO ₄ ^– (H₂PO₄)₂ ^2–] of 0.21 M^–1, a bimolecular rate constant of 5×10⁸ M^–1-sec^–1 and a standard volume change of –5 cm³ mole. The equilibrium constant for H₂PO ₄ ^– + HPO₄ ^2–H₃(PO₄)₂ ^3– is estimated to be 0.7 M^–1.     

Nitrate ion association with Nd3+

The overall stability constantsK ₁ andK ₂ of NdNO ₃ ²⁺ and Nd(NO₃) ₂ ⁺ complexes were determined (K ₁=1.77;K ₂=1.28) using an extraction method with tri-n-butyl phosphate as the extractant. The ratio ₁/₂ of the stepwise stability constants is discussed. It was established that the Nd(NO₃) ₂ ⁺ complex was an outer-sphere ion pair.

---

Die Assoziation von Nitrat-Ion mit Nd³⁺

Zusammenfassung Mittels einer Extraktionsmethode wurden die StabilitätskonstantenK ₁ undK ₂ von NdNO ₃ ²⁺ - und Nd(NO₃)⁺-Komplexen bestimmt (K ₁=1.77;K ₂=1.28; Tri-n-butylphosphat als Extraktionsmittel). Das Verhältnis ₁/₂ der stufenweisen Stabilitätskonstanten wird diskutiert. Es stellte sich heraus, daß der Nd(NO₃)⁺-Komplex als ein Outer-Shere-Ionenpaar vorliegt.

     

Neue acetonylsubstituierte Azole II. 3-Acetonyl-1,2,4-oxadiazole, 2-Acetonyl-1,3,4-oxadiazole und 5-Acetonyl-1,2,4-thiadiazole

3-Acetonyl-1,2,4-oxadiazoles and 2-acetonyl-1,3,4-oxadiazoles are accessible starting with the ketal of acetoacetamide oxime and the ketal of acetoacetic acid hydrazide, respectively. 5-Acetonyl-1,2,4-thiadiazoles are obtained from 5-chloro-1,2,4-thiadiazoles andtert.-butyl acetoacetate. These Acetonyl-azoles are starting materials for three series of azolylvinyl phosphates and phosphonates.

Herrn Prof. Dr.Klaus Weissermel zu seinem 60. Geburtstag.     

高效液相色谱检测Zn（Ⅱ）、Cd（Ⅱ）、Co（Ⅱ）、Pb（Ⅱ）、Ni（Ⅱ）、Cu（Ⅱ）、Hg（Ⅱ）

用双-(2-羟乙基)二硫代甲酸铵(HEDC)在反相液相色谱中作检测某些金属离子的衍生化试剂，HEDC的金属螯合物微溶于水，可直接水样注射于C18柱中进行检测，范围为0．006～10mg／L相对偏差1％～2％，检测波长254nm，金属汞的整合物在HPLC分析前进行浓缩富集检测限可低至0．06～25μg／L，相对偏差小于2％。     

Kristallstrukturanalyse von Ammonium-catena-polyphosphat II mit Röntgenpulvertechniken

Crystal Structure Determination of Ammonium catena-Polyphosphate II by X-Ray Powder Techniques The first structure determination of one of the five modifications of ammonium-catena-polyphosphate was performed using X-ray powder diffraction data. (NH₄PO₃)_nII is formed by phase transformation of (NH₄PO₃)_nI which on its part is obtained by condensation of NH₄H₂PO₄ at 200°C in presence of urea. Modification II crystallizes in P2₁2₁2₁ (a = 1 207.9(1), b = 648.87(8), c = 426.20(4) pm; Z = 4; 291 observed reflections; R(p) = 0.089; R(wp) = 0.111; R(I, hkl) = 0.088). The chain-anion runs parallel to the shortest axis, the period of identity is two. The ammonium ion is surrounded by a distorted tetrahedron of oxygen atoms (N? O-distances range from 285 to 292 pm, hydrogen bonds of middle strength).