Solutions for a Mode Ⅲ Growing Crack in a Piezoelectric Plane Under Two Kinds of Electric Boundary Conditions ＊

The solutions for a mode Ⅲ crack growing along an arbitrary propagation path in a piezoelectric plane are studied under the impermeable surface condition and the electrical contact surface condition respectively. According to the two kinds of electric boundary conditions, the Hilbert and Riemann boundary value problems in a half-plane including opening smooth arc are obtained from the theoretical analysis. Moreover, the equipollence of the solution formed under these two electric boundaries is proved, and unified solutions for the stress and electric displacement distribution in the crack-tipfield of the piezoelectric plane are achieved.     

High—Efficiency Organic Double—Quantum—Well Light—Emitting Devices Using 5,6,11,12—Tetraphenylnaphthacene Sub—monolayer as Potential Well

The double-quantum-well organic light-emitting devices of indium-tin-oxide (ITO)/NPB (50nm)/rubrene (0.05nm)/NPB (4nm)/rubrene (0.05nm)/Alq3 (50nm)/LiF (0.5nm)/Al were fabricated, in which N,N-bis-(1-naphthyl)-N,N‘-diphenyl-1,1‘-biphenyl-4,4‘‘‘‘‘‘‘‘-diamine (NPB) is used as a barrier potential or hole transport layer, tris (8-hydroxyquinoline) aluminium (Alq3) used as electron transport layer, and 5,6,11,12-tetraphenylnaphthacene (rubrene) as a potential well and emitter. The brightness can reach 18610cd/m^2 at 13V. The maximum electroluminescent efficiency of the device was 6.61cd/A at 7V, which was higher than that of common dope-type devices. In addition, the electroluminescence efficiency is relatively independent of the drive voltage in the range from 5 to 13V.     

Stopband Phenomena in the Passband of Left-Handed Metamaterials

Stopband phenomena are reported in the passband of left-handed metamaterials. The samples with linear defect are designed by removing one layer of split ring resonators （SRRs）. It is shown that the left-handed transmission peaks have a distinct transform with the relative deviation of the SRRs centre from the wire centre 8, from a single left-handed peak, double left-handed peaks with different magnitude to no transmission peak, i.e. left-handed properties of metamaterials disappear. Numerical simulation shows that the change of 8 makes the effective permeability shift at a frequency range, where stopband occurs. It is thought that the stopband in left-handed passband is due to the symmetry breaking between SRRs and wires in the metamaterials.     

Nd掺杂的Bi4Ti3O12变温X射线衍射分析

利用变温X射线衍射技术，在预烧过程中分析了Nd掺杂Bi4Ti3O12后生成Bi3.15Nd0.85Ti3O12（BNT）相的形成过程以及微结构的变化．实验观察到以30℃／min的升温速率，BNT相在700℃时开始形成，其衍射峰强度随温度的继续升高而增强，衍射峰半高宽随烧结时间延长而减小．X射线衍射分析结果表明，在900℃恒温条件下，烧结约2h，可形成单一的BNT相．     

各向异性接合材料界面端部场数值分析

为了求解各向异性接合材料界面端部奇异性应力场,建立了一种新型杂交元模型.该模型的独特之处在于:基于有限元特征法得到的奇异性场数值特征解建立了一种新型界面端奇异单元.通过算例证明,新型杂交元模型能够利用较少的单元数获得较为精确的数值结果.当前模型应用范围广泛,能够用于复杂结构的界面端部场求解.     

铁电体表面效应的唯象理论及其与横场Ising模型的关系

分析了铁电体横场Ising模型与Landau唯象理论的关系,得出了有表面的铁电体的Landau自由能表达式,指出原有的表达式中面积分部分仅含与极化平方成正比的项只在特殊情况下成立,一般情况下还应包含与极化四次方成正比的项.利用所得出的自由能表达式,计算了铁电薄膜自发极化和Curie温度与厚度的关系,使原先用唯象理论不能理解的一些实验现象得到了解释     

"热核"的统计特性和核物质液气相变

用含温度推广的Thomas-Fermi模型讨论了"热核"和核物质的激发能、熵和自由能等热力学函数的温度依赖特性.确定了有限温度下核物质的状态方程,并进而计算了液气相变的临界温度及其对核物质不对称度的依赖关系.     

光学双稳性临界点的相变行为

本文详细地讨论了光学双稳性(OB)的临界现象。理论分析主要以忽略量子涨落的Fokker-Plank方程的静态解为基础。结果发现,OB的临界现象可以纳入Landau二级相变理论的框架,并且有关临界指数之间的关系也服从标度律。 关键词：     

喷雾干燥-高温固相法制备纳米LiFePO4与LiFePO4/C材料及性能研究

采用喷雾干燥-高温固相法制备纳米LiFePO₄与LiFePO₄/C正极材料，用X-射线衍射，扫描电镜等对合成材料进行了表征，并对以LiFePO₄为正极的电池进行了电化学性能测试。结果表明:材料合成最佳煅烧温度为600 ℃;合成过程中由于碳对LiFePO₄晶型的生长有一定的抑制作用，相对于纯LiFePO₄材料，LiFePO₄/C材料粒径更小;并且，在此最佳合成温度下合成的LiF     

纳秒激光闪光光解装置功能扩展──有机非线性材料二阶非线性系数测定

纳秒级激光闪光光解装置可用于有机光化学、光物理过程，瞬态发光和吸收的动力学过程的研究，在不改变原装置整体布局和结构的基础上，建立了有机非线性光学材料的二阶非线性系数测定方法，并为国家８６３专家委员会承担过仲裁测定。