钼过氧配合物与HSO 在酸性溶液中的反应动力学和机理

用载流法研究了Mo~4O~12(O~2) [简作Mo~4(O~2)~2] 与HSO 在酸性条件(4×10^-3～0.5mol·dm^-3)下的反应动力学,并提出了反应机理.反应经历下列历程:Mo~4(O~2)~2+H~2O Mo~4(O~2)(OOH)(k~1,k~-1) Mo~4(O~2)(OOH)+HSO Mo~4(O~2)OOSO~2+H~2O(k~2,k~-2) Mo~4(O~2)OOSO~2+H~2O Mo~4(O~2)+H~2SO~4(k~1,k~-1)中间产物Mo~4(O~2)再以相同机理继续与HSO 反应.由机理,得到了[S(IV)/k~观察与[H^+],[S(IV)]之间的线性关系式以及20℃时的动力学参数:K~1=7.4±0.3dm^3·mol^-1·S^-1,k~-1/k~2=(5.8±0.5)×10^-2和k~-2/k~3=(1.4×0.8)×10^-4.配合物Mo~4(O~2)~2中(O~2)基质子化是决定反应速度的关键步骤.用此机理讨论了Thompson研究的 MoO(O~2)~2与HSO 的反应结果.     

SiO_2负载钼催化剂的合成及其催化乙烯二聚、同系化和歧化的反应性能

从单核及双核二甲胺钼络合物出发,制备了SiO_2负载的钼催化剂。程序升温分解实验(TPDE)及红外测试表明,双核钼络合物与SiO_2作用生成双钼中心物种,此物种可催化乙烯的二聚反应。280℃活化后此双钼中心物种变成单钼中心物种,单钼物种只催化乙烯的同系化及歧化反应。     

钇钼钨硅杂多配合物的合成稀土多元渗及导电性

用降解法合成了未见报道的标题配合物.通过化学分析、ICP和TG曲线确定了其化学式为K10H3[Y(SiW9Mo2O39)2];利用IR、XRD、183W-NMR、循环伏安等手段对其结构进行了表征.结果表明,杂多阴离子为α-型Keggin结构.采用稀土多元渗的方法对配合物进行了气相热扩渗,ICP和XPS测试表明,微量的稀土元素La,Sm和Dy可以渗入到配合物的体相,并与组分元素发生键合作用;导电性的测试结果表明,室温扩渗后,试样的电导率提高了约104倍,有望成为具有实际应用的固体电解质.     

四面体手性配合物催化二乙基锌对苯甲醛的不对称加成反应

利用手性相转移催化剂(氯化苄基莘可宁)诱导合成了具有光学活性的炔桥钴钼双金属异核配合物, 并实现了此配合物中手性四面体骨架催化二乙基锌与苯甲醛加成反应的不对称诱导, 从而证实了四面体骨架手性对催化反应的不对称诱导作用.     

制备参数对β-Mo2N0.78催化剂加氢脱硫活性影响的研究

以N2与H2的混合气为反应气，和三氧化钼进行多段程序升温反应，制得一种β晶型的氮化钼。以噻吩为模型化合物的常压加氢脱硫反应表明，β-Mo2N0.78具有较强的加氢脱硫活性和强的抗硫化性能。同时考察了预还原、反应温度以及氮化末温、升温速率、反应气中N2-H2比及氮化时间等制备参数对β-Mo2N0.78加氢脱硫活性的影响。研究发现，β-Mo2N0.78的加氢脱硫活性在320 ℃～400 ℃随反应温度的升高增强，而还原预处理会降低催化剂的活性。氮化末温、氮化时间、反应气组成和升温速率等制备参数对催化剂的活性有明显的影响：随着氮化末温的升高，所制备的催化剂催化加氢脱硫活性降低；在氮化末温恒温较长时间，可以引起制备催化剂的加氢脱硫活性下降；存在最佳的反应气组成和各段升温速率。小晶粒的β-Mo2N0.78具有强的加氢脱硫活性。     

A Novel Cu-Mo／ZSM-5 Catalyst for NOx Catalytic Reduction with Ammonia

The Cu-Mo/ZSM-5 catalysts with different Cu/Mo ratios were prepared by wet impregnation method, and their catalytic performance for selective catalytic reduction of NOx was studied. The results showed that Cu-Mo/ZSM-5 is a very effective catalyst for NOx catalytic reduction with ammonia, especially when Cu/Mo molar ratio is about 1.5. It not only exhibited the extremely high catalytic activity, but also showed good stability for 02. The bulk phase structure of Cu-Mo/ZSM-5 catalysts was determined by XRD technique, and the results indicated that there is a maximum dispersion for Cu species when Cu/Mo molar ratio is 1.5, and an interaction between Cu and Mo along with HZSM-5 may be present in Cu-Mo/ZSM-5, which may possibly result in a special structure favorable for the catalytic reduction of NOx over Cu-Mo/ZSM-5 catalyst.     

钙羧酸钠褪色光度法测定微量碘的研究

提出了以钙羧酸钠褪色光度法测定微量碘的新方法。在盐酸介质中 ,表面活性剂十六烷基三甲基溴化铵 (CTMAB)存在下 ,碘酸根离子定量氧化钙羧酸钠褪色。最大吸收波长λmax=5 95nm ,表观摩尔吸光系数ε =3.1× 10 4 L·mol-1·cm-1。碘浓度在 0～ 5 0 μg 2 5ml范围内服从比耳定律。方法用于加碘食盐中碘的测定 ,结果满意     

用钼酸盐和罗丹明B连续光度法测定铈和钪

聚乙烯醇存在下，铈或钪钼杂多酸与罗丹明Ｂ（ＲＢ）形成离子缔合物，最大吸收均位于５７０ｎｍ，摩尔吸光系数分别为１．１６×１０＾６和５．６２×１０＾５Ｌ．ｍｏｌ＾－１．ｃｍ＾－１，ｃｍ＾－１，０－１．２μｇ／２５ｍＬＣｅ和０－２．０μｇ／ｍＬＳｃ服从比耳定律，检测限１．５ｎｇ／ｍＬＣｅ（ｎ＝１０）和１．１ｎｇ／ｍＬＳｃ（ｎ＝９）。缔合物的摩尔比为Ｃｅ：ｍＯ：ＲＢ＝１：６：３和 Ｓｃ：Ｍｏ：ＲＢ＝１：１     

Selective Oxidation of Isobutene over CsFeCoBiMnMoOx Mixed Oxide Catalyst

Mixed oxide catalyst Cs0.1Fe2Co6BiMnMo12Ox was prepared by the coprecipitation method.Selective oxidation of isobutene was carried out in a fixed-bed reactor over Cs0.1Fe2Co6BiMnMo12Ox.The results showed that the catalyst had high catalytic activity. Under the optimum reaction conditions(n(i-C4):n(O2)=1:2-1:4, space velocity=180 h^-1, T=360℃), the yields of methacrolein and methacrylic acid can reach 80% and 8%, respectively. The total yield of liquid products (methacrolein, methacrylic acid and acetic acid) can reach about 90%.     

MOLECULAR ENGINEERING STUDIES ON NONTHROMBOGENIC BIOMATERIALS——A NOVEL CLASS OF NONTHROMBOGENIC BIOMATERIALS WITH ZWITTERIONIC STRUCTURE OF CARBOXYBETAINES

N,N-dimethyl-N-methacryloyloxyethyl-N-carboxyethyl ammonium (DMMCA) was graft-copolymerized onto the surface of segmented poly(ether urethane) (SPEU) and PE film. The carboxybetaine structure on SPEU and PE film surfaces was confirmed by ATR-FTIR, XPS and water contact angle measurements. Through the experiments with platelet adhesion and protein adhesion assay in vitro, the two materials studied, including poly-DMMCA gel, all show excellent nonthrombogenicity. This confirms once again that the zwitterionic molecular structure on the surfaces of materials is essential for improving their nonthrombogenicity and biocompatibility.