多组分烟用香精定量分析方法的研究进展

综述了近年来烟用香精、香料各组分化合物的定量分析方法的研究进展。面积归一化法、内标法、外标法和标准加入法等常用色谱定量分析方法主要用于烟用香精、香料中目标化合物或单个组分的测定;多标定量法、特征峰-内标定量法和多元校正法能深入剖析烟用香精复杂体系中各组分含量(引用文献48篇)。     

三维荧光结合二阶校正法测定绞股蓝中槲皮素含量

采用三维荧光并结合二阶校正的平行因子分析(PARAFAC)算法、交替三线性(ATLD)算法和自加权交替三线性(SWATLD)算法对中药绞股蓝中的槲皮素含量和回收率进行测定,Al(Ⅲ)作敏化剂增加槲皮素的荧光强度。核一致检验法说明体系中荧光组分数为2,其中一个组分对应于槲皮素,另一个对应于中药中的一个共存组分。3种方法测定中药绞股蓝中槲皮素的含量分别为0.274 9%,0.272 9%和0.272 7%,回收率分别为96.3%,103.1%和96.8%,得到的槲皮素解析光谱和真实光谱几乎完全重合。实验结果表明,化学计量学"二阶校正"法具有简单、快速、高效及操作费用低等特点,可用于复杂成分的定性和定量分析。同时,还讨论了中药溶液中内滤光效应对荧光强度及定量分析的影响,并采用数学校正法对中药溶液的内滤光效应进行校正,实验发现测定的荧光强度用相应的溶液吸光度校正后,定量分析结果的准确度大大改善。     

PbTiO3/SrTiO3(010)异质界面上的周期性失配位错及电子富集

It is important to determine the effects of misfit dislocations and other defects on the domain structure, ferroelectricity, conductivity, and other physical properties of ferroelectric thin films to understand their ferroelectric and piezoelectric behaviors. Much attention has been given to ferroelectric PbTiO₃/SrTiO₃ or PbZr_0.2Ti_0.8O₃/SrTiO₃ heterointerfaces, at which improper ferroelectricity, a spin-polarized two-dimensional electron gas, and other physical phenomena have been found. However, those heterointerfaces were all (001) planes, and there has been no experimental studies on the growth of (010) PbTiO₃/SrTiO₃ heterointerface due to the 6.4% misfit between two materials. In this study, we selected an atomically flat (010) PbTiO₃/SrTiO₃ heterointerface grown using a two-step hydrothermal method as the research subject, and this is the first experimental report on that interface. Interfacial dislocations can play a significant role in causing dramatic changes in the Curie temperature and polarization distribution near the dislocation cores, especially when the size of a ferroelectric thin film is scaled down to the nanoscale. The results of previous studies on the effects of interfacial dislocations on the physical properties of ferroelectric thin films have been contradictory. Thus, this issue needs to be explored more deeply in the future. This study used aberration corrected scanning transmission electron microscopy (STEM) to study the atomic structure of a (010) PbTiO₃/SrTiO₃ heterointerface and found periodic misfit dislocations with a Burgers vector of a[001]. The extra planes at the dislocation cores could relieve the misfit strain between the two materials in the [001] direction and thus allowed the growth of such an atomically sharp heterointerface. Moreover, monochromated electron energy-loss spectroscopy with an atomic scale spatial resolution and high energy resolution was used to explore the charge distribution near the periodic misfit dislocation cores. The fine structure of the Ti L edge was quantitatively analyzed by linearly fitting the experimental spectra recorded at various locations near and at the misfit dislocation cores with the Ti³⁺ and Ti⁴⁺ reference spectra. Therefore, the accurate valence change of Ti could be determined, which corresponded to the charge distribution. The probable existence of an aggregation of electrons was found near the a[001] dislocation cores, and the density of the electrons calculated from the valence change was 0.26 electrons per unit cell. Based on an analysis of the fine structure of the oxygen K edge, it could be argued that the electrons aggregating at the dislocation cores came from the oxygen vacancies in the interior regions of the PbTiO₃. This aggregation of electrons will probably increase the electron conductivity along the dislocation line. The physics of two-dimensional charge distributions at oxide interfaces have been intensively studied, however, little attention had been given to the one-dimensional charge distribution. Therefore, the results of this study can stimulate research interest in exploring the influence of the interfacial dislocations on the physics of ferroelectric heterointerfaces.     

双贴合无光焦度校正板在双球面镜次镜后的系统的像差特性研究

讨论了双贴合无光焦度校正板放在次镜后的双反射球面系统.根据像差理论分析了消像差的条件,研究了主镜的相对孔径变化、校正板在次镜后的位置变化以及无光焦度校正板的正负透镜的不同组合形式对系统高级残余像差的影响.结果表明：当主镜的相对孔径增加或校正板靠近次镜时,系统的残余像差增加;无论校正板的第一个透镜是正透镜还是负透镜,系统在某一光焦度处残余像差最小,并且靠近次镜的透镜最好采用负透镜.     

模型传递用于解析遥感傅里叶变换红外谱图

基于模型传递的原理,建立了一种可对存在背景干扰,谱峰严重混叠的遥感傅里叶变换红外(remote sensing Fourier transform infrared: RS-FTIR)谱图进行解析的方法。分别用4组分气体混合物的EPA红外标准谱图和RS-FTIR谱图,建立校正和预测模型,经过正交信号校正(OSC)处理后,用EPA红外谱图数据所建立的校正模型,对RS-FTIR谱图数据进行预测,得到的丙酮、甲醇、苯和三氯甲烷的均方根预测误差(RMSEP)分别为：0.008 5,0.018 0,0.064 0,0.002 8。未经OSC处理时的RMSEP依次是0.085 6,0.047 9,1.065 3,0.014 2。经优化,支集选择的方法为Kennard-Stone法,OSC在实现过程中循环次数为3时得到的预测结果最好。研究结果表明,该方法能够克服背景和校正模型给RS-FTIR监测大气污染物带来的制约。     

厚胶光刻非线性畸变的校正

利用厚胶光刻技术制作大深度微结构元件是一种有效的途径,但厚胶光刻过程中的非线性畸变对光刻面形质量的严重影响限制了该技术的应用,基于此,提出了一种对掩模透射率函数进行校正的方法。分析空间像形成及其在光刻胶内传递、曝光、显影等过程中非线性因素的影响,利用模拟退火算法对掩模透射率函数进行校正,以提高光刻面形质量,并以凹面柱透镜为例,给出了校正前后的显影轮廓模拟结果,其校正后浮雕面形的体积偏差仅为2.63%。该方法在有效改善面形质量的同时,并没有引起掩模的设计、制作难度及费用增加,这对于设计、制作高质量的微结构元件有重要意义。     

多元分辨校正模型与方法研究—无机多组份分析

系统研究了各种多元分辨校正模型、方法及其应用，以模拟体系、病态体系有态体系为对象，考察了它们的多元校正能力与多元分辨效果，给我机多组份分析态体系实例。     

液相色谱-三重串联四极杆质谱测定粮油中的黄曲霉毒素

建立了超声提取-液相色谱-电喷雾三重串联四极杆质谱测定玉米、大米、大豆等粮油固体样品中黄曲霉毒素B1、B2、G1和G2(AFB1、AFB2、AFG1和AFG2)的方法。分析前对样品进行超声提取,优化得到最佳超声提取条件: 溶剂为甲醇-水(含40 g/L NaCl) (80:20, v/v)溶液、料液比为1:3(g:mL)、温度为50 ℃、时间为3 min。然后对提取的样品进行免疫亲和特异性净化。最后与液相色谱-电喷雾三重串联四极杆质谱联用,使用C18反相色谱柱,流动相为甲醇-10 mmol/L乙酸铵水溶液梯度洗脱,以黄曲霉毒素M1(AFM1)作为内标进行定量测定。结果表明,AFB1、AFB2、AFG1和AFG2的检出限分别为0.002、0.004、0.004和0.012 μg/kg。方法的加标回收率为87%～111%,日内相对标准偏差(RSD)和日间RSD分别不大于6.7%和5.6%。实验结果表明该方法可以有效地降低基质效应的影响,相比于外标法能极大地提高方法的准确度。     

氢火焰离子化检测器校正因子的理论计算

根据FID检测器工作原理，提出一种相对质量校正因子的计算公式。由该公式出发可以推导出相对摩尔响应值（RMR）与化合物碳数的线性关系式和有效碳数的近似计算方法，并赋予原计算方法中的参数以明确的含意，解决了参数之间的矛盾。新方法的计算值同文献数据吻合良好。     

S_2OF_(10)气体标准样品制备方法和测定方法研究

提出了一系列的安全、方便、可靠、在线和可连续操作的热解吸／色谱分析柱制备Ｓ２ＯＦ１０纯品、指数稀释法配制Ｓ２ＯＦ１０标准样品、应用定量校正系数测定样品中痕量Ｓ２ＯＦ１０的方法和技术。分别采用气相色谱、红外光谱、气相色谱／质谱等方法对色谱制备的Ｓ２ＯＦ１０纯品进行了纯度分析和测定。配制Ｓ２ＯＦ１０标准气体的体积分数范围为８．０×１０－７～２．６×１０－４。气相色谱测定Ｓ２ＯＦ１０的定量校正系数为０．１９７,测定方法的相对误差范围为１．８％～２０％。