Y2O3薄膜处理对3Cr25Ni7N合金的抗高温氧化性能的影响

采用电沉积-热解法在3Cr25Ni7N合金表面制备了Y2O3薄膜,并研究了薄膜处理对合金在1000℃空气中的抗高温氧化性能的影响。氧化动力学曲线、SEM及XRD分析结果表明,Y2O3薄膜处理使合金表面氧化膜以尖晶石结构为主,氧化膜致密,有效地抑制了Cr2O3的挥发反应,且氧化膜与基体的附着性好,因此合金在高温下的抗氧化性能得到提高,这与氧化钇薄膜在较低温度下抗高温氧化性能提高的机制是不同的。在不同温度下,Y2O3薄膜处理均可以有效提高合金的抗高温氧化性能。     

Electrodeposition of a cobalt-molybdenum alloy from an ammonia-citrate electrolyte

Kinetics of processes of electrochemical production of a cobalt-molybdenum alloy out of an ammonia-citrate electrolyte is studied. The electrolyte’s composition is similar to that used for depositing a nickel-molybdenum alloy. It is established that the cobalt-molybdenum alloy undergoes deposition at smaller values of pH (5.0–6.0) than the nickel-molybdenum alloy (7.0–9.0). The current efficiency for the cobalt-molybdenum alloy is substantially dependent on the electrolyte pH, whereas the chemical composition of the obtained deposits is practically independent of the electrolyte pH in the pH interval 5.0–8.0 at current densities of 0.025 to 0.100 A cm^?2. On the other hand, a change in the electrolyte pH produces a considerable effect on the morphology of the obtained deposits. At large values of pH (pH 8.0), one can obtain a powder-like deposit of the cobalt-molybdenum alloy with a small value of the current efficiency. The deposits that are obtained in the pH region 5.0–6.0 have some cracks, with the number of cracks increasing with the electrolyte pH.     

Ni-B非晶态合金催化苯丙酮酸加氢合成苯丙氨酸

通过化学还原法制备了纳米非晶态Ni-B合金催化剂,考察了其对苯丙酮酸胺化加氢合成苯丙氨酸的催化性能.结果表明,相对于传统雷尼镍和漆原镍催化剂,非晶态合金催化剂表现出更为优异的活性和选择性,并且当非晶态Ni-B合金负载在SiO2载体上时,其活性和选择性均得到较大提高(高达97.67%).非晶态合金催化剂对苯丙氨酸合成反应表现出较好活性和选择性的原因主要是硼提供部分电子给镍的效应以及非晶态合金颗粒的纳米尺寸效应.     

Mg／Mgl．8La0．2Ni纳米复合材料的吸放氢性能研究

应用高能球磨法制备Mg-x％Mg1.8La0.2Ni（x=10、20和30）纳米复合储氢材料．X射线衍射（XRD）、透射电镜（TEM）和选区电子衍射（SAED）测试表明，该复合材料具有纳米晶和非晶态混合结构的性质，吸氢温度降低，较好的吸放氢动力学性能，在423K，2．5MPa氢压的条件下，50s内即可达到最大吸氢量．     

离子交换树脂预处理/离子色谱法测定镁铝合金中微量氯

镁铝合金试样用稀硫酸溶解后通过装有强酸性阳离子交换树脂的分离柱以除去试样溶液中大量镁及铝离子。通过交换柱的试液以及洗涤交换柱用的高纯水接受于1 L容量瓶中,用高纯水定容。分取25μL试液作离子色谱测定氯,对离子交换分离及离子色谱测定的条件作了试验和优化。离子色谱测定氯离子的标准曲线的相关系数为0.999 1,方法的检出限为1.03μg.L-1。根据精密度试验结果计算得其相对标准偏为4.5%。在6个试样中各加氯标准200.0 mg.kg-1作回收率试验,所得结果在94.1%~106.0%之间。     

Electrochemical characterization of Ni–Fe alloy codeposition under MHD control

The nickel–iron alloy electrodeposition is affected by a superimposed magnetic field. Some previous papers [Msellak et al., Magnetohydrodynamics, 39:487–493, 2003 and Msellak et al., J Magn Magn Mat, 281:295–304, 2004] have exhibited some dramatic changes in iron amount and morphology of these deposits. As it is usual for a magnetic field up to 1 T, no charge transfer effect can be expected, and the observed modifications can be explained by the magnetohydrodynamic convection that controls the iron species flux during the electrochemical reaction. By electrochemical impedance spectroscopy and physical investigations (scanning electron microscopy, X-ray diffraction, and inductively coupled plasma), the reduction process is analyzed, the characteristic parameters of the mechanism are determined, and the magnetic field effects can be quantified. Contribution to special issue on “Magnetic field effects in Electrochemistry”.     

金属铝燃料电池的研究

铝是一种丰富廉价的有色金属，金属铝电池作为一种新型燃料电池，具有低成本、无毒害、高功率、高能量密度等优点。本文简述了金属铝电池的工作原理，并对铝阳极、空气阴极、催化剂、电解液和铝燃料电池的应用等方面的研究概况进行了叙述。     

X-射线荧光光谱法测定钛铁中的硅、锰、磷、铝

介绍用X-射线荧光光谱仪测定钛铁中Si、Mn、P、Al含量的方法,通过试验确定了合适的研磨时间、压力和保压时间,用压片法制样,建立了各元素的工作曲线,各元素的测定范围分别为Si3.00%～6.00%,Mn1.00%～3.00%,P0.030%～0.070%,Al5.00%～9.00%。通过强度测量得到测定Si、Mn、P、Al的相对标准偏差分别为0.074%、0.308%、0.383%、0.040%,精密度满足测试要求。将该方法测定结果与化学法比对,准确度满足国家标准方法分析误差的要求。     

Oxidation behavior of NiAl alloy at low temperatures

Oxidation behavior of NiAl alloy at low temperatures was studied. A NiAl plate was oxidized by exposure to ambient atmosphere at room temperature, heated at 473 K in air, and heated at 773 K in air. The oxide formed on the NiAl surface was investigated by angle‐resolved X‐ray photoelectron spectroscopy (AR‐XPS). Chemical composition and atomic concentration in the oxide layer were analyzed with factor analysis of XPS spectra. Exposure of the NiAl plate to the ambient atmosphere resulted in the formation of an Al₂O₃ layer along with a small amount of NiO. Oxidation of the NiAl plate at 473 K in air formed a film of double‐layered oxide; the top layer consisted of NiAl₂O₄ and a small amount of NiO, and the second layer was Al₂O₃. Successive oxidation at 773 K only changed the oxide‐layer thickness without changing the structure. Formation of oxide observed in the present study corresponds to the thermodynamic prediction for the oxidation behavior of NiAl at 1373 K. Copyright © 2007 John Wiley & Sons, Ltd.     

火焰原子吸收光谱法测定钒铝合金中的铁

用盐酸–硝酸–水混合液(3∶1∶4)溶解样品,以火焰原子吸收光谱法测定钒铝合金中的铁含量。实验表明钒铝基体对铁含量测定结果无影响。选择灯电流为12.5 m A,燃气流量为2.0 L/min,燃烧头高度7.5 mm。结果表明,铁的质量浓度x在0~4 mg/L范围内与吸光度y呈良好的线性关系,线性方程为y=0.009 3x–8×10~(–5),相关系数为0.999 9。将该方法应用于两个不同样品中铁的测定,与利用YS/T 1075.1–2015标准方法所得结果基本一致,测定结果的相对标准偏差分别为2.32%,2.83%(n=11),加标回收率为98.0%~102.0%,可满足钒铝合金中铁的检测要求。