聚酰胺酸合成工艺研究

 采用超声波在线测量溶液粘度的方法，研究了合成聚酰胺酸过程中实验条件的影响，并对实验结果进行分析，由此确定了合成高分子量聚酰胺酸的最佳实验条件。研究表明：在加料次序为先加二胺后加二酐（二酐与二胺的摩尔比为1.01～1.02：1）、试剂中含水量尽可能少，反应温度0～5℃、反应时间以溶液粘度到达最大值为止的条件下，所合成的聚酰胺酸溶液粘度最大，可满足惯性约束聚变（ICF）充气腔靶端口膜的需要。     

流动注射-化学发光法定量测定同一水域中的腐殖酸

采用流动注射-化学发光(FI-CL)这一灵敏的检测方法,通过条件实验与参数优化,优选了测定环境中痕量多羟基酚类化合物的发光体系,通过考察天然水体中的腐殖酸对化学发光-多羟基酚测定体系的影响,为来自于水及土壤中的实际样品中腐殖酸的检测提供了参考,建立了同一区域水体中腐殖酸的化学发光定量测定方法。 所得线性回归方程y=70.36x+540.1,相关系数r=0.995 4,线性范围为3～15 mg·L-1,检测限为0.749 mg·L-1,HA浓度为6 mg·L-1时的相对标准偏差(RSD)为1.08%。     

Improved Synthesis and Structure of 3-Carboxy-2-pyrazinecarbohydroxamic Acid

3-Carboxy-2-pyrazinehydroxamic acid was prepared by a one pot reaction starting from pyrazine-2,3-dicarboxylic anhydride with a high yield, and characterized by IR, Mass spectrum, 1H NMR and 13C NMR spectra and single-crystal X-ray diffraction. It crystallizes in triclinic, space group Pī with a=4.8659(10), b=7.4233(15), c=11.602(2), α=96.904(2), β=92.422(3), γ=107.454(2)°, V=395.51(14)3 , Z=2, Dc=1.689g/cm3 , F(000)=208, μ(MoKα)=0.149 mm-1 , the final R=0.0473 and wR=0.1306 for 2853 observed reflections (I>2σ (I)). A three-dimensional framework was assembled through intermolecular hydrogen bonding between water and 3-carboxy-2-pyrazine-carbohydroxamic acid molecules.     

Simultaneous determination of morniflumate and its major active metabolite,niflumic acid,in human plasma by high‐performance liquid chromatography in stability and pharmacokinetic studies

A rapid, sensitive and stable high‐performance liquid chromatography (HPLC) method was developed and validated for the simultaneous determination of morniflumate and its major active metabolite, niflumic acid, in human plasma. HPLC analysis was carried out using a 5 µm particle size, C₁₈‐bonded silica column with a mixture of acetonitrile and 0.005 m potassium phosphate monobasic in water (60:40, v/v) as the mobile phase and UV detection at 287 nm. The method involved the treatment with 50 μL of 0.4 m hydrochloric acid for the stability of morniflumate, extraction with diethylether and evaporation to dryness under a nitrogen stream. The lower limit of quantitation for morniflumate and niflumic acid was 50 and 500 ng/mL, respectively. The calibration curves for morniflumate and niflumic acid were linear over the concentration range of 50–20,000 ng/mL and 500–50,000 ng/mL, respectively, with correlation coefficients greater than 0.9995 and inter‐ or intra‐batch coefficients of variation not exceeding 13.79%. The variability (percentage difference) of incurred sample re‐analysis did not exceed 11.72% and all of the repeat samples fell within 20% of the mean value. This assay procedure was applied successfully to an examination of the pharmacokinetics of morniflumate and its metabolite, niflumic acid, in human subjects. Copyright © 2013 John Wiley & Sons, Ltd.     

Use Of Diffusion Controlled Preconcentration Systems With Chemically Immobilized Coatings For The Determination Of Atmospheric Nitric Acid

Abstract

A new coating procedure for different diffusion controlled preconcentration methods (tubular denuder, annular denuder, diffusion screen) is described for the determination of nitric acid in air. In this study, a silanization reaction is applied to obtain a chemically fixed coating with an end placed functional NH₂-group, which can be used as a sink to collect acidic compounds from air. This coating must be carried out only once and can be used for a long time. The denuders, coated with this procedures, were compared with conventionally coated NaF denuders.     

Kinetic Carbon Isotope Effects in the Decarbonylation of Lactic Acid of Natural Isotopic Composition and of [1-14C] Lactic Acid

Studies of carbon-13 and carbon-14 kinetic isotope effects (K. I. E.) in the decarbonylation of lactic acid (L. A.) in sulphuric acid and in phosphoric acids media have been summarized and compared with earlier studies of ¹⁴C and ¹³C K. I. E. in the decarbonylation of formic and oxalic acids in concentrated sulphuric acid. Supplementary data concerning the decarbonylation of L. A. in sulphuric acid diluted with water and in pyrophosphoric acid are presented and discussed. The observed temperature dependences of ¹³C and ¹⁴C K. I. E. in concentrated H₂SO₄ and in concentrated phosphoric acids media have been rationalized by invoking a change of the mechanism of decarbonylation of L. A. in concentrated sulphuric and phosphoric acids with temperature. Preliminary calculational results concerning ¹³C and ^1??C K. I. E. in decarbonylation processes are also presented. In H₂SO₄ diluted with water and in H₃PO₄ diluted with water the temperature dependence of ¹³C and ¹⁴C K. I. E. is normal and well reproduced by one frequency approximation. In concentrated sulphuric acid and in concentrated phosphoric acids besides the C—OH bond rupture the rupture of a C—C bond had to be considered also to reproduce the observed ¹³C K. I. E. in selected temperature regions.     

Изотопные мишени для ядерных исследований

A non-contact measuring method on electrostatic potential by using α-ray ionization is proposed. In this method potential of a charged material is estimated from ionic current flowing through an ion collector attached with a small ²⁴¹Am source. As hade electrode surrounding the collector has a function of adjusting sensitivity and potential up to 50 kV was measured with precision of 1 kV.     

一种锌配合物用于炭疽生物标志物的检测

采用溶剂热合成方法,合成了一种新型金属配位聚合物{[Zn₂(L)(H₂O)(DMA)]·DMA·2.3H₂O}_n (1),其中L^4-为完全脱去质子的N,N''-二(4-羧基苄基)-5-氨基间苯二甲酸,DMA为N,N-二甲基乙酰胺。单晶X射线衍射结果显示,该配合物属于三斜晶系,空间群为P$overline{1}$,a=0.989 6(5) nm,b=1.370 5(5) nm,c=1.382 1(5) nm,α=80.067(5)°,β=76.729(5)°,γ=76.611(5)°,结构是由二维金属有机层通过π…π相互作用而扩展成的三维超分子骨架。红外光谱验证了锌离子与L^4-配体成功配位。粉末X射线衍射(PXRD)实验证实了配合物1具有较高的纯度。热重分析结果显示配合物1在室温至416.9 ℃区间内具有较好的热稳定性。在273 nm的激发光下,配合物1在437 nm处有较强的荧光发射,可以在30 s内快速检测乙醇溶液中的炭疽生物标志物——吡啶-2,6-二甲酸,具有选择性高、抗干扰能力强、检测限低(约为15 μmol·L^-1)等特点。结合PXRD图和紫外可见吸收光谱揭示了其检测机理为晶体骨架坍塌而诱导的荧光猝灭。     

Convenient Synthesis and Purification of N-Trifluoroacetylated Neuraminic Acid Tetraol: A Key Precursor for the Synthesis of New Sialyl Donors Containing Labile O-Acyl Protecting Groups

A convenient synthesis and separation of α- and β-anomers of methyl (phenyl 3,5-dideoxy-2-thio-5-trifluoroacetamido-D-glycero-D-galacto-nonulopyranosid)onate (6a and 6b) on a multigram scale was developed. Both α- and β-isomers of 6 were obtained as crystals suitable for safe storage. The β-isomer forms a crystalline solvate with methanol. Fully O-trichloroacetylated and O-trifluoroacetylated N-trifluoroacetyl thiosialosides were synthesized in an efficient manner from the β-tetraol 6b.     

Folate binding protein—Outlook for drug delivery applications

Serum proteins represent an important class of drug and imaging agent delivery vectors. In this minireview, key advantages of using serum proteins are discussed, followed by the particular advantages and challenges associated with employing soluble folate binding protein. In particular, approaches employing drugs that target folate metabolism are reviewed. Additionally, the slow-onset, tightbinding interaction of folate with folate binding protein and the relationship to a natural oligomerization mechanism is discussed. These unique aspects of folate binding protein suggest interesting applications for the protein as a vector for further drug and imaging agent development.