High sensitivity CW-cavity ring down spectroscopy of water in the region of the 1.5 μm atmospheric window

The absorption spectrum of natural water vapour around 1.5 μm has been recorded with a typical sensitivity of 5 × 10⁻¹⁰ cm⁻¹ by using a CW-cavity ring down spectroscopy set up based on fibred DFB lasers. A series of 31 DFB lasers has allowed a full coverage of the 6130.8-6748.5 cm⁻¹ (1.63-1.48 μm) region corresponding to the H transparency band of the atmosphere. The line parameters (wavenumber and intensity) of a total of 5190 lines, including 4247 lines of water vapor, were derived by a one by one fit of the lines to a Voigt profile. Different isotopologues of water (H₂¹⁶O, H₂¹⁸O, H₂¹⁷O, and HD¹⁶O) present in natural abundance in the sample contribute to the spectrum. For the main isotopologue, H₂¹⁶O, 2130 lines were measured with line intensities as weak as 10⁻²⁹ cm/molecule while only 926 lines (including a proportion of 30% inaccurate calculated lines) with a minimum intensity of 3 × 10⁻²⁷ cm/molecule are provided by the HITRAN and GEISA databases. Our comparison in the whole 5750-7965 cm⁻¹ region, has also evidenced that an error in the process of conversion of the intensity units from cm⁻²/atm to cm⁻¹/(molecule × cm⁻²) at 296 K, has led to H₂¹⁶O line intensities values listed in the HITRAN-2000 database, systematically 8 % below the original FTS values. The rovibrational assignment was performed on the basis of the ab initio calculations by Schwenke and Partridge with a subsequent refinement and validation using the Ritz combination principle together with all previously measured water transitions relevant to this study. This procedure allowed determining 172, 139, 71, and 115 new energy levels for the H₂¹⁶O, H₂¹⁸O, H₂¹⁷O, and HD¹⁶O isotopologues, respectively. The results are compared with the available databases and discussed in regard of previous investigations by Fourier transform spectroscopy. The spectrum analysis has showed that most of the transitions which cannot be assigned to water are very weak and are due to impurities such as carbon dioxide and ammonia, leaving only about 3% of the observed transitions unassigned. The interest of a detailed knowledge of water absorption for trace detectors developed in the 1.5 μm range is underlined: for instance HDO contributes significantly to the considered spectrum while no HDO line parameters are provided by the HITRAN database.     

Flame Temperature Effect on the Structure of SiC Nanoparticles Grown by Laser Pyrolysis

Small SiC nanoparticles (10 nm diameter) have been grown in a flow reactor by CO₂ laser pyrolysis from a C₂H₂ and SiH₄ mixture. The laser radiation is strongly absorbed by SiH₄ vibration. The energy is transferred to the reactive medium and leads to the dissociation of molecules and the subsequent growth of the nanoparticles. The reaction happens with a flame. The purpose of the experiments reported in this paper is to limit the size of the growing particles to the nanometric scale for which specific properties are expected to appear. Therefore the effects of experimental parameters on the structure and chemical composition of nanoparticles have been investigated. For a given reactive mixture and gas velocity, the flame temperature is governed by the laser power. In this study, the temperature was varied from 875°C to 1100°C. The chemical analysis of the products indicate that their composition is a function of the temperature. For the same C/Si atomic ratio in the gaseous phase, the C/Si ratio in the powder increases from 0.7 at 875°C up to 1.02 at 1100°C, indicating a growth mechanism limited by C₂H₂ dissociation. As expected, X-ray diffraction has shown an improved crystallisation with increasing temperature. Transmission electron microscopy observations have revealed the formation of 10 nm grains for all values of laser power (or flame temperature). These grains appear amorphous at low temperature, whereas they contain an increasing number of nanocrystals (2 nm diameter) when the temperature increases. These results pave the way to a better control of the structure and chemical composition of laser synthesised SiC nanoparticles in the 10 nm range.     

111In–L–LDL and 153Gd–L–LDL as radiotracers for detection of AR4‐2J rat pancreatic tumors

Pancreatic cancer has an extremely poor prognosis, due, in part, to lack of methods for early diagnosis. The present study was designed to evaluate the potential of labeling low‐density lipoprotein (LDL) with a radionuclide using a lipid chelating agent, bis(stearylamide) of diethylenetriaminepentaacetic acid (L), to detect pancreatic tumors by gamma‐scintigraphy. Previous studies indicated that the difficulty of visualization of pancreatic tumors was due to their poor vascularization. This study compares the ability of two radiotracers, ¹¹¹In–L–LDL and ¹⁵³Gd–L–LDL to target highly vascularized rat pancreatic tumors (AR4‐2J) implanted in nude mice. Biodistribution studies showed that the tumor uptake of ¹¹¹In–L–LDL and ¹⁵³Gd–L–LDL tracers was twofold and fivefold higher respectively than with the controls (¹¹¹In citrate and ¹⁵³Gd citrate respectively). These tracers would thus be suitable for scintigraphic imaging. We show here that LDL could be employed as a delivery system for tracers such as ¹¹¹In or ¹⁵³Gd when these two radionuclides are complexed by a lipid‐chelating anchor, and that ¹¹¹In–L–LDL and ¹⁵³Gd–L–LDL enabled better visualization of the pancreatic tumor tissues, with a better result with ¹⁵³Gd–L–LDL. Copyright © 2004 John Wiley & Sons, Ltd.     

Formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber blends: Effects of preparation method,composition, and thermal condition

The effects of preparation method, composition, and thermal condition on formation of β‐iPP in isotactic polypropylene/ethylene–propylene rubber (iPP/EPR) blends were studied using modulated differential scanning calorimeter (MDSC), wide angle X‐ray diffraction (WAXD), and phase contrast microscopy (PCM). It was found that the α‐iPP and β‐iPP can simultaneity form in the melt‐blended samples, whereas only α‐iPP exists in the solution‐blended samples. The results show that the formation of β‐iPP in the melt‐blended samples is related to the crystallization temperature and the β‐iPP generally diminishes and finally vanishes when the crystallization temperature moves far from 125 °C. The phenomena that the lower critical temperature of β‐iPP in iPP/EPR obviously increases to 114 °C and the upper critical temperature decreases to 134 °C indicate the narrowing of temperature interval, facilitating the formation of β‐iPP in iPP/EPR. Furthermore, it was found that the amount of β‐iPP in melt‐blended iPP/EPR samples is dependent on the composition and the maximum amount of β‐iPP formed when the composition of iPP/EPR blends is 85:15 in weight. The results through examining the effect of annealing for iPP/EPR samples at melt state indicate that this annealing may eliminate the susceptibility to β‐crystallization of iPP. However, only α‐iPP can be observed in solution‐blended samples subjected to annealing for different time. The PCM images demonstrate that an obvious phase‐separation happens in both melt‐blended and solution‐blended iPP/EPR samples, implying that compared with the disperse degree of EPR in iPP, the preparation method plays a dominant role in formation of β‐iPP. It is suggested that the origin of formation of β‐iPP results from the thermomechanical history of the EPR component in iPP/EPR. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1704–1712, 2007     

Synthesis, morphology and random laser action of ZnO nanostructures

Three-dimensional (3-D) ZnO random-wall nanostructures and one-dimensional (1-D) ZnO nanorods were prepared on silicon substrates by a simple solid-vapour phase thermal sublimation technique. Optical pumped random lasing has been observed in the ZnO random-wall arrays with a threshold intensity of 0.38 MW/cm² in the emission wavelength from 380 to 395 nm. The optical gain was attributed to the closed-loop scattering and light amplification of the ZnO random-wall. The experimental result suggests that the morphology of nanostructure is the key factor to effect random lasing.     

A DC excited waveguide multibeam CO2 laser using high frequency pre-ionization technique

High power industrial multibeam CO₂ lasers consist of a large number of closely packed parallel glass discharge tubes sharing a common plane parallel resonator. Every discharge tube forms an independent resonator. When discharge tubes of smaller diameter are used and the Fresnel numberN ≪ 1 for all resonators, they operate in waveguide mode. Waveguide modes have excellent discrimination of higher order modes. A DC excited waveguide multibeam CO₂ laser is reported having six glass discharge tubes. Simultaneous excitation of DC discharge in all sections is achieved by producing pre-ionization using an auxiliary high frequency pulsed discharge along with its other advantages. Maximum 170 W output power is obtained with all beams operating in EH₁₁ waveguide mode. The specific power of 28 W/m is much higher as compared to similar AC excited waveguide multibeam CO₂ lasers. Theoretical analysis shows that all resonators of this laser will support only EH₁₁ mode. This laser is successfully used for woodcutting     

Cu-MgF2复合纳米金属陶瓷薄膜的电导特性研究

用射频磁控共溅射法制备了Cu体积分数分别为 10 % ,15 % ,2 0 %和 3 0 %的Cu MgF2 复合金属陶瓷薄膜 .用x射线衍射、x射线光电子能谱和变温四引线技术对薄膜的微结构、组分及电导特性进行了测试分析 .微结构分析表明 :制备的Cu MgF2 复合薄膜由fcc Cu晶态纳米微粒镶嵌于主要为非晶态的MgF2 陶瓷基体中构成 ,Cu晶粒的平均晶粒尺寸随组分增加从 11 9nm增至 17 8nm .5 0— 3 0 0K温度范围内的电导测试结果表明 :当Cu体积分数qM 由 15 %增加到 2 0 %时 ,Cu MgF2 复合薄膜的电阻减小了 8个量级 ,得出制备的复合薄膜渗透阈qCM 应处于 15 %和 2 0 %之间 .qM 在 10 %和 15 %之间的薄膜呈介质导电状态 ,而在 2 0 %和 3 0 %之间的薄膜则呈金属导电状态 .从理论上讨论了复合薄膜中杂质电导和本征电导的激活能及其对电导的贡献 ,并讨论了Cu MgF2 复合纳米金属陶瓷薄膜的渗透阈 ,得到了和实验一致的结果     

A new cytotoxic limonoid from Odontadenia macrantha from the Suriname rainforest

Bioassay‐guided fractionation of the methanol extract of Odontadenia macrantha afforded a new limonoid, odontadenin A (1) and two known triterpenoids, lupeol (2) and α‐amyrin (3). The structure of 1 was established on the basis of 1D and 2D NMR and high‐resolution fast atom bombardment mass spectrometric data. The new compound was found to possess moderate cytotoxicity against A2780, the ovarian cancer cell line. Copyright © 2003 John Wiley & Sons, Ltd.     

Molecular dynamics in aqueous solutions of β-cyclodextrin

Water molecule mobility in ion-containing and nonionic aqueous solutions of β-cyclodextrin was studied by quasielastic neutron scattering (QENS). The total self-diffusion coefficients and their components corresponding to the contributions from collective (Lagrange type) and single-particle (jump diffusion) parts of molecular motions were determined. From the data obtained, one can conclude that the molecular mobility of free water in nonionic aqueous solutions of β-cyclodextrin with guest molecules (2-aminopyridine) proceeds by a single-particle mechanism. The addition of Pb²⁺ ions into the solution leads to increase in self-diffusion coefficients and growth of a bound water fraction.     

Electrical characterization of low temperature deposited TiO2 films on strained-SiGe layers

Thin films of titanium dioxide have been deposited on strained Si_0.82Ge_0.18 epitaxial layers using titanium tetrakis-isopropoxide [TTIP, Ti(O-i-C₃H₇)₄] and oxygen by microwave plasma enhanced chemical vapor deposition (PECVD). The films have been characterized by X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FTIR). Dielectric constant, equivalent oxide thickness (EOT), interface state density (D_it), fixed oxide charge density (Q_f/q) and flat-band voltage (V_FB) of as-deposited films were found to be 13.2, 40.6 Å, 6×10¹¹ eV⁻¹ cm⁻², 3.1×10¹¹ cm⁻² and −1.4 V, respectively. The capacitance–voltage (C–V), current–voltage (I–V) characteristics and charge trapping behavior of the films under constant current stressing exhibit an excellent interface quality and high dielectric reliability making the films suitable for microelectronic applications.