Lu2O3：Tb纳米粉末的光致发光特性

用燃烧合成法制备了Lu₂O₃:Tb³⁺纳米粉末。产物为立方相结构,粒径在3~40nm之间可控。对不同颗粒度的样品的激发光谱、发射光谱和荧光衰减特性进行了研究。在紫外光激发下,样品显示出较强的发光(来自于Tb³⁺的⁵D_3,4→⁷F_J跃迁)。同时,样品的光致发光性质在很大程度上受到样品颗粒度的影响,对此现象给出了合理的解释。     

Acta Matehmatica Sinica

Submission Please type your paper in LaTeX, and e-mail the pdf file. The editorial office will confirm receipt within 3 days. If you do not receive the receipt letter, please send an e-mail to ask. The address is Editorial Board, Acta Mathematica Sinica （English Series）, Institute of Mathematics, Chinese Academy of Sciences, Zhongguancun, Beijing 100190, China, ernail： ActaMath@amss.ac.cn.     

The influence of SiNx substrate on crystallinity of μc-Si film used in thin film transistors

This paper found that the crystalline volume ratio （Xc） of μc-Si deposited on SiNx substrate is higher than that on 7059 glass. At the same silane concentration （SC） （for example, at SC=2%）, the Xc of μc-Si deposited on SiNx is more than 64%, but just 44% if deposited on Conning 7059. It considered that the ‘hills＇ on SiNx substrate would promote the crystalline growth of μc-Si thin film, which has been confirmed by atomic force microscope （AFM） observation. Comparing several thin film transistor （TFT） samples whose active-layer were deposited under various SC, this paper found that the appropriate SC for the μc-Si thin film used in TFT as active layer should be more than 2%, and Xc should be around 50%. Additionally, the stability comparison of μc-Si TFT and a-Si TFT is shown in this paper.     

Blue-Green Light Emission from a-SiCx：H-Based Fabry-Perot Microcavities

A Si-based novel Fabry-Perot microcavity device that can emit blue-green light at room temperature is proposed and fabricated, One of its Bragg reflectors consists of periodically stacked a-SiO2/a-Si：H layers deposited on the glass by plasma enhanced chemical vapour deposition, The other reflector is a sputtered Al film, The active region between both the reflectors is constructed by a p-type a-SiCx：H/intrinsic-type a-SiCx ：H junction fromwhich the electroluminescence （EL） is originated. The EL spectra of this device are recorded by RENISHAW RM2000, a sharp and strong EL peak at 483nm with FWHM of 20nm is observed when the device is driven by dc voltages of 8 V, 12 V and 18 V at room temperature. The intensity of EL increases with the applied voltage while the luminescence wavelength keeps unchanged. Compared with the EL spectra from the sample without the Bragg reflector, the luminescence intensity is about 10 times enhanced and the peak is narrowed greatly. The luminescence mechanism is analysed in detail.     

红色长余辉材料Mg2SiO4：Dy3+,Mn2+的制备及发光特性

用高温固相法制备了长余辉发光材料Mg₂SiO₄:Dy³⁺,Mn²⁺,对这种材料的红色长余辉性质进行了研究.对以不同掺杂浓度单掺杂Mn²⁺、单掺杂Dy³⁺以及双掺杂Dy³⁺,Mn²⁺的Mg₂SiO₄体系,通过在紫外激发下的发射光谱及其激发光谱的研究,确认了在双掺杂体系中,峰值为660nm的发光带对应着Mn²⁺的⁴T₁(⁴G)→⁶A₁(⁶S)跃迁,Mn²⁺为主要发光中心.Mn²⁺的660nm发射的激发谱分布很宽,样品在近紫外和可见光区都有良好的吸收,长波边可达600nm,是这种材料的一个显著优点.还研究了双掺杂体系中Dy³⁺对Mn²⁺的660nm发光带的敏化作用.另外,通过对单掺杂、双掺杂体系热释光曲线的比较,揭示了双掺杂体系中Dy³⁺的陷阱作用.     

A 4.8-W M^2 = 4.6 Continuous-Wave Intracavity Sum-Frequency Diode-Pumped Solid-State Yellow Laser

A yellow continuous wave with beam quality M^2= 4.6 and output power of 4.8 W at 589nm is generated by intracavity sum-frequency mixing of 1064 nm and 1319 nm radiations of a Nd：YAG laser. To achieve high beam quality at high power, thermally near-unstable flat-flat resonators with two-rod birefringence compensation are designed to obtain the large fundamental mode size inside the Nd：YAG rods and the same beam width inside the KTP crystal. The optimal intracavity power ratio of both 1064nm and 1319nm beams is also considered. The output power fluctuation of the yellow laser remains less than 5% in four hours.     

YAG：Ce^3＋荧光粉的合成及α-Al2O3籽晶对相形成的促进作用

用聚丙烯酰胺凝胶法来合成YAG：Ge^3＋荧光粉，用XRD对煅烧过程粉体的结构进行了跟踪测定。结果发现，当直接煅烧凝胶时，可观察到θ-Al2O3，YAM和YAP等中间相的形成，而当煅烧含有α-Al2O3，YAM和YAP的形成，加速其与Y203的反应而在较低温度下直接生成YAG相。合成YAG：Ce^3＋荧光粉的发射峰为处于550nm的宽峰，其激发光谱有两个主要的吸收峰，主峰位于460nm，可以与GaN LED的蓝色发射相匹配而用于白光LED的组装。一些助熔剂可以提高荧光粉的光致发光特性，这归因于助熔剂对YAG结晶过程的改进作用和对YAG：Ce^3＋中三价铈离子的稳定作用。     

掺杂型BaFBr:Eu2+的热释发光性质的研究

BaFBr:Eu^2 是利用色心存储电子－空穴对并用可见光激励读出存储信息（产生Eu^2 的4f^65d→4f^7的跃迁）的优良的光激励发光材料。通过热释发光技术研究了BaFBr:Eu^2 的热激活行为，对其低温段和高温段的热释发光峰分别进行了归属，通过对BaFBr:Eu^2 以及掺杂Na^ 或Al^3 的BaFBr:Eu^2 的热释发光（TL）谱和光激励发光（PSL）谱的表征，指出在BaFBr:Eu^2 中掺杂Na^ 或Al^3 影响了F（Br^-）色心，使其陷阱深度变涛，并从理论上加以计算，得出的热致激发能量的变化与光致激光能量的变化能很好地吻合。     

液体相位共轭技术应用于高重复频率双通放大器实验

固体激光器运转过程中工作物质的热效应严重地影响着激光器的输出光束质量，20世纪60年代末Ostcrink等从理论和实验上研究了Nd：YAG晶体产生的热效应，相位共轭镜技术能够补偿热效应造成的波前畸变，从而改善了激光器的光束质量。液体相位共轭镜大多数采用了CS2、丙酮、CCL4、SnCL4、HPLCll3（氟里昂）等液体，由于丙酮液体的相对污染少，SBS阈值功率密度低，且市场上容易购买，因而得到普遍运用。文中报道了在重复频率400Hz，脉宽20ns的二极管泵浦Nd：YAG双通放大激光器中用丙酮液体作为相位共轭镜改善光束质量的实验研究。激光器SBS实验光路采用聚焦光斑在液体池里扫描和不扫描两种方式。