Simultaneous microwave-assisted extraction of polycyclic aromatic hydrocarbons, polychlorinated biphenyls, phthalate esters and nonylphenols in sediments

A new method was developed for the simultaneous extraction of polycyclic aromatic hydrocarbons (PAHs), polychlorinated biphenyls (PCBs), phthalate esters (PEs), nonylphenols (NPs) and nonylphenol mono- and diethoxylates (NP1EOs and NP2EOs, respectively) in sediment samples by means of a closed microwave system. The extractions were carried out at 21 psi and 80% of microwave power and 15 ml of acetone were used as the common extraction solvent. The filtered extract was further fractionated in two groups using Florisil cartridges: PAHs and PCBs were eluted with n-hexane:toluene (4:1) and the PEs, NPs and ethoxylates were eluted with ethyl acetate. All the compounds were analysed by gas chromatography-mass spectrometry (GC-MS). In case of PAHs and PCBs, the developed method was validated by comparison of the results obtained for the certified reference material NIST 1944 with the certified values. In the absence of a reference material for phthalate esters and nonylphenols, one sediment sample was extracted twice under the optimal conditions in order to check than an exhaustive extraction of the analytes occurred. This method is currently used in the study of the distribution of those organic contaminants in the estuaries of the Bay of Biscay (Spain).     

Stir bar sorptive extraction and trace analysis of alkylphenols in water samples by thermal desorption with in tube silylation and gas chromatography-mass spectrometry

A novel method called thermal desorption (TD) with in tube silylation followed by gas chromatography-mass spectrometry (GC-MS), which is used for the determination of trace amounts of alkylphenols (APs) in river water samples, is described. APs are extracted from river water samples and concentrated by the stir bar sorptive extraction (SBSE) technique. The stir bar coated with polydimethylsiloxane (PDMS) is added to 2.0 ml water sample and stirring is carried out for 60 min at room temperature (25 degrees C) in the vial. Then, the PDMS stir bar is subjected to TD with in tube silylation followed by GC-MS. The detection limit is of the sub pg ml(-1) (ppt) level. The method shows good linearity and the correlation coefficients are higher than 0.99 for all analytes. The average recoveries of APs are higher than 90% (R.S.D.: 3.6-14.8%, n=6). This simple and sensitive analytical method may be used in the determination of trace amounts of APs in river water samples.     

SPE/LC/ESI/MS with phthalic anhydride derivatisation for the determination of alcohol ethoxylate surfactants in sewage influent and effluent samples

A new method for the analysis of alcohol ethoxylates (AEs) using electrospray ionisation liquid chromatography/mass spectrometry (ESI LC/MS) is described. The procedure incorporates a novel derivatisation step with phthalic anhydride for the analysis of EO0-20 ethoxylates in a single analysis. The derivatives obtained have proved to be very stable and the negative ion spectra show reduced background ions and competing adduct formation as compared to positive ion spectra. An automated solid phase extraction (SPE) step is used to allow both pre-concentration and clean-up of the environmental samples. The method provides more efficient recovery of AEs across the C12-C18 range than previously reported in the literature. Recoveries from final effluent spiked at 100 microg/L total AE, for the 126 species analysed, were found to be in the range 55-117%, with approximately 100 of the individual analytes having recoveries of 90-105%. An LOD of 0.02 microg/L for individual ethoxylate components is reported with the instrument operated in scan mode over the range m/z 300-1300. The method was applied to sewage effluent and influent samples, with AEs determined at approximately 7 and 5000 microg/L, respectively.     

液质联用法测定纺织品中烷基酚和烷基酚聚氧乙烯醚

采用高效液相色谱-质谱法测定了纺织品中残留的辛基酚、壬基酚、辛基酚聚氧乙烯醚和壬基酚聚氧乙烯醚,对提取方式、提取溶剂等前处理条件进行了优化,对质谱监测离子进行了选择。该方法检出限(S/N=5)为0.010~0.025 mg/kg,回收率为93%~106%,相对标准偏差为1.0%~5.0%,方法简便、准确,灵敏度高。     

Synthesis and surface activity properties of alkylphenol polyoxyethylene nonionic trimeric surfactants

A series of trimeric n-alkylphenol polyoxyethylene surfactants (TAP) were successfully synthesized and the molecular structure were confirmed by NMR, FTIR spectrum and elemental analysis. Using the same synthesis route, the trimeric nonylphenol polyoxyethylene surfactant (TNP) was synthesized using industrial product nonylphenol and paraformaldehyde, and its molecular structure was characterized by ¹HNMR, FTIR spectrum and elemental analysis. The optimal reaction conditions were established. The surface activity properties of TAP and TNP (such as the critical micelle concentration (cmc), the values of surface tension at the cmc (γ_cmc), the maximum surface excess concentration (Γ_cmc), and the minimum surface area per surfactant molecule (A_cmc)), were determined by means of Wilhelmy plate method and steady-state fluorescence probe method, respectively. The experimental results show that the lengths of the hydrophilic group oxyethylene (EO) chains and hydrophobic group methylene chains have an influence on the cmc, γ_cmc, Γ_cmc, and A_cmc of series of surfactants. Furthermore, TAP are arranged to staggered three-dimensional array mode at the air-water interface, which has exhibited better surface properties, such as low cmc values, strong adsorption affinities and wet abilities.     

Determination of nonylphenol ethoxylates in the aquatic environment by normal phase liquid chromatography-electrospray mass spectrometry

A comprehensive analytical method based on normal-phase liquid chromatography–electrospray ionization mass spectrometry (NPLC–ESI-MS) has been established for determination of nonylphenol ethoxylates (NPEOs) in the aquatic environment. Extraction and cleanup of samples were performed on graphitized carbon black (GCB) solid-phase extraction cartridges. Complete separation between each individual NPEOs was achieved by combining a C₁₈ pre-column with a silica analytical column and using acetonitrile–water as eluent. Quantitative determination by LC–ESI-MS was achieved in the positive ionization (PI) mode at a ramped cone voltage for NPEOs using selected ion monitoring. Recoveries for NPEOs ranged between 91.9 and 117.5%, and the limits of detection varied between 0.5 and 2 ng/l for individual NPEOs with n longer than 2, and between 5 and 0.5 μg/l for NP1EO and NP2EO. This method was successfully applied to the investigation of residual NPEOs with n>2 in the Chongqing area of the Changjiang river. NPEOs with n ranging from 1 to 22 were found to vary between 0.1 and 2900 ng/l with a distribution depending on the depth of water.     

Sterol surfactants: from synthesis to applications

An overview is given of sterol surfactants, including raw material aspects, classification and synthesis routes, physico-chemical behaviour and applications in pharmaceuticals and cosmetics.     

Development and optimisation of a GC-MS method for the evaluation of oestrogens and persistent pollutants in river and seawater samples

This paper describes the development and validation of a GC-MS method which allows the simultaneous quantification of 11 endocrine disrupting compounds (EDCs) in surface water samples from both estuary and sea. The analysed EDCs are oestrone (E1), 17β-estradiol (E2), 17α-ethynylestradiol (EE2), 4-tert-octylphenol, 4-n-octylphenol, 4-nonylphenol, bisphenol A and finally, mono and diethoxylates of 4-nonylphenol and 4-octylphenol. The method includes the pre-concentration of water samples, 1000-fold factor, in OASIS HLB cartridges by solid phase extraction, the derivatisation of all EDCs by N,O-bis(trimethylsilyl)trifluoroacetamide added with 1% trimethylchlorosilane and pyridine (at 65°C for 30?min) and, finally the stabilisation of the EDCs-silylated derivatives, in hexane, for 72?h. The validation parameters revealed that this method was highly specific for all target compounds using real samples. The linearity of the calibration curves (r ²) showed correlation factors higher than 0.990. The detection limits ranged from 0.10 to 1.45?ng?L^?1, depending on each analysed compound, and recoveries were satisfactory for most of the assayed EDCs (>60%). Analysis of samples from four polluted areas of Douro River estuary and from two points of the Atlantic Ocean (Portugal) showed high amounts of E1 (up to 1.96?ng?L^?1), E2 (up to 14.36?ng?L^?1) and EE2 (up to 2.76?ng?L^?1).     

Multi-Target Strategy to Uncover Unexpected Compounds in Rinse-Off and Leave-On Cosmetics

The wide range and complexity of cosmetic formulations currently available on the market poses a challenge from an analytical point of view. In addition, during cosmetics manufacture, impurities coming from raw materials or formed by reaction of different organic compounds present in the formulation may be present. Their identification is mandatory to assure product quality and consumer health. In this work, micro-matrix solid-phase dispersion (μMSPD) is proposed as a multi-target sample preparation strategy to analyze a wide number of unexpected families of compounds including polycyclic aromatic hydrocarbons (PAHs), pesticides, plasticizers, nitrosamines, alkylphenols (APs), and alkylphenol ethoxylates (APEOs). Analytical determination was performed by gas chromatography-mass spectrometry (GC-MS) for the determination of 51 target compounds in a single run, whereas liquid chromatography tandem mass spectrometry (LC-MS/MS) was employed for the analysis of six APs and APEOs. Both methodologies were successfully validated in terms of linearity, accuracy, and precision in leave-on and rinse-off cosmetics. Limits of detection (LODs) were calculated in the low ng g⁻¹, showing their suitability to determine trace levels of impurities and banned compounds with different chemical natures, providing useful tools to cosmetic control laboratories and companies.     

Decomposition kinetics of 2-propylphenol in supercritical water

The decomposition of 2-propylphenol (PP) at 673 K and a water density of 0–0.5 g cm⁻³ yielded 2-isopropylphenol (IPP), phenol and 2-cresol. Gas products were methane, carbon dioxide, ethylene and propene. The decomposition was found to occur through rearrangement and alkylation, that is, (1) rearrangement of the propyl functional group from PP to IPP, (2) dealkylation of PP to phenol, (3) dealkylation of PP to 2-cresol. The decomposition probably occurred by a free-radical mechanism. The reaction rate constants of each pathway were determined and it was found that these were invariant over all the water densities studied at the given temperature.