Gas chromatographic system equipped with a mass detector and a selective nitrogen-phosphorous detector operating simulataneously in the analysis of pesticide residues

The possibility to perform gas chromatographic analysis using both a mass detector and a selective nitrogen-phosphorous detector will enable highly sensitive analytical results and an optimal identification reliability. In this work we describe an easily workable technical solution, which has been accomplished in our laboratory and the application of the above system to analytical procedures for the detection and determination of nitrogenous herbicides in drinking water and phosphorylated pesticides in agricultural products is discussed.     

Ion-exchange method for separation and concentration of platinum and palladium for analysis of environmental samples by inductively coupled plasma atomic emission spectrometry

An ion-exchange procedure is proposed for determination of Pt and Pd in environmental samples, using a Dowex 1-X10 anion-exchange resin. Pt and Pd were separated from the matrix elements in the sample by selective retention on the column as anionic chloro complexes and subsequent elution by circulated thiourea at 60 °C. The eluent, containing Pt and Pd was analyzed by inductively coupled plasma (ICP) atomic emission spectrometry (AES). Average recoveries of 98% and detection limit of 15 ng/g for both metals were achieved. Analysis of Pt and Pd concentrations in road dust, sampled from several sites in Germany was performed. The comparison of the obtained data with the concentrations of Pt and Pd in the same samples, determined by ICP-MS showed a very good agreement.     

Biosensors for environmental pollutants and food contaminants

This review article provides an overview of the most recent literature on biosensors for environmental pollutants and food contaminants. Due to the large number of publications, only papers published between 2000 and January 2003 were considered. Also, while not all of the published literature could be reviewed here, over 200 references are cited to provide a good overview of research undertaken in the last two years. Older publications are covered by a number of earlier review articles. This article provides an introduction into the field including specific consideration of the application areas, describes the typical biosensor assay format used, and is subsequently structured according to the biorecognition elements used (i.e., nucleic acids, enzymes, whole cells, tissue and whole organisms, antibodies and receptors, and biomimetic materials). In addition, a section on microbiosensing systems is provided. Since only very few microbiosensors with applications in environmental and food systems have been published, enabling technology is also covered in this article.Abbreviations BOD biological oxygen demand - cfu colony forming units - DNP dinitrophenol - GFP green fluorescent protein - NASBA nucleic acid sequence-based amplification - PCR polymerase chain reaction - ppt parts per trillion - QCM quartz crystal microbalance - SPR surface plasmon resonance     

Organically modified sols as pseudostationary phases for microchip electrophoresis

We demonstrate that the selectivity of microchip electrophoresis separations is greatly improved by the presence of organically modified silica (Ormosil) sols in the run buffer. A negatively-charged N-(trimethoxysilylpropyl)ethylenediamine triacetic-acid (TETT)-based sol is used for improving the selectivity between nitroaromatic explosives and a methyltrimethoxysilane (MTMOS)-based sol is employed for enhancing the microchip separation of environmental pollutants, aminophenols. These sols are added to the run buffer and act as pseudostationary phases. Their presence in the run buffer changes the apparent mobility of studied solutes, and leads to a higher resolution. The observed mobilities changes reflect the interactions between the Ormosil sols and the solutes. Relevant experimental variables have been characterized and optimized. The diverse chemistry of Ormosil sols should be extremely useful for tailoring the selectivity of a wide range of electrophoresis microchip separations.     

Synthesis and Characterization of Ag2S Nanocrystals in Hyperbranched Polyurethane at Room Temperature

Ag₂S nanoparticles in hyperbranched polyurethane matrix were prepared through the in situ reaction with thioacetamide as the sulfur source at room temperature. Transmission electron microscopic analysis revealed a uniform spherical shape for Ag₂S nanoparticles, with an average size of about 4-10 nm and a narrow size distribution. X-ray powder diffraction and UV-vis spectroscopy were also used to characterize the obtained nanoparticles     

Uniform Rice-like CdS Particles Prepared from Water-in-oil Microemulsions

IntroductionNano-sized semiconductors are of great interestdue to their special optical and electronic proper-ties[1,2].As one of the mostimportantⅡ—Ⅵsemicon-ductors,CdS has importantapplications in many fields,such as the solar cell field,non linear o…     

Fast solid-phase extraction-gas chromatography-mass spectrometry procedure for oil fingerprinting. Application to the Prestige oil spill

A rapid and simple fractionation procedure using solid-phase extraction (SPE) cartridges was developed for an accurate determination of aliphatic and polycyclic aromatic hydrocarbons in petroleum residues and further application in chemical fingerprinting of oil spills by gas chromatography-mass spectrometry (GC-MS). Among the adsorbents evaluated, SiO2/C3-CN exhibited the best selectivity, providing, by elution with n-hexane (4 ml) and n-hexane-CH2Cl2 (1:1) (5 ml), two well-resolved aliphatic and aromatic hydrocarbon fractions, with recoveries of 97 +/- 7.2 and 99.7 +/- 13.9%, respectively. The SPE fractionation procedure was compared with the conventional silica-alumina adsorption chromatography showing similar results but practical advantages in terms of reproducibility, analysis time, solvent reduction and cost. Moreover, is particularly suitable for routine analysis with a high sample throughput. The developed methodology was tested in the characterization of fuel-oil samples collected along the Spanish north-west coast, after the Prestige oil spill accident.     

Element-selective detection using capillary gas chromatography with atomic emission detection

Capillary GC coupled to an atomic emission detector (AED) provides a powerful new hyphenated technique for the separation and characterization of complex mixtures and compounds. The AED provides simultaneous and truly specific multi-element detection. The specificity of detection reduces the need for the complex sample pretreatment procedures which are necessary to reduce the interference from co-eluted substances which is experienced with detectors such as the FID and the ECD. A range of environmentally significant problems has been studied, including PCB analysis, the characterization of the reaction products of a novel waste treatment process, and the profiling of sulfur-containing species formed by the pyrolysis of various types of coal.     

Analysis of organic compounds in environmental samples by headspace solid phase microextraction

The analysis of samples contaminated by organic compounds is an important aspect of environmental monitoring. Because of the complex nature of these samples, isolating target organic compounds from their matrices is a major challenge. A new isolation technique, solid phase microextraction, or SPME, has recently been developed in our laboratory. This technique combines the extraction and concentration processes into one step; a fused silica fiber coated with a polymer is used to extract analytes and transfer them into a GC injector for thermal desorption and analysis. It is simple, rapid, inexpensive, completely solvent-free, and easily automated. To minimize matrix interferences in environmental samples, SPME can be used to extract analytes from the headspace above the sample. The combination of headspace sampling with SPME separates volatile and semi-volatile analytes from non-volatile compounds, thus greatly reducing the interferences from non-target compounds. This paper reports the use of headspace SPME to isolate volatile organic compounds from various matrices such as water, sand, clay, and sludge. By use of the technique, benzene, toluene, ethyl-benzene, and xylene isomers (commonly known as BTEX), and volatile chlorinated compounds can be efficiently isolated from various matrices with good precision and low limits of detection. This study has found that the sensitivity of the method can be greatly improved by the addition of salt to water samples, water to soil samples, or by heating. Headspace SPME can also be used to sample semi-volatile compounds, such as PAHs, from complex matrices.     

Surface status and size influences of nickel nanoparticles on sulfur compound adsorption

Metallic nickel nanoparticles were incorporated on mesoporous silica to remove sulfur compounds in diesel selectively. In the first method, nickel nanoparticles were formed on mesoporous silica SBA-15 by impregnation and subsequent reduction of nickel nitrate. The sulfur adsorption capacity was strongly dependent on the nickel loading and the average nickel particle size. In the second method, nickel nanoparticles were synthesized in solution in the presence of a capping agent and then incorporated in mesoporous silica MCF by sonication. Although these particles maintain their sizes on the MCF surface after heat treatment, capping agent remaining on the Ni particle surface might interfere the adsorption of sulfur compounds.