Alkali metal cation doping of metal-organic framework for enhancing carbon dioxide adsorption capacity

Metal-organic frameworks （MOFs） have attracted much attention as adsorbents for the separation of CO2 from flue gas or natural gas. Here, a typical metal-organic framework HKUST-I（also named Cu-BTC or MOF-199） was chemically reduced by doping it with alkali metals （Li, Na and K） and they were further used to investigate their CO2 adsorption capacities. The structural information, surface chemistry and thermal behavior of the prepared adsorbent samples were characterized by X-ray powder diffraction （XRD）, thermo-gravimetric analysis （TGA） and nitrogen adsorption-desorption isotherm analysis. The results showed that the CO2 storage capacity of HKUST-1 doped with moderate quantities of Li＋, Na＋ and K＋, individually, was greater than that of unmodified HKUST-1. The highest CO2 adsorption uptake of 8.64 mmol/g was obtained with 1K-HKUST-1, and it was ca. 11% increase in adsorption capacity at 298 K and 18 bar as compared with HKUST- 1. Moreover, adsorption tests showed that HKUST-1 and 1K-HKUST-1 displayed much higher adsorption capacities of CO2 than those of N2. Finally, the adsorption/desorption cycle experiment revealed that the adsorption performance of 1K-HKUST-1 was fairly stable, without obvious deterioration in the adsorption capacity of CO2 after 10 cycles.     

SnS2/GCP(石墨烯复合粉末)微米复合材料作为锂离子电池负极材料的电化学性能

以石墨烯复合粉末为添加剂,采用一步水热法制备了一种SnS₂/GCP微米复合材料。在所得到的复合材料中,SnS₂纳米片相互缠绕组成多孔球状SnS₂颗粒,石墨烯复合粉末均匀的包裹在球状SnS₂颗粒表面。将所制备的SnS₂/GCP微米复合材料用作锂离子电池负极材料测其电化学性能。结果显示,在0.1 A·g^-1的电流密度下可逆比容量为795.6 mAh·g^-1,循环100次后比容量损失不到1%。相比于SnS₂其比容量和循环稳定性得到了明显改善,主要是由于石墨烯复合粉末的加入,不仅缓解了SnS₂颗粒在充放电过程中的团聚和体积膨胀,而且还提高了SnS₂颗粒的电导率。     

巯基乙酸锑(Ⅲ)配合物合成与晶体结构

以三氧化二锑和巯基乙酸在水溶液中反应合成了配合物HSb(SCH2COO)2,并通过元素分析、红外光谱、X射线粉末衍射进行了表征,利用单晶X射线四圆衍射法测定了晶体结构,结果表明该配合物晶体属于单斜晶系,C2/c空间群,晶胞参数为:a=1.40005(8)nm,b=1.19121(8)nm,c=1.23588(8)nm,β=126.822(1)°,V=1.6499(2)nm^3,Dc=2.439g·cm^-3,Z=8,R1=0.0250。并对X射线粉末衍射数据进行了指标化,其结果与单晶数据吻合。     

X-射线荧光光谱法(XRF)测定钼精矿中多种元素

详细论述了压片法及熔融片法测定钼精矿的分析条件。其中压片法通过大量采用同一矿区的生产样品经化学定值后作为校准样品建立校准曲线,因此粒度效应和矿物效应基本上可忽略。详细地讨论了元素之间谱线干扰、背景和脉冲高度选择。使用经验系数法校正基体效应,可准确测定钼精矿中的钼、硫、铁、铜、铅、锌等11种元素。在熔融片法中主要讨论了元素谱线的选择及其相互之间的干扰,经理论α系数校正后,可准确测定不同钼矿中的多种元素,其适用范围更广。     

洗涤时pH值对纳米级β-Ni(OH)2的团聚程度和电化学性能的影响（英文）

Nano-scale nickel hydroxide was prepared by precipitate transformation method in the paper. Effect of rinse pH on the agglomeration degree and electrochemical performance of nano-scale Ni (OH)2 was investigated. The measurement results of XRD and TEM indicate that the prepared nano-scale Ni (OH)2 is β (II)-phase, the grain size is in the rang of 10 ～ 50nm, and rinse pH exerts a great influence on the agglomeration degree of nano-scale Ni(OH) 2.The agglomeration of material becomes very obvious when rinse pH = 11, and the density of nano-scale Ni(OH)2 is enhanced obviously. Cyclic voltammetry(CV) and simulate cells experiment show that nano-scale Ni(OH)2 with suitable agglomeration degree have better electrochemical CV performance than those with ideal disperse Ni (OH)2and micron Ni(OH)2, and its proton diffusion coefficient is also the highest. It can elevate the discharge potential platform and prolongs discharge time, so the utilization ratio of Ni (OH)2 is raised.``     

自催化还原制备微米和纳米级空心镍球的研究

提出了一种新型的制备超细空心金属镍粉的方法.通过FESEM,TEM和XRD衍射对该制备方法进行了研究,并考察了有关工艺参数对产物粒径和粒度分布的影响.研究认为,通过在胶核表面发生自催化还原反应,形成金属镍壳,同时胶核发生自分解,最后可得到空心金属镍球.控制反应物浓度和NaOH的配比可得到粒径均匀的镍球;通过调整这两个参数可得到粒度在微米或纳米尺度的空心镍球.     

Li2+2xZn1-xSiO4水基溶胶-凝胶法合成及其离子导电性

用水基溶胶凝胶法制备了锂离子导体Li_2+2xZn_1-xSiO₄(0≤x≤0.5)。实验中对干凝胶的热稳定性进行了TG-DTG分析。XRD谱结果表明形成了与Li₃PO₄结构相关的固溶体Li_2+2xZn_1-xSiO₄。TEM结果则显示晶粒尺寸为50nm左右,并应用交流阻抗谱技术进行了样品烧结体的电性能测试。     

红外吸收法测定碳化铪粉末中的氧含量

应用氧氮分析仪建立碳化铪粉末中氧的测定方法。针对碳化铪熔点极高的特性,对加热功率、称样量和空白值等测定条件进行探讨,选择适合的助熔剂和高温石墨坩埚,确定了最佳测试条件。将该方法用于实际样品测定,测定结果的相对标准偏差小于2.0%(n=9),样品的加标回收率为98.1%～102.6%。     

锂离子电池爆喷失效后残留粉末的研究

由电池挤压试验机得到不同荷电状态的电池爆喷失效后的残留粉末.经称量、水溶解和X射线衍射(XRD)测试,结果表明,随着电池荷电状态的提高,单位能量升高,电池燃烧温度上升和持续时间延长,其铜箔完好程度逐渐降低,粉末残余量逐渐减少.依据水溶解实验可将残留粉末分为不溶粉末和可溶粉末2种,其中不溶粉末较多,主要成分有C、Co和CoO;可溶粉末较少,主要成分有Li2CO3和LiF.随着电池荷电状态的提高,不溶粉末含量逐渐减少,而可溶粉末含量逐渐增多.     

LiInS_2多晶原料的合成与性能(英文)

本文研究了高纯LiInS2多晶原料的合成及性能。LiInS2晶体是一种极具吸引力的晶体,可以应用于红外区域的非线性光学频率变换。一般来说,含锂硫族化合物制备非常困难,因为锂极易被氧化,且腐蚀石英管。而且,硫族元素高的蒸气压会导致石英安瓿爆炸。本文采用两种方法合成了LiInS2多晶原料,对所获LiInS2多晶原料进行了X射线粉末衍射和差示扫描量热分析。