Yb:FAP和Yb:C_3S_2-FAP晶体光谱的温度特性和选择激发

报导了Yb :FAP和Yb :C3S2 _FAP晶体在不同温度下的吸收光谱和荧光光谱实验结果 ,研究发现由于电子_声子近共振耦合作用 ,Yb :FAP和Yb :C3S2 _FAP晶体均存在有明显的振动谱 ,Yb :FAP晶体的零声子线在低温下还劈裂为相差 10cm- 1 的两条线 .采用激光选择激发技术研究了Yb3 离子在FAP和C3S2 _FAP晶体中的格位特征 ,结果表明Yb3 离子在这两种基质中都只占据Ca(Ⅱ )格位 ,但由于CaF2 的挥发 ,导致了Ca(Ⅱ )格位的局部畸变 .     

光纤光栅选频掺Yb3+双包层光纤激光器

利用相位掩模法 ,在D形内包层掺Yb3 双包层光纤一端直接写制出Bragg光栅 ,用作双包层光纤激光器的输出腔镜 .试验得到了线宽为 0 196nm ,波长为 10 5 8 2nm ,最高输出功率为 5 70mW的稳定激光输出 ,解决了激光器中模式竞争造成的输出不稳定现象 .从速率方程出发 ,对激光器的输出功率与抽运功率、光栅反射率的关系以及最佳光纤长度进行了理论分析 ,结果与实验符合很好     

Cl/HN3/I2全气相化学激光体系的化学动力学模拟计算

 对Cl/HN₃/I₂产生NCl(a)/I激光的过程进行了化学动力学计算，主要考察了Cl,HN₃和I₂的初始粒子数密度及其配比对小信号增益系数的影响。结果发现,当温度为400K, 初始Cl粒子数密度为1×10¹⁵，1×10¹⁶和1×10¹⁷cm^-3时,小信号增益系数分别达到1.6×10^-4,1.1×10^-3和1.1×10^-2cm^-1，获得最佳小信号增益系数的HN₃和I₂的初始粒子数密度分别为初始Cl粒子数密度的1～2倍和2%～4%。同时，对Cl，HN₃和I₂配比对小信号增益系数和增益持续时间的影响进行了讨论。     

横向射流式单重态氧发生器的性能实验研究

 对氧碘化学激光器的单重态氧发生器（SOG）进行了改进，采用横向射流方式，并对该横向射流式单重态氧发生器的性能进行了检测。实验中过氧化氢碱溶液温度控制在－16℃左右,氯气流量为530mmol/s，He与氯气的流量比为3;采用PS法测量单重态氧分子的产率,吸收法测量氯气的利用率和相对水含量。得出如下结论:在不使用冷阱和分离器的情况下，最高单重态氧分子产率达到58%, 氯气利用率在80%以上,相对水含量小于等于0.5;气体达到最大流量时,发生器仍然能稳定地工作。     

Synthesis and characterization of N-3-phenyl-2-propenoyl amino acids

Three N-3-phenyl-2-propenoyl amino acids were synthesized through interaction between 3-phenyl-2-propenoyl chloride and amino acids in alkaline with a high Yield.Structure of the products were identified by elemental analysis,IR and NMR spectroscopy.     

Acetalation and Ketalation Catalyzed by SO42-/TiO2-MoO3

The catalytic activities of SO42-/TiO2-MoO3 in synthesizing cyclohexanone ethylene ketal,cyclohexanone 1,2-propanediol ketal, 2-propyl-1,3-dioxolane, 4-methyl-2-isopropyl-1,3-dioxolane,2-isopropyl-1,3-dioxolane, 4-methyl-2-isopropyl-1,3-dioxolane, butanone ethy-lene ketal and butanone 1,2-propanediol ketal were reported. It has been demonstrated that SO42-/TiO2-MoO3 is an excellent catalyst. Various factors concerned in this reaction have been investigated. The optimum conditions have been found, that is, the molar ratio of aldehyde/ketone to alcohol was 1:1.5 or 1:1.3,the mass ratio of the catalyst used to the reactants was 0.25～1.5%, and the reaction time was 45～60 min. Under this conditions, the yield of cyclohexanone ethylene ketal is 82.7%, cyclohexanone 1,2-propanediol ketal is 83.4%, the yield of 2-propyl-1,3-dioxolane is 68.1%,4-methyl-2-isopropyl-1,3-dioxolane is 87.5%, the yield of 2-isopropyl-1,3-dioxolane is 70.7%,4-methyl-2-isopropyl-1,3-dioxolane is 82.5%, the yield of butanone ethylene ketal is 74.1%, and butanone 1,2-propanediol ketal is 94.9%.Some equation and experiment results concerned of the synthetic acetals or ketals were listed as follows.     

Synthesis of 2-Acyl-2H-1,2,3-diazaphospholes and Their Diels-Alder Reaction with Cyclopentadiene

2H-1,2,3-Diazaphospholes 3a-3h were prepared from various ketone acylhydrazones and phosphorus trichloride in the presence of triethylamine. Compounds 3 underwent feasible hetero-Diels-Alder reactions with cyclopentadiene to afford the respective anellated [1,2,3]diazaphospholes 4a--4d as well as 4a‘--4d‘ in moderate yields. The endo rule in the reaction was observed under kinetic control conditions.     

Regioselective Synthesis of Multi-substituted Phenylselenomethyl Isoxazolines

A mild, regioselective 1, 3-dipolar cycloaddition protocol for the preparation ofphenylselenomethyl isoxazolines through substituted allyl phenyl selenides and nitrile oxides wasreported.     

Solid Phase Synthesis of 2-Substituted 1,3-Oxazin-6-ones Using Resin-bound Cyclic Malonic Acid Ester

A facile solid phase synthesis of 2-substituted 1,3-oxazin-6-ones using polymer-supported Meldrum‘s acid has been reported. Reaction of the resin-bound cyclic malonic acid ester with triethyl orthoformate and subsequent double substitution with amide, afforded the corresponding polymer-supported acylaminomethylene cyclic malonic acid ester, which upon thermal treatment led to 1, 3-oxazin-6-ones in good yields and with high purity.     

Nd~(3+):YAG激光的光纤传输

首先叙述了光纤传输Nd~(3+): YAG激光的优点,接着分析了不同光纤和其传输Nd~(3+): YAG激光的特点。然后通过对光纤传输系统各部分的分析与设计,结合实际,设计了光纤耦合机构。最后,对来自于工件反射光问题提出了解决方案。