钯／阴离子交换树脂对硝基化合物催化加氢的取代基效应

本文研究了聚苯乙烯系强碱性阴离子交换树脂负载的钯催化剂对取代硝基苯催化加氢的性能,结果表明,取代基的电子性质及空间位置对加氢速率影响很大;反应活化能与取代常数σ之间呈线性关系:E_1=-20.7σ+47.0在该反应体系中存在补偿效应:log A_(red)=0.14E_a-6.86     

交联聚4-乙烯基吡啶及其季铵盐负载钯催化剂对丙烯酸甲酯加氢反应的研究

 制备了交联聚4-乙烯基吡啶及碘甲烷,溴乙烷季铵化的聚4-乙烯基吡啶负载钯催化剂,考察了它们催化丙烯酸甲酯加氢反应的性能。对碘甲烷季铵化聚4-乙烯基吡啶负载钯催化剂,其催化加氢活性随载体季铵化程度的增加而减小,并且当载体季铵化程度低于80％时,其催化加氢活性比聚4-乙烯基吡啶负载催化剂高。实验结果表明催化剂制备条件对催化性能有很大影响。     

钴铬水滑石的合成及表征

采用共沉淀法合成了一系列不同Co/Cr物质的量比的碳酸根型水滑石。用X－衍射、红外光谱、差热、热重、分光光度等方法对其组成和结构进行了研究。结果表明Co/Cr投料比为2到3时能形成结晶度好、纯度高的水滑石。初步推测了部分产物的组成及所含水滑石的化学式。     

壳聚糖表面修饰的SiO2负载Ni-B非晶态合金的制备及催化性能

以壳聚糖(CS)对SiO2进行表面修饰, 采用浸渍还原法制备了负载型Ni-B非晶态合金催化剂(Ni-B/CS/SiO2), 并采用XRD、FTIR、电感耦合等离子体发射光谱(ICP)、BET、XPS、TEM、SAED等表征方法研究了催化剂的非晶性质、原子组成、尺寸分布及粒径大小等. 考察了催化剂对糠醇加氢制四氢糠醇反应的催化性能, 并与没有壳聚糖修饰的Ni-B/SiO2催化剂及Raney Ni催化剂进行了对比. 结果表明, 加入壳聚糖制得的Ni-B/CS/SiO2催化剂的活性组分Ni-B团簇粒径更小, 表面活性组分浓度更高, 催化活性更高.     

煤—焦炉气共热解特性的研究：温度的影响

利用高压热天平和１０ｇ固定床反应器考察了温度对兖州烟煤与焦炉气共热解的失重行为、热解产物分布以及脱硫脱氮的影响。随热解温度升高共热解在３００～５５０℃和６００～７００℃间出现明显失重峰。煤焦炉气共热解与加氢热解失重行为相似，均发生热分解反应和加氢反应。在实验温度范围（４５０～６５０℃）内，温度升高有利于提高焦油收率、热解水含量以及脱硫脱氮率，同时半焦收率降低。相同热解条件（压力为３ＭＰａ，终温为６５０℃）下，与煤在氮气气氛下热解相比，煤焦炉气共热解和加氢热解所得半焦收率均降低，焦油收率、热解水及脱硫脱氮率明显增加。与相同总压的加氢热解相比，煤焦炉气共热解半焦和热解水收率增加，焦油收率降低，脱硫率相当且脱氮率降低     

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.     

SMAI法制备的Cu催化剂的CO加氢催化

用溶剂化金属原子浸渍（SMAI）法制备了SiO2、Cr2O3负载Cu催化剂.XPS测定表明三种载体上的Cu几乎全部以零价态存在．X射线增宽法测定表明随着Cu含量增加Cu颗粒增大．Cu催化剂在CO加氢中的催化活性与载体、Cu颗粒大小和Cu价态有关．Cr2O3对Cu催化活性有促进效应．Cr2O3负载Cu催化剂活性随Cu颗粒减小而增大，而SiO2作载体时，颗粒大小对活性无影响，零价Cu0为催化活性中心     

三组分(NiO、La2O3、SiO2)负载型加氢催化剂中La2O3的作用

用X射线衍射分析、FT-IR、小角X光散射等方法研究了浸渍法制备的NiO/SiO_2和NiO/(La_2O_3+SiO_2)样品中组分之间的相互作用。La_2O_3在SiO_2上可形成近乎密置单层的分散。在负载了La_2O_3的SiO_2上,NiO的分散程度比在SiO_2上有明显提高,也更容易被还原,而且还原后所得金属镍粒子的平均粒度降低,小粒子所占百分比提高。这些结果表明,NiO/(La_2O_3+SiO_2)比NiO/SiO_2样品具有更高的加氢还原硝基普鲁卡因为胺基普鲁卡因的活性,与Ni/(La_2O_3+SiO_2)比Ni/SiO_2活性高的情形相一致。     

水热改性对NiMo/γ-Al2O3加氢脱氮催化剂结构及性能的影响

The influence of hydrothermal modification on the structure and hydrodenitrogenation (HDN) activity of NiMo/γ-Al₂O₃catalyst was studied in the range 140～180 ℃. The experimental results indicated that the hydrodenitrogenation reaction rate of pyridine was accelerated using the NiMo/γ-Al₂O₃catalyst synthesized via hydrothermal route due to the change of the structure, the increase of the amount of Mo and Ni and the rise of the specific surface area. The change of the structure of catalysts was enhanced at higher hydrothermal temperature, producing NiMo/γ-Al₂O₃catalyst with better HDN activity.     

Recent Results on Fast Flow Gas-Phase Partial Oxidation of Lower Alkanes

Recent experimental results and kinetic modeling of fast flow gas-phase oxidation of methane and other lower alkanes to methanol and other oxygenates are discussed,alongside with prospects and possible areas for applications of the processes.