掺杂两种荧光染料的有机红光电致发光器件

制作了掺杂rubrene和4-(dicyanomethylene)-2-t-butyl-6-(1,1,7,7-tetramethyljulolidyl-9,enyl)-4H-pyran(DCJTB)两种荧光染料的红光有机电致发光器件。N,N’-diphenyl-N,N’-bis(1-naphthyl)-(1,1’-biphenyl)-4,4’-diamine(NPB)和掺杂的Tri-(8-hydroxyquinoline)aluminum(Alq3)分别作为空穴和电子传输层。我们发现掺rubrene和DCJTB的器件性能与只掺DCJTB的器件性能相比有所提高。器件性能的改善是因为掺入的rubrene能够促进从Alq3到DCJTB的能量转移。根据荧光衰减曲线,计算出从Alq3到DCJTB、从Alq3到rubrene以及从rubrene到DCJTB的能量转移速率分别为1.04×109,3.89×109,2.79×109s-1。可以看出能量通过rubrene从Alq3到DCJTB的转移速率是能量直接从Alq3到DCJTB的2.7倍。     

Nano-tribological study on a super-hydrophobic film formed on rough aluminium substrates

A novel super-hydrophobic stearic acid (STA) film with a water contact angle of 166^o was prepared by chemical adsorption on aluminum wafer coated with polyethyleneimine (PEI) film. The micro-tribological behavior of the super-hydrophobic STA monolayer was compared with that of the polished and PEI-coated Al surfaces. The effect of relative humidity on the adhesion and friction was investigated as well. It was found that the STA monolayer showed decreased friction, while the adhesive force was greatly decreased by increasing the surface roughness of the Al wafer to reduce the contact area between the atomic force microscope (AFM) tip and the sample surface to be tested. Thus the friction and adhesion of the Al wafer was effectively decreased by generating the STA monolayer, which indicated that it could be feasible and rational to prepare a surface with good adhesion resistance and lubricity by properly controlling the surface morphology and the chemical composition. Both the adhesion and friction decreased as the relative humidity was lowered from 65% to 10%, though the decrease extent became insignificant for the STA monolayer. The project supported by the National Natural Science Foundation of China (50375151, 50323007, 10225209) and the Chinese Academy of Sciences (KJCX-SW-L2)     

密封容器中后处理制备Tl2Ba2CaCu2Oy高温超导薄膜及其性能研究

以铝酸镧（001）单晶为基片，采用两步法制备Tl2Ba2CaCu2Oy（Tl 2212）高 温超导薄膜.首先，利用脉冲激光沉积（PLD）工艺沉积Ba2CaCu2Ox非晶前驱体薄膜；然后，前驱体薄膜在高温（720—850℃）下密封钢容器里铊化结晶形成Tl 2212薄膜.XRD结果表明Tl2212 薄膜是沿c轴方向生长的，其相组成为Tl 2212，摇摆曲线（0012）的半高宽为0.72° ，SEM图像显示其表面光滑平整，其零电阻温度为106.2K. 关键词： Tl 2212超导薄膜 脉冲激光沉积     

光子晶体反常色散超窄带滤波理论

讨论了利用由反常色散材料构成的二维（2D）光子晶体(PCs)实现超窄带滤波（PCADOF）的原理，并对铯原子蒸气6P3/2←6S1/2谱线的反常色散曲线进行了研究，讨论利用此反常色散曲线通过2D PCs实现超窄带滤波的方法和特点，研究发现这种滤光器的带宽可达到0.002nm，这将为设计一种全新的滤波器提供指导. 关键词： 反常色散 光子晶体 超窄带滤波     

Kirchhoff方程的相对常值特解及其Lyapunov稳定性

对于超细长弹性杆静力学的Kirchhoff方程，用动力学的概念和方法研究其常值特解 和稳定性问题.计算了Kirchhoff方程相对固定坐标系、截面主轴坐标系以及中心线Frenet 坐标系的常值特解，进行了Kirchhoff动力学比拟，用一次近似理论分别讨论了它们的Lyapu nov稳定性，导出了若干稳定性判据，并在参数平面上绘出了稳定域. 关键词： 超细长弹性杆 Kirchhoff方程 常值特解 Lyapunov稳定性     

Zn(BTZ)2白色有机电致发光材料的合成及其器件制备

以PCl₃为脱水剂,将邻氨基硫酚与水杨酸脱水环化合成出2-(2-羟基苯基)苯并噻唑,并进一步将所得产物与乙酸锌反应合成出2-(2-羟基苯基)苯并噻唑螯合锌(Zn(BTZ)₂)材料。以该配合物作为发光层制备出结构为ITO/PVK:TPD/Zn(BTZ)₂/Al近白色电致发光器件,其色坐标位于白场之内(x=0.242,y=0.359),在驱动电压为16V时,亮度达3200cdm²,对应的量子效率为0.32%。进一步在Zn(BTZ)₂中掺入橙红色染料Rubrene,制成ITO/PVK:TPD/Zn(BTZ)₂:Rubrene/Al结构器件,实现了纯白色发光(色坐标值:x=0.324,y=0.343),非常接近于白色等能点,且量子效率达0.47%。最后对上述器件的发光和电学性能进行了深入的研究和探讨。     

调节层状分子基磁体[NO2BzQ1][FeRuxFe（1-x）（ox）3]的合成与磁性研究

合成了组成不同的一类新的层状分子基磁体[NO2BzQ1][FeRuxFe(1-x)(ox)3]，并测定了它们的变温磁化率，结果显示，磁体磁性随着Ru^Ⅲ／Fe^Ⅲ比例的不同而发生变化。     

Theoretical Study on the Long-lived Complexes for the Na＋I2 Collision System

For the Na I2 collision system, theoretical study is performed on the QCISD(T) level by using ab initio method. The ab initio potential energy surfaces are got and on them the long-lived complexes are found and optimized. These results verify the crossed molecule beam experimental phenomenon and the detailed geometry structures are given for the first time. The role of the complexes in the reaction path is also described in detail.     

The First Intramolecular Charge Transfer Transition Based on 2-Ureido-4[1H]-pyrimidinone Binding Module

The first intramolecular charge transfer transition based on 2-ureido-4[1H]-pyrimidinone binding module was reported.     

164Lu的三轴超形变核态的研究

利用TRS方法对双奇核¹⁶⁴Lu的位能面进行了计算,确认了¹⁶⁴Lu核的一条三轴超形变带,结果与实验较好地符合,同时指出了三轴超形变带的一个具体的组态