Anomalous heat evolution of deuteron implanted al upon electron bombardment III - try to observe the nuclear d-d reaction

In previous papers, one of the authors (K. K.) has observed the anomalous melting of the surface layer of deuteron implanted Al, containing so-called "tunnel structures", on the electron bombardment in transmission electron microscope. In the present paper, we intended to observe the evidence of the d-d nuclear reaction, expecting neutron emission, associated with the melting phenomenon. However, the result was rather unexpected. The melting phenomenon was certainly observed under the same experimental conditions as before. But, in spite of the melting, neutron emission associated with the nuclear reaction was not observed. And, more unexpectedly, X-ray emission of energy less than roughly 400 v keV was observed when specimens with a bubble structure, which never showed melting, were bombarded with electron beams. Several conceivable mechanisms are discussed which, however, are all not convincing to explain the melting. The melting is attributed to some excess energy generation. The error estimation of the radiation measurements was undertaken.     

聚乙烯基咔唑与8-羟基喹啉铝混合体系的荧光衰减

报道了8－羟基喹啉铝和聚乙烯基咔唑薄膜及其混合体系膜的荧光衰减特性。聚乙烯基咔唑／8－羟基喹啉铝重量比100：4的混合膜在波长540nm和460nm处的荧光衰减时间分别为6．47ns和8．5ns。重量比100：10混合膜在波长540nm和460nm处的荧光衰减时间分别为5．5ns和7．9ns。上述两波长对应8－羟基喹啉铝和聚乙烯基咔唑分子荧光发射。混合体系的荧光寿命仅为8－羟基喹啉铝分子荧光的40％，同时也低于聚乙烯基咔唑14ns的荧光寿命。荧光寿命的减少反映出两种分子之间存在较强的相互作用或形成了分子复合体。     

非临界相位匹配RTP晶体1.6 μm光参量振荡器

采用非临界相位匹配切割,尺寸4 mm4 mm20 mm的磷酸钛氧铷（RTP）晶体作为非线性光学晶体,进行了半导体激光端面抽运Nd:YAG/RTP的内腔式光参量振荡获得人眼安全激光的实验研究。对比了不同声光调Q重复频率下的信号光输出特性。在10.5 W的抽运功率和15 kHz的重复频率下,获得了最高900 mW的1.62 m人眼安全激光输出,光光转换效率达8.6%。1.62 m信号光和对应的1.06 m基频光的脉冲宽度分别为4.6和8.2 ns。信号光中心波长在1618 nm,谱线宽度小于0.5 nm。     

大尺寸磷酸二氢钾晶体的折射率均一性研究

采用德国Trioptics公司生产的新一代全自动高精度折射率测量仪,测量了磷酸二氢钾(KDP)晶体不同部位的样品位于近紫外到近红外波段(0.253—1.530μm)内12个不同波长处的折射率,测量精度达到10-6量级.结果表明,大尺寸KDP晶体不同部位样品的折射率存在不均一性,靠近晶体恢复区的样品折射率小于晶体锥头区的样品折射率,偏差在10-5—10-4量级.研究发现,这种折射率不均一性与晶体不同部位的结晶质量存在差异有关.另外,将测量数据与其他文献中的数据进行对比.结果显示,所测试的样品数、波段宽度、测量点数量以及数据的精度均超过其他文献,结合测试条件分析了不同文献数据存在差异的原因.最后,使用最小二乘法拟合得到了KDP晶体较为可靠的Sellmeier方程.     

掺钕磷酸盐激光玻璃的光谱特性

掺钕激光玻璃广泛应用于核聚变、高功率激光放大器和光纤激光器等领域。磷酸盐玻璃热膨胀系数高、热稳定性和化学稳定性差、热机械强度低。通过改变玻璃组分,即添加Al2O3和F2,并改进制备工艺来降低热膨胀系数,除去铂和分子水。测量了磷酸盐玻璃中Nd3+离子的荧光光谱、吸收光谱及玻璃的热膨胀系数。根据吸收光谱计算掺钕磷酸盐激光玻璃的光谱参数。通过对掺钕磷酸盐玻璃的热膨胀系数的实际测量和计算,分析了玻璃的热稳定性。结果表明,在基质玻璃中引入Al2O3使激光玻璃的热膨胀系数可降低到α=38.75×10-7/℃,引入F2既达到了除水的目的又降低了玻璃的声子能量,提高了荧光发射的量子效率,并优化了光谱性能,拓展了掺钕磷酸盐激光玻璃的应用范围。     

纳米氧化铝微柱富集-ICP-AES测定绒柄牛肝菌中的痕量稀土元素

以负载了1-苯基-3-甲基-4-苯甲酰基-吡唑酮[5](PMBP)的纳米氧化铝为微柱吸附材料,采用电感耦合等离子体-原子发射光谱法(ICP-AES)研究了动态条件下对稀土离子Sc3+、Y3+和La3+的吸附性能,确定了最佳吸附及解脱条件。在pH为4.5时,分析物均可被上述吸附材料定量吸附;用0.5mol.L-1盐酸溶液可将吸附在微柱上的稀土离子完全解脱。本法对Sc3+、Y3+和La3+的检出限分别为0.15、0.18和0.34μg.L-1;相对标准偏差(RSD)分别为2.5%、3.0%和1.7%(n=12,C=0.5mg·mL-1)。方法应用于绒柄牛肝菌(Boletus tomentipes)中痕量Sc、Y和La的测定,结果满意。     

Effects of acid and alkaline based surface preparations on spray deposited cerium based conversion coatings on Al 2024-T3

Cerium based conversion coatings were spray deposited on Al 2024-T3 and characterized to determine the effect of surface preparation on the deposition rate and surface morphology. It was found that activation of the panel using a 1-wt.% sulfuric acid solution increased the coating deposition rate compared to alkaline cleaning alone. Analysis of the surface morphology of the coatings showed that the coatings deposited on the acid treated panels exhibited fewer visible cracks compared to coatings on alkaline cleaned panels. Auger electron spectroscopy depth profiling showed that the acid activation decreased the thickness of the aluminum oxide layer and the concentration of magnesium on the surface of the panels compared to the alkaline treatment. Additionally, acid activation increased the copper concentration at the surface of the aluminum substrate. Based on the results, the acid based surface treatment appeared to expose copper rich intermetallics, thus increasing the number of cathodic sites on the surface, which led to an overall increase in the deposition rate.     

The alkoxide sol–gel process in the calcium phosphate system and its applications†

A single calcium glycolate was synthesized. The alkoxide was stable under ambient atmosphere. The calcium glycolate, phosphoric acid and P(OH) _x (OEt)_{3− x} were used as the precursors. Acetic acid was used as a reagent to modify the calcium glycolate and to change the acidity of the mixtures of the precursors. Mixtures of the calcium glycolate and phosphoric acid in a Ca/P ratio of 1.67 showed unusual sol–gel behavior. A transparent gel could be formed depending on the content of acetic acid and the extent of stirring. The behavior is attributed to a high viscosity and a large molecular size of the ethylene glycol solvent, leading to a strong dependence of the reactions in the mixtures on the diffusion process, greatly affected by stirring. When the mixtures of the calcium glycolate and PO(OH) _x (OEt) _{3− x} contained acetic acid at an acetic acid/Ca ratio of 3, stable alkoxide solutions with Ca/P ratios of 1.0, 1.5 and 1.67 could be formed. Different calcium phosphate compounds and hydroxyapatite coatings on alumina substrates could easily be formed from the alkoxide solutions. The chemical homogeneity provided by the alkoxide route leads to easy formation of the required products. Copyright © 1999 John Wiley & Sons, Ltd.     

Electrochemical properties of Meldola's Blue immobilized on silica-titania phosphate prepared by the sol-gel method

The mixed oxide phosphate (≡SiO)₂Ti(O₃POH)₂ having a specific surface area of S_BET= 595 m² g⁻¹ and an average pore volume of 0.43 mL g⁻¹ was prepared by the sol-gel processing method. The material showed the following characteristics: Ti=11.6 wt% and P=10.5 wt%; ion exchange capacity of 0.60 mmol g⁻¹. Meldola's Blue (MLB) dye was adsorbed, by an ion exchange reaction, from an aqueous solution in a quantity of 0.62 mmol g⁻¹. The dye was strongly retained and was not easily leached from the matrix even in presence of 0.5 M electrolyte solution. Changing the solution pH between 2.5 and 7.0, the midpoint potential of the dye-adsorbed (≡SiO)₂ Ti(O₃POMLB)₂ matrix carbon paste electrode remained practically constant, i.e. about 20 mV vs. SCE. This is not the usual behaviour of MLB since its midpoint potential changes considerably in solution phase as the pH is changed. The modified electrode has proved to be stable and electrocatalytically active for hydrazine oxidation at pH 6. Received: 22 June 1999 / Accepted: 7 September 1999     

具有生物活性有机硅化合物的研究(XIV)──含硅四配位双(单)硫代磷酸酯化合物的研究

共合成了13个含硅四配位二硫代磷酸酯和2个含硅四配位单硫代磷酸酯的新化合物,经元素分析、IR、¹HNMR、MS确定了新化合物结构,对部分化合物进行了生物活性的测定,结果表明个别化合物有较好的生物活性。