碳纳米管添加剂对质子交换膜燃料电池低铂载量膜电极性能的影响研究

以碳纳米管（CNT）作为低铂载量膜电极（CCM）催化层（0.1 mg_Pt·cm^-2）添加剂，研究了CNT的添加方式对催化层微观结构以及膜电极性能的影响.结果表明，与常规低铂载量催化层相比，在其表面喷涂一层CNT或将CNT均匀分散到Pt/C催化层中均有利于提升低铂载量膜电极的输出性能，在70℃和100%相对湿度条件下最高输出功率比常规低铂载量膜电极的0.522 W·cm^-2分别提升了22.4%和60.0%，并且均匀分散添加方式优于分层添加方式.其原因在于分层添加CNT后改善了低铂催化层和气体扩散层之间的接触界面，降低了催化层与扩散层间的接触电阻，而均匀分散添加方式除了可降低界面接触电阻外，还显著改善了低铂催化层中的气体传输，大幅提升了Pt催化剂的利用效率，使得膜电极电化学反应电阻明显降低.进一步对均匀分散添加方式中CNT的载量进行优化，表明CNT添加量为37.5 μg·cm^-2时电池输出性能最佳，70℃和100%相对湿度条件下的最大输出功率达到0.91 W·cm^-2.本研究工作表明，将CNT均匀分散添加到催化层中是一种有效提升低铂载量膜电极性能的方法.     

DFT法研究离子液中EMIM+催化丁烯双键异构反应机理(II)

用密度泛函理论(DFT)在B3LYP/6-31G(d, p)的计算水平上研究了离子液中1-乙基-3-甲基咪唑阳离子(EMIM⁺)的4-H和5-H原子催化丁烯双键异构反应的可能途径，优化了反应体系的平衡态和过渡态的几何构型，分析了反应过程中键参数的变化，通过振动分析对平衡态和过渡态进行了验证. 计算结果表明, 离子液中的EMIM⁺首先通过4-H和5-H原子吸附丁烯, 进而催化丁烯的双键异构反应, EMIM⁺的4-H和5-H催化1-丁烯异构为2-丁烯的正反应活化能分别为204.2和207.3 kJ•mol^-1，逆反应活化能约为220.9和223.8 kJ•mol^-1， 反应为基元反应.     

氧化条件下NOx催化的甲烷均相部分氧化

考察了没有固体催化剂时NOx对甲烷气相氧化的促进作用.实验结果表明，即使在强氧化条件下（O2/CH4=5），NOx对甲烷部分氧化制一氧化碳仍然有明显的催化活性.在CH4-O2体系中加入0.005％～0.2％的NO后，反应温度可降低200-300 ℃.在反应产物中还可观察到甲醛和乙烯，通过改变反应条件可以控制它们的相对浓度.     

Experimental and Theoretical Study of the Effect of Moisture on Methane Adsorption and Desorption by Activated Carbon at 273.5 K

Adsorption and desorption of methane by activated carbon (AC) at constant temperature and at various pressures were investigated. The effect of moisture was also studied. A volumetric method was used, up to 40 bar, at a temperature of 273.5 K. Results of a dry AC sample were compared with those obtained from a moist sample and two different ACs with different physical and surface properties were used. As expected, the results showed that the existence of moisture, trapped in the AC pores, could lead to a decrease in the amount of methane adsorbed and a decrease in the amount of methane delivered during desorption. To model the experimental results, a large variety of adsorption isotherms were used. The regressed parameters for the adsorption isotherms were obtained using the experimental data generated in the present study. The accuracy of the results obtained from the different adsorption isotherms was favorably compared.     

喹乙醇的合成

喹乙醇的合成张维汉，李瑞声，李开颜，邓一军，谭桂利（中山大学化学系，广州，５１０２７５）关键词：喹乙醇，合成，相转移催化使用含有饲料添加剂的混合饲料，既节省粮食，又能提高畜牧产品的质量，因此发展高效无毒的多功能饲料添加剂很有意义。喹乙醇（Ｏｌａｑｕｉ...     

混合三烃基锡衍生物的研究：X.甲基二环己基锡二硫代磷酸酯的合成及生…

合成了１０种甲基二环己基锡－Ｏ，Ｏ－二烃基二硫代磷酸酯，利用ＩＲ，ＮＭＲ，ＭＳ及元素分析确证了化合物的结构，生物活性测试结果表明，这类化合物具有较高的杀螨和除草活性。     

SiO2—Al2O3和MgO催化剂上吸附CH3NO2的TPD和IR研究

用TPD和IR方法研究了CH_3NO_2在典型固体酸SiO_2-Al_2O_3和固体碱MgO催化剂上的吸附分解。结果表明,在SiO_2-Al_2O_3表面CH_3NO_2吸附转化为表面甲酰胺物种,后者在高温下分解为CO_2和NH_3。在MgO表面CH_3NO_2吸附形成多种表面化学物种,它们在升温过程中脱附,并通过表面亚硝基甲烷物种分解为NO、C_2H_4、C_2H_6和N_2O.讨论了CH_3NO_2分解过程中表面酸、碱中心的作用。     

1-(4-硝基苯)-3-(3-甲基吡啶)-三氮烯合成及其与铜的显色反应

报道了新显色剂 1-(4-硝基苯)-3-(3-甲基吡啶)-三氮烯(NPMPDT)的合成及其与铜的显色反应.在OP的存在下,pH 10.5的Na2B4O7-NaOH缓冲溶液中,该试剂能与铜发生显色反应,铜与NPMPDT形成摩尔比为2∶1型的黄色配合物,在460 nm处有一最大正吸收,在535 nm 处有一最大负吸收.以460 nm为参比波长,535 nm为测量波长进行双波长测定,其表观摩尔吸光系数ε＝2.18×105 L·mol-1·cm-1,铜的质量浓度在0～0.48 μg/mL 范围内符合比尔定律,用本法测定大米和面粉中微量的铜,结果满意.     

The Effect of Nb Loading on Catalytic Properties of Ni/Ce0.75Zr0.25O2 Catalyst for Methane Partial Oxidation

In this study,the effect of Nb loading on the catalytic activity of Ce_(0.75)Zr_(0.25)O_2-supported Ni catalysts was studied for methane partial oxidation.The catalysts were characterized by BET,H_2 chemisorption,XRD,TPR,TEM and tested for methane partial oxidation to syngas in the temperature range of 400-800℃at atmospheric pressure.The results showed that the activity of methane partial oxidation on the catalysts was apparently dependent on Nb loading.It seemed that the addition of Nb lowered the catalytic activity for methane partial oxidation and increased the extent of carbon deposition. This might be due to the strong interaction between NiO and Nb-modified support and reduction of surface oxygen reducibility.     

烯烃氢甲酰化反应研究进展

本文综述了烯烃氢甲酰化反应的催化剂从钴配合物到铑配合物和从均相催化体系到两相催化体系的发展过程。比较了三种催化剂和两个催化体系的特点、应用情况及研究工作进展.