催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

High-density plasma etching of indium-zinc oxide films in Ar/Cl2 and Ar/CH4/H2 chemistries

The dry etching characteristics of transparent and conductive indium-zinc oxide (IZO) films have been investigated using an inductively coupled high-density plasma. While the Cl₂-based plasma mixture showed little enhancement over physical sputtering in a pure argon atmosphere, the CH₄/H₂/Ar chemistry produced an increase of the IZO etch rate. On the other hand, the surface morphology of IZO films after etching in Ar and Ar/Cl₂ discharges is smooth, whereas that after etching in CH₄/H₂/Ar presents particle-like features resulting from the preferential desorption of In- and O-containing products. Etching in CH₄/H₂/Ar also produces formation of a Zn-rich surface layer, whose thickness (∼40 nm) is well-above the expected range of incident ions in the material (∼1 nm). Such alteration of the IZO layer after etching in CH₄/H₂/Ar plasmas is expected to have a significant impact on the transparent electrode properties in optoelectronic device fabrication.     

CO_2 Reforming of CH_4 over Ni/CeO_2-ZrO_2-Al_2O_3 Prepared by Hydrothermal Synthesis Method

The Ni/CeO2-ZrO2-Al2O3 catalyst with different Al2O3 and NiO contents were prepared by hydrothermal synthesis method. The catalytic performance for CO2 reforming of CH4 reaction, the interaction among components and the relation between Ni content and catalyst surface basicity were investigated. Results show that the interaction between NiO and Al2O3 is stronger than that between NiO and CeO2-ZrO2.The addition of Al2O3 can prevent the formation of large metallic Ni ensembles, increase the dispersion of Ni, and improve catalytic activity, but excess Al2O3 causes the catalyst to deactivate easily. The interaction between NiO and CeO2 results in more facile reduction of surface CeO2. The existence of a small amount of metallic Ni can increase the number of basic sites. As metallic Ni may preferentially reside on the strong basic sites, increasing Ni content can weaken the catalyst basicity.     

稀土添加剂对烃类水蒸汽重整镍催化剂性能的影响——水蒸汽吸附的TPD研究

用程序升温脱附技术,研究了添加稀土的烃类水蒸汽重整催化剂(Ni/α-Al_2O_3)对水蒸汽的吸附性能,同未加稀土的镍催化剂作了对比。结果表明,加有稀土的镍催化剂对水蒸汽的吸附能力主要是稀土的贡献。还原态催化剂对水蒸汽的吸附量比相应的氧化态多1.4倍。发现催化剂对水蒸汽的吸附能力不仅取决于浸渍方式,而且同稀土含量有关。当稀土含量较多时,催化剂表面上呈现出三个能量不同的吸附位。稀土含量少于1.3%时。对提高催化剂吸附水蒸汽的能力已作用不大。含稀土的镍催化剂吸附水蒸汽的能力大,正是其抗结炭性能耐硫性能好的原因。     

Preparation and catalytic performance of superfine Ni/BaTiO3 catalyst

Superfine Ni/BaTiO₃ catalysts were prepared by impregnation method and used successfully for CO₂ reforming CH₄ to syngas. The effects of preparation method and the temperatures of calcination, reduction and reaction on the catalytic activity of the Ni/BaTiO₃ system were investigated. This revised version was published online in June 2006 with corrections to the Cover Date.     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

COMBINED PARTIAL OXIDATION AND CARBONDIOXIDE REFORMING OF METHANE PROCESS TO SYNTHESIS GAS

IntroductionIthasbccndcmonstratcdthatmcthancrcformingt"ithcarbondioxidcpr0ducessynthcsisgasrichincarbonmonoxidc-x"hichisuscfulforthcs}nthcsisofaccticacid'dimcthylcthcrando.o-alcoholsll'2].Carbondioxidcref0rmingismorccndothcrmicthanstcamrcformingfCH4 CO2,'2CO 2H2Ai/'2,,=2473kJ..ol-1(l)Accordingl\"thisrcact1onnccdshighcrtcmpcraturcandlimitsspaccvclocityoffccdgas,Wehavcprct'ious1\studicdmcthancrcformingt"lthC02inthcmonotubcproccssl3J.Inordertoconvcrtmcthancinfccdgascomplctcl}',thcspaccvcloci…     

Parametric study of catalytic reforming process?

Summary A parametric study of catalytic reforming process in a pilot plant was carried out by varying the pressure, H₂/HC ratio, and space velocity. The results show that lower aromatics and higher hydrogen yields can be accomplished by increasing the space velocity in existing reformers, which will also result in better C₅⁺yield.     

ZrO2在Cu-ZnO-ZrO2甲醇水蒸汽重整制氢催化剂中的作用

通过对一系列Cu-ZnO-ZrO2甲醇水蒸汽重整(SRM)催化剂的XRD、TEM和BET表征及催化性能测定,研究催化剂中ZrO2对催化剂粒径、比表面以及对SRM反应性能的影响.结果表明,ZrO2的加入,使催化剂的粒径从15 nm降至10 nm（其中CuO和ZnO的平均粒径分别从7.7和10.4 nm降至3.9和8.7 nm）,BET比表面从60 m2•g－1增至78 m2•g－1.随着催化剂含ZrO2量不同,甲醇的转化率和H2、CO2的选择性均产生变化,当催化剂中Zr含量为24.0％(w),反应温度为220 ℃,水、醇摩尔比为1.3时,甲醇的转化率达到51.6％, H2和CO2的选择性达到100％(CO和CH4在产物气体中的体积分数小于10－4),这一结果对甲醇燃料电池甲醇重整器的应用具有重要的意义.     

液化石油气水蒸气重整镍催化剂新型载体研究

以共沉淀法合成了硅铝系载体（AS和SA），并采用改性天然高铝石为原料合成了矿物质载体（MC-1和MC-2）,采用浸渍法合成了镍负载型催化剂。用常压固定床管式反应器，考察了液化石油气水蒸气重整反应活性，通过XRD、物理吸附等手段对催化剂进行了表征。结果表明，以MC-1、MC-2和SA、AS为载体的催化剂的水蒸气重整活性明显高于目前普遍使用的Ni/α-Al2O3催化剂。以SA为载体，负载5%镍的催化剂具有最好的水蒸气重整活性。在750 ℃，水碳比为2.0的条件下转化率达100％，C1选择性达94.46％。XRD分析结果表明1 300 ℃焙烧后的SA载体中存在α-Al2O3晶型和莫来石结构。硅、铝添加次序对水蒸气重整活性影响较大，硅-铝添加次序的催化剂样品的活性高于铝-硅添加次序的样品，C1选择性提高12.7％。