钇对2618合金组织及性能的影响

采用X射线，光学显微镜及扫描电镜等手段研究了2618合金中的组织与相结构，并研究了元素钆在2618合金中的存在形式及其对合金力学性能的影响。结果表明，微量钆元素在铝合金中是以化合物形式存在的；钆对合金中的铸态组织及Al9FeNi仃形态没有影响。由于微量钆的加入，降低了铜与镁在2618合金中的固溶量，减少了时效析出相A2CuMg数量，从而降低2618合金的室温强度帮在250℃的高温瞬时强度；但由于微量钆减少了铜与镁在2618合金中的扩散速度，延缓了时效机的粗化，并由于第二相数量的增多，因此提高了2618合金在250℃经100h高温热暴露后的高温瞬时强度。     

溶剂萃取法制备Co(PO_3)_2超细微粉

本文用溶剂萃取法成功地制备了偏磷酸钴超细微粉并通过ＸＲＤ，ＩＲ，ＴＧ，ＤＴＡ，ＴＥＭ等实验对超细微粉的组成、结构进行了表征。     

Effect of Drying Methods on the Structure and Combustion Activity of Mn—Substituted Hexaaluminate Catalysts

Conventional oven drying (COD) and supercritical drying (SCD) methods were applied to the preparation of Mn-substituted hexaaluminate (BaMnA111O19-α) catalysts. The effect of drying methods on phase composition, specific surface area, pore structure, reduction behavior of Mn^3 ions, and combus-tion activity of the samples was investigated. The homogenous mixing of the components in the sol-gel process could be maintained by SCD, and the hexaaluminate phase was almost the only phase of the resulting materials after calcination. H2-TPR revealed that the Mn^3 ions in the sample obtained by SCD were easier to be reduced than that by COD. Moreover, the samples obtained by SCD have higher surface area, narrower pore size distribution, and higher combustion activity than those obtained by COD.     

有机溶剂对镧和钇ICP光谱信号的增敏机理研究

本文考察了有机溶剂（乙酸丁酯）及有机试剂（PMBP）引入ICP－AES对稀土元素镧和钇光谱信号的影响。实验结果表明，有机溶剂的引入明显增大了待测物的传质效率，从而导致分析灵敏度的改善。与水相相比，有机相的引入对ICP激发温度未产生明显影响，但使线对强度比（LogI^ /I)增强，有利于待测物的电离。     

聚苯乙烯乳胶球三维有序体的制备及其显微形貌表征

A three-dimensional (3D) ordered structure was achieved by self-organization of monodisperse polystyrene latex about 250nm in diameter after being ambient dried. The stacked morphology was investigated by scanning electron microscopy(SEM) observation. It is shown that the face-centered cubic(FCC) phase dominantly exists. This finding presents a potential template for preparing an inverse FCC structure as a photonic crystal of full band gap if the index contrast is higher than 2.8.     

晶体C60的相对稳定性

C_(60)分子的空心球状结构假设已为各种光谱手段及扫描电镜技术所证实。但是,由于难以制备长程有序的C_(60)单晶,人们至今未能测得其键长、键角等结构参数。C_(60)单晶制备技术上的巨大困难显然与C_(60)分子间微弱的范德华力及其自身的高速旋转和空间阻碍有关。本工作旨在建立C_(60)分子间相互作用     

衍生化毛细管气相色谱法测定糖尿病大鼠眼球晶体中糖醇含量

建立了大鼠眼球晶体中糖醇化合物包括葡萄糖、肌醇、山梨醇同时测定的毛细管气相色谱分析方法。通过改进用甘露糖为内标，先加入5％盐酸羟胺．吡啶溶液进行肟化反应，再加入醋酸酐溶液进行乙酰化反应，将糖醇化合物转化成相应的糖腈乙酰醇化合物，经SE-30毛细管柱色谱分离，氢火焰离子化检测器检测。葡萄糖、肌醇、山梨醇的回收率均在93％以上，其检出限分别为0．40、0．26和0．30mg/L。比较测定了正常对照组、糖尿病对照组、某中药复方治疗组的大鼠眼球晶体中各单糖的含量。     

Y2O2S：Eu,Mg,Ti,Tb红色长时发光材料的研究

利用高温固相反应法合成了一种新型的红色长时发光材料－Y2O2S：Eu,Mg,Ti,Tb.材料的XRD测试结果表明Eu掺杂引起Y2O2S，Eu,Mg,Ti,Tb晶胞增大，激发光谱，发射光谱和发光衰减曲线表明该材料是一种适合紫外线和可见光激发，并具有很好的长时发光性能的红色长时发光材料，热释光谱测试结果表明该材料可能具有两个较深的陷阱能级，研究了Eu,Mg,Ti,Tb的加入量对材料发光特性的影响。结果表明：Eu,Mg,Ti,Tb影响材料的初始亮度和发光时间，Eu决定材料的红色比。