测定不同形状物体空气阻力系数的实验

设计空气流速连续可调的小型风洞,对圆形平板、圆柱体、流线体的空气阻力系数进行测量.利用U型管中水柱的高度差表达孔板法中空气的流速,通过悬臂梁力传感器测量测试物受到的空气阻力,根据空气阻力和U型管中水柱的高度差的关系测定空气阻力系数.     

Power dissipation characteristics of great power and super high speed semiconductor switch

The power dissipation characteristics of pulsed power switch reversely switched dynistors （RSDs） are investigated in this paper. According to the expressions of voltage on RSD, derived from the plasma bipolar drift model and the RLC circuit equations of RSD main loop, the simulation waveforms of current and voltage on RSD are acquired through iterative calculation by using the fourth order Runge-Kutta method, then the curve of transient power on RSD versus time is obtained. The result shows that the total dissipation on RSD is trivial compared with the pulse discharge energy and the commutation dissipation can be nearly ignored compared with the quasi-static dissipation. These characteristics can make the repetitive frequency of RSD increase largely. The experimental results prove the validity of simulation calculations. The influence factors on power dissipation are discussed. The power dissipation increases with the increase of the peak current and the n-base width and with the decrease of n-base doping concentration. In order to keep a low power dissipation, it is suggested that the n-base width should be smaller than 320μm when doping concentration is 1.0×10^14cm^-3 while the doping concentration should be higher than 5.8×10^13cm^-3 when n-base width is 270μm.     

TIG焊焊缝X光照相异常图象形成机制的研究

采用X光照相检测GH163合金TIG(tungsten-inert-gasarcwelding)焊结构时,在胶片上发现焊缝中心有一黑线。本文通过X光偏转实验和光学金相对其形成机制进行了研究,并提出了防治措施。     

具有空穴传输基团的超支化聚合物发光材料的结构与光谱性质

利用A2 B3反应,合成了带有空穴传输基团——三苯胺为联接单元,以1,3,5-三苯基苯为核的超支化聚合物（TPA-TPP）,并对这类聚合物的合成方法、结构、光物理性质进行了系统的研究。通过溶剂效应观察到了TICT（分子内电荷转移态）,发射谱为宽而无结构的带谱,且发射波长随溶剂极性的增大而明显红移。因而可利用此特性来调节发光波长。研究结果表明,以三苯基苯为核心,引入三苯胺基团作为连接基团,加大了空间位阻,使由溶液到固体膜状态的发射光谱红移减小。     

具有特大磁电阻效应钙钛矿材料的制备及性能分析

通过固相烧结法制备了具有特大磁电阻效应的钙钛矿材料Pr0.64Ag0.044MnAl0.2O3.利用结构和成分分析,发现此材料只有在1 100℃高温烧结下才能生成完整的钙钛矿结构,且属于立方晶系,晶格常量a≈0.386 nm.在0.4 T的外磁场下,磁电阻值在122 K处达到最大,约为19.2%,为巨磁电阻实验提供了较好的样品.     

磁性隧道结Ni80Fe20/Al2O3/Co的制备和物性

用等离子体氧化形成绝缘层的方法，重复性地制备出了Ni     

Procreating tiles of double commutative-step digraphs

Double commutative-step digraph generalizes the double-loop digraph. A double commutative-step digraph can be represented by an L-shaped tile, which periodically tessellates the plane. Given an initial tile L（l, h, x, y）, Aguil5 et al. define a discrete iteration L（p） = L（l ＋ 2p, h ＋ 2p, x ＋ p, y ＋ p）, p = 0, 1, 2,..., over L-shapes （equivalently over double commutative-step digraphs）, and obtain an orbit generated by L（l, h, x,y）, which is said to be a procreating k-tight tile if L（p）（p = 0, 1, 2, ~ ~ ~ ） are all k-tight tiles. They classify the set of L-shaped tiles by its behavior under the above-mentioned discrete dynamics and obtain some procreating tiles of double commutative-step digraphs. In this work, with an approach proposed by Li and Xu et al., we define some new discrete iteration over L-shapes and classify the set of tiles by the procreating condition. We also propose some approaches to find infinite families of realizable k-tight tiles starting from any realizable k-tight L-shaped tile L（l, h, x, y）, 0 ≤ y - x ≤ 2k ＋ 2. As an example, we present an infinite family of 3-tight optimal double-loop networks to illustrate our approaches.     

Negative Resistance in a Two-Dimensional System with Entropic Barrier

A phenomenon of negative resistance is found in two-dimensional bistable and periodic potentials via Langevin simulation, where output quantities for noise and signal driven system, such as the power-spectrum density modulus and the signal power amplification, can become minima at finite temperatures. In such a system, the curvature of the potential along non-transport degree of freedom at the barrier is larger than that at the local minima. The temperature-dependent effective barrier, i.e. entropic barrier, is introduced via integration over the non-transport variables. The system shows the negative resistance because of the competence between the signal and the entropic barrier.     

CHJ-S-2型超声波塑料焊接机

上海超声波仪器厂新近研制成功了一种新颖的大功率超声波塑料焊接机,它是焊接热塑性塑料制品的最新设备,各种注塑而成的胶件都可以使用该设备进行焊接,不需要任何熔剂、粘合剂或其他辅助品,它具有焊接速度快、质量高、外形美观等优点。 超声波塑料焊接机用途广泛,只要使用热塑性胶件的行业都可适用,如电子工业、汽车工业、电器制造、玩具、家庭用品、包装及一般塑料行业等。 本设备可根据不同焊接对象进行熔焊、嵌焊、铆焊等,由于本设备输出功率较大,所以对较大面积的塑料作进行传输焊接效果更为理想。     

La2/3Ca1/3MnO3样品的磁和电子输运性质研究

实验研究了La2/3CamMnO3样品零磁场下的电阻率和低磁场下的磁化强度随温度的变化行为．结果表明，除了居里温度(Tc)外还存在另一特征温度Tonset，高于Tonset的样品为典型的顺磁绝缘体，而低于Tc的样品为典型的铁磁金属，但在Lonset和Tc之间，样品的磁化率大大偏离居里一外斯定律，同时其导电特性显示出明显的反常．对观察到的不寻常导电特性，根据铁磁金属集团在顺磁绝缘体背景上随机分布的假设，进行了分析与探讨。