机械泵驱动两相回路的储液器控温策略研究

本文阐述了一种机械泵驱动两相回路的储液器的控温原理,并对待选的两种控温策略进行了解释:一种是基于电压的PI控制,另一种是基于功率的PI控制。文中将它们作了近似等效转换,并用SINDA/FLUINT软件进行模拟。结果显示:当控温点上升时,两种不同控制策略的控温效果大体一致;但当控温点下降时,由于基于功率的PI控制策略包含有Peltier的制冷功能,可以比基于电压的PI控制策略更快到达控温点。另外,基于功率的PI控制策略在死区内的跳跃更少,其应当为优先选择的控制策略。     

快放电直线型变压器驱动源磁芯脉冲损耗特性

建立了快脉冲磁芯损耗特性测试平台,对比研究了50 m的DG6硅钢和25 m的2605TCA非晶两种材料磁芯损耗特性;采用一种新的特征参量(磁芯单位面积上激磁电压陡度)来规范磁芯的激磁电压条件,使得实验结果与快放电直线型变压器驱动源实际工作条件下磁芯性能具有可比性;通过测量初级漏电流及次级开路电压,获得了相同激磁条件下两种磁芯等效损耗电阻的大小,50 m 的DG6硅钢磁芯损耗约为25 m的2605TCA非晶磁芯损耗的4倍;计算了两种材料磁芯总损耗中涡流损耗所占的比例,50 m的DG6硅钢磁芯涡流损耗占总损耗的75%,25 m的2605TCA非晶磁芯涡流损耗占总损耗的28%。     

Determination of elastic, piezoelectric, and dielectric constants of an R:BaTiO3 single crystal by Brillouin scattering

From the sound velocity measured using the Brillouin scattering technique, the elastic, piezoelectric, and dielectric constants of a high-quality monodomain tetragonal Rh：BaTiO3 single crystal are determined at room temperature. The elastic constants are in fairly good agreement with those of the BaTiO3 single crystal, measured previously by Brillouin scattering and the low-frequency equivalent circuit methods. However, their electromeehanical properties are significantly different. Based on the sound propagation equations and these results, the directional dependence of the compressional modulus and the shear modulus of Rh：BaTiO3 in the （010） plane is investigated. Some properties of sound propagation and electromechanical coupling in the crystal are discussed.     

Cu对Ni50Mn36In14相变和磁性的影响

文章研究了Cu替代部分Ni对铁磁性形状记忆合金Ni₅₀Mn₃₆In₁₄相变和磁性的影响规律. 研究表明,在Ni_50-xCu_xMn₃₆In₁₄中,随着Cu含量的增加,相变温度逐渐降低. Cu含量低于5%时,奥氏体的磁性强于马氏体的磁性, 母相和马氏体相的饱和磁化强度的差值ΔM随着Cu含量的增加而增大. 当Cu含量x=4.5时, ΔM迅速增加到80 emu/g, 并在该材料中观察到了磁场驱动的马氏体到奥氏体的转变,显示了该材料作为磁驱动磁电阻材料的潜在应用前景.当Cu含量高于5%时,奥氏体保持铁磁状态, 马氏体相由反铁磁状态变为铁磁状态,马氏体的磁性强于奥氏体的磁性, ΔM大大削弱,磁场驱动性质消失.     

Ohmic Radio-Frequency Synergy Current Drive and Transformer Recharging Experiments in the HT-7 Tokamak

Lower hybrid current drive (LHCD) experiments for investigating the interaction between lower hybrid (LH) wave and residual dc electric field were performed in extensive plasma parameter ranges in the HT-7 superconducting tokamak. The experimental results are well fitted to the Karney-Fisch theory on the efficiency of LH waves energy converted to poloidal magnetic field energy. The fraction of absorbed LH power is about 0.75 for the HT-7 machine, and the upshift of the LH-wave parallel refraction index during LHCD experiments have been derived by the optimizing fitting parameters. The LH wave is also used for the transformer recharging when the plasma current is maintained unchanged. The highest efficiency about 7% has been achieved in HT-7 machine.     

压电陶瓷压电特性的激光调制法测量研究

介绍可测量压电陶瓷压电特性的激光干涉调制测量方法.采用相干检测原理对信号进行提取,不仅可以抑制噪声对干涉信号的影响,而且还可以大大降低光电探测器和电路的1/f噪声.与通常干涉仪测量方法相比,这种方法具有测量灵敏度高等优点.利用该方法对压电陶瓷压电特性进行了测量,讨论了激励电压信号的频率、幅度对压电陶瓷压电常数d₃₁的影响,并对其压电迟滞曲线进行了测量.     

ADS系统中少錒系核素的灵敏度分析

为了确定加速器驱动系统中少錒系核素的核数据的不确定性对此系统中积分参数的影响, 选择一铅 铋冷却次临界系统来进行分析, 选择不同的微观评价库CENDL 3.0 , JENDL 3.2及ENDF/B VI.6, 并只考虑20 MeV以下的中子产额, 来计算次临界系统的积分参数. 以ENDF/B VI.2 库的计算结果作为参考结果, 依次用CENDL 3.0库及JENDL 3.2库中相应的錒系核素替换ENDF/B VI.6 库中的錒系核素, 计算了次临界系统的Keff值及反应率, 并就变换主要錒系核素时对所计算的Keff值及反应率的影响进行了分析、 比对. 在堆芯处, 当改变錒系核素时Keff值总的变化为30%, CENDL 3.0的238Pu的弹性散射反应率比ENDF/B VI 库的结果高出10%, ENDF/B VI 库的242Am的裂变率超过了CENDL 3.0库的15%. In order to investigate the effect of minior actinide data on integral parameter, the accelerator driven minior actinide benchmark system was selected in this work. The library based on ENDF/B VI.2 was used for the reference calculation. The sensitivities were examined by exchanging the minior actinides of CENDL 3.0 and JENDL 3.2 one after another. The Keff values and reaction rates were calculated. According to the comparisons, the difference in Keff from the refrence is more than 3‰, and the fission reaction rate of 242Am is about 15% lower than those of reference results. The elastic scattering reaction rate of 238Pu of CENDL 3.0 is about 10% larger than those of ENDF/B VI.     

离心力场下H2O和R12热驱动换热特性实验研究

本文实验研究了离心力场下细微封闭循环通道中,以H2O和氟利昂R12为热驱动介质的热驱动流动规律和换热特性,重点分析了热驱动换热效果随Ra数Ro数的变化规律以及冷却效果。实验结果表明:在热流密度和旋转速度相同的条件下,采用介质R12可以获得较高的平均换热系数,冷却效果也优于以H2O为介质的冷却效果。最后建立了两种介质条件下相应的准则关系式。     

双波荡器自由电子激光理论

给出了双波荡器自由电子激光器的通用理论.在双波荡器自由电子激光器中,引入了一个周期长度非常接近主波荡器中电子束感应加速振荡周期的附加波荡器.推导出了一套自治方程组描述双波荡器中自由电子激光场演变过程,并分别给出了低增益、高增益和饱和三种情况下的解析解.研究表明,适当选择附加波荡器的参数,可以提高自由电子激光器的增益或转换效率     

北京大学高平均流强光阴极电子枪驱动激光系统

DC-SC超导光阴极注入器将直流光阴极电子枪和超导加速腔结合在一起,其特点之一是适合于提供高平均流强电子束.文中介绍了直流光阴极电子枪的驱动激光系统的研制.该驱动激光系统的主机为瑞士TBP公司的GE-100-XHP型激光器,是采用可饱和吸收镜技术的被动锁模激光器,其工作晶体为Nd:YVO₄,输出波长为1064nm,脉冲重复频率为81.25MHz,平均功率10W.该驱动激光系统配套的CLX-1100同步控制器可以将激光脉冲与射频参考信号严格锁定,随机抖动不大于1ps.根据使用要求,作者研制了高效的激光倍频器,获得了大于1W的266nm紫外激光.同时,激光到光阴极的传输设计中,采用了傅立叶光学技术,在紫外激光功率650mW左右的条件下,从自行研制的Cs₂Te光阴极上实现了大于500μA的光电流引出