Mn-Cu合金成分对去合金化法制备纳米多孔铜的影响

 采用电弧熔炼制备出前驱体Mn-Cu合金,在稀盐酸溶液中自由腐蚀去合金化,制备出具有双连续结构的纳米多孔铜。研究了前驱体合金的成分对纳米多孔铜微观结构及Mn的选择性腐蚀程度的影响。结果表明：前驱体Mn-Cu合金的Cu原子分数为43%时,其去合金化受到抑制,存在明显的未完全去合金化的岛状结构;前驱体Mn-Cu合金的Cu原子分数为32%～23%时,可完全去合金化,形成平均孔径尺寸为20～100 nm,平均系带尺寸为30～80 nm,具有双连续结构的纳米多孔铜;前驱体Mn-Cu合金的Cu原子分数低至20%时,去合金化后存在大量裂纹,形成纳米颗粒聚集体。纳米多孔铜中存在少量的残余Mn,残余Mn的原子分数随着前驱体合金Mn原子分数的增高而降低。实验表明腐蚀液浓度对纳米多孔铜形貌也存在影响。     

近红外消偏振分光膜设计近红外消偏振分光膜设计

大角度倾斜入射时,光学薄膜表现出强烈的偏振效应。入射光S分量和P分量的反射率和透射率曲线,以及反射或透射引起的两个分量的相位变化都不再相同,彼此有一定的偏振分离。通过对产生偏振效应内在原因的分析,采用一个在近红外波段对于45倾斜入射光的S分量和P分量等效导纳非常接近的膜系结构,结合单纯形法优化算法,设计得到一个1 500～1 600 nm范围内反射率都是50％的近红外消偏振分光膜。结果显示,在45入射时,S分量和P分量的反射率曲线偏振分离小,反射和透射引起的相位变化也控制在很小范围。     

无沸腾喷雾冷却技术的研究进展

文中简述了无沸腾喷雾冷却技术近年来国内外的研究进展。着重介绍了关于影响无沸腾区换热各参数的实验研究,如壁面温度、介质体积通量、喷雾流量、喷雾倾角和喷雾高度等,为寻求最佳换热提供了指导。并对无沸腾区的理论研究内容进行了归纳,主要是模拟不同喷雾条件下的换热过程及特性参数(如液膜厚度)的大小和分布,并将理论值与实验数据进行比较分析;总结了影响无沸腾区换热的喷雾特性参数和外部特性。     

宽光谱膜厚监控系统中光谱实时测量技术研究

 在宽光谱膜厚监控系统中,利用光栅光谱仪分光,线阵CCD接收,完成光谱的一次性快速扫描来控制膜层厚度,达到实时监控的要求。而系统光谱扫描的准确性,直接影响膜厚实时监控的有效性。为了得到准确的光谱信息,首先确定CCD像素和光波波长的对应关系,基于特征谱线的离散关系,采用最小二乘拟合法建立了光谱标定函数,经实验,标定波长均方根误差为0.037 nm;对于CCD实时输出的光谱监控信号,利用小波阈值优化算法抑制信号中的随机噪声,保留了光谱信号的细节成分,峰值误差的最大值为1.0%,峰位误差的最大值为0.3%,满足了监控中光谱分辨率的要求。     

Short range order transformation and magnetostriction of Fes3Ga17 ribbons

The relationship between magnetostriction and structure of melt-spun Fes3Ga17 ribbons are investigated by XRD and M5ssbauer spectrum technique （MS）. As the heat-treatment temperature increases from 650℃ to 800℃, the magnetostriction coefficient of Fes3Ga17 ribbon first increases and then decreases. The largest magnetostriction coeiffcient （-578.4 ppm） is achieved in those specimens quenched at 750oc. According to the XRD and MSssbauer spectrum anal- ysis, a small quantity of DO3 phase is precipitated in Fe83Ga17 ribbons when quenched from 650℃ and the DO3 phase is gradually transformed into B2-1ike phase if quenched at higher temperature. However, both DO3 and B2-1ike phases disappear when the temperature increases up to 800℃. From this point of view, B2-1ike phase might be beneficial to the enhancement of magnetostrictive properties of melt-spun ribbons.     

Ti-doped nano-porous graphene: A material for hydrogen storage and sensor

Clustering of Ti on carbon nanostructures has proved to be an obstacle in their use as hydrogen storagematerials. Using density functional theory we show that Ti atoms will not cluster at moderate concentrations when doped into nanoporous graphene. Since each Ti atom can bind up to three hydrogen molecules with an average binding energy of 0.54 eV/H₂, this material can be ideal for storing hydrogen under ambient thermodynamic conditions. In addition, nanoporous graphene is magnetic with or without Ti doping, but when it is fully saturated with hydrogen, the magnetism disappears. This novel feature suggests that nanoporous graphene cannot only be used for storing hydrogen, but also as a hydrogen sensor.     

Progress in improving thermodynamics and kinetics of new hydrogen storage materials

Hydrogen storage material has been much developed recently because of its potential for proton exchange membrane (PEM) fuel cell applications. A successful solid-state reversible storage material should meet the requirements of high storage capacity, suitable thermodynamic properties, and fast adsorption and desorption kinetics. Complex hydrides, including boron hydride and alanate, ammonia borane, metal organic frameworks (MOFs), covalent organic frameworks (COFs) and zeolitic imidazolate frameworks (ZIFs), are remarkable hydrogen storage materials because of their advantages of high energy density and safety. This feature article focuses mainly on the thermodynamics and kinetics of these hydrogen storage materials in the past few years.     

激光制备类金刚石膜技术研究

现有技术制备的类金刚石(DLC)膜由于含氢、硬度低、内应力大、附着力差等特点,严重限制了其光学工程应用.激光法是近年发展的一种制备DLC膜的新方法,相比其他制备方法具有诸多优点.综合分析了激光制备DLC膜过程中,激光波长、脉宽、功率密度、衬底温度和偏压等因素对薄膜质量的影响规律.采用氧气氛辅助沉积、元素掺杂和双波长激光...     

多孔硅制备的二维光子晶体生长过程监控

采用单槽电化学腐蚀法在预置有倒金字塔结构的n型单晶硅上制备用于二维光子晶体的多孔硅。利用基于LabVIEW的虚拟仪器技术对实验仪器编程,搭建实时测控系统,实现对反应过程中所需电源的控制,并且实时显示采集到的随时间变化的电压和电流信号,将采集的数据存储在计算机里。实验表明,恒电流供电模式下致使电压剧烈变动,导致多孔硅侧向...     

Pr0．45（Ca1-xSrx）0．55MnO3体系调带宽引起的磁相变及电输运性质转变

采用固相法制备了Pr0．45（Ca1-xSrx）0．55MnO3（x=0．0,0．2,0．4,0．6,0．8,1．0）多晶样品．通过测量样品的X射线衍射（XRD）谱、磁化强度-温度（M～T）曲线、电阻率-温度（ρ～T）曲线,研究了Sr^2＋替代Ca^2＋对Pr0．45Ca0．55MnO3体系磁性和电性的影响．实验发现：...