DFT Investigations of Aun Nano-Clusters Supported on TiO2 Nanotubes: Structures and Electronic Properties

TiO₂ nanotubes (TiO₂NTs) are beneficial for photogenerated electron separation in photocatalysis. In order to improve the utilization rate of TiO₂NTs in the visible light region, an effective method is to use Au_n cluster deposition-modified TiO₂NTs. It is of great significance to investigate the mechanism of Au_n clusters supported on TiO₂NTs to strengthen its visible-light response. In this work, the structures, electronic properties, Mulliken atomic charge, density of states, band structure, and deformation density of Au_n (n = 1, 8, 13) clusters supported on TiO₂NTs were investigated by DMOL3. Based on published research results, the most stable adsorption configurations of Au_n (n = 1, 8, 13) clusters supported with TiO₂NTs were obtained. The adsorption energy increased as the number of Au adatoms increased linearly. The Au_n clusters supported on TiO₂NTs carry a negative charge. The band gaps of the three most stable structures of each adsorption system decreased compared to TiO₂NTs; the valence top and the conduction bottom of the Fermi level come mainly from the contribution of 5d and 6s-Au. The electronic properties of the 5d and 6s impurity orbitals cause valence widening and band gap narrowing.     

Lane-Emden型微分方程数值解的Euler小波方法

提出了利用Euler小波方法求解带有Dirichlet,Neumann和Neumann-Robin型边界条件的一类Lane-Emden型微分方程数值解.借助Euler多项式解析形式,推导出Riemann-Liouville分数阶定义下Euler小波函数的分数阶积分计算公式.利用Euler小波配置法来将带有边界条件的Lane-Emden方程转为代数方程组,然后采用牛顿法进行求解,最后通过求解不同边界条件下的Lane-Emden方程,验证了Euler小波方法的准确性和有效性.数值计算结果与其他方法的计算结果和精确解进行了比较.     

Determination of protoapigenone in rat plasma by high‐performance liquid chromatography with UV detection and its application in pharmacokinetic studies

A simple and sensitive HPLC method using UV detection was developed to determine the concentration of protoapigenone in rat plasma. Chromatographic separation was conducted on a C₁₈ column with a mobile phase consisting of an acetonitrile–methanol–aqueous phase (containing 0.2% acetic acid, pH 3.0) system at a flow rate of 1.0 mL/min. The UV detector was set at 248 nm. The calibration curve was linear over the range of 0.031–10.0 µg/mL. The lower limit of quantification was 31 ng/mL. The recoveries for plasma samples ranged from 70.3 to 82.5%. The intra‐ and inter‐day accuracy and precision fulfilled the international standards. This method was successfully applied to a pharmacokinetic study of protoapigenone in rats after oral administration of protoapigenone. It was shown that protoapigenone could be absorbed rapidly after oral administration and could reach the maximum concentration within 1 h. Copyright © 2013 John Wiley & Sons, Ltd.     

A family of single‐isomer,dicationic cyclodextrin chiral selectors for capillary electrophoresis: Mono‐6A‐ammonium‐6C‐butylimidazolium‐β‐cyclodextrin chlorides

The first member of the single‐isomer, dicationic cyclodextrin (CD) family, 6^A‐ammonium‐6^C‐butylimidazolium‐β‐cyclodextrin chlorides (AMBIMCD), has been synthesized, analytically characterized, and used to separate a variety of acidic enantiomers and amino acids by CE. Starting from mono‐6^A‐azido‐β‐cyclodextrin, the cationic imidazolium and ammonium moieties were subsequently introduced onto primary ring of β‐cyclodextrin via nucleophilic addition and Staudinger reaction. The analytically pure AC regio‐isomer CD was further obtained via column chromatography. This dicationic CD exhibited excellent enantioselectivities for selected analytes at concentration as low as 0.5 mM, which were even better than those of its mono‐imidazolium or ammonium‐substitued counterpart CDs at 10 equivalent concentrations. The effective mobilities of all studied analytes were found to decrease with the concentration of AMBIMCD. Inclusion complexation in combination with eletrostatic interactions seemed to account for the enhanced chiral discrimination process.     

Study on the flow resistance of the dispersion system of deformable preformed particle gel in porous media using LBM-DEM-IMB method

After being injected into the porous media, the dispersion system of preformed particle gel (PPG) tends to enter high permeability regions and block water channeling passages, which forces the subsequent water to turn to the low permeability regions and thus increases sweep efficiency and enhances oil recovery. However, it is still unclear about the influence factors and the mechanisms how PPG increases water flow resistance, which limits the application of PPG in more oilfields. Therefore, the paper combines the lattice Boltzmann method (LBM), the discrete element method (DEM) and the improved immersed moving boundary (IMB) method to simulate the migration of deformable PPG in porous media. On the basis, the paper quantitatively analyzes the variation law of displacement pressure across the porous media and discusses the influence factors such as the PPG diameter, elasticity modulus and the number concentration. Results indicate that, because of the friction and retention of PPG in pore-throat, the displacement pressure across the porous media during PPG flooding is much higher than that during water flooding. In other words, the existence of PPG increases the flow resistance of injected water. Besides, the displacement pressure is always fluctuant resulting from the continuous process of PPG migration, retention, deformation and remigration. Influence factor analysis shows that the incremental value and fluctuation degree of flow resistance increase with the PPG diameter, elasticity modulus and the number concentration. The study not only provides useful reference for future PPG flooding, but also benefits the development of deformable particle flow theory.     

The behavior of technetium in technetium-scrubbing stage of PUREX process

Technetium decontamination factor as a function of the acidity, flow ratio, scrubbing stage number was investigated by counter-current cascade experiments or mixer-settler batch tests. Results showed that the acidity of the scrubbing acid has little influence on the decontamination factor of technetium when the acidity was kept in the range of 4.5–6 M. The most effective method to increase the decontamination factor is to lower the feed-to-acid flow ratio. Keeping other condition same the factor increased to 10.3 from 3.1 when feed-to-acid ratio changed to 4 from 5.6. The loss of uranium and plutonium can be recovered through a re-extraction technology.     

Relaxation dynamics of stretched polymer chains traced by shear induced Shish‐Kebab structure

We have developed a morphologic method to investigate the relaxation processing of the stretched polymer chains in melts, in which an atomic force microscope probe was used to shear the surface of an isotactic polypropylene melt to obtain the isolated shish‐kebab structure. We present the results of the time dependence of length of the isolated shish‐kebab structure and the stress dependence of the kebab density along the direction of shish in this paper. Our results demonstrate that the shear‐oriented polymer melts show the relaxation dynamics of worm‐like chain where the length deficit of the isolated shish‐kebab structure is scaled with the relaxation time as a power of 1/3. The melting behavior of shish‐kebab structure was also investigated. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2013, 51, 907–914     

Multireference calculations on low-lying states and the X~3 Π_u -~3 Π_g absorption spectra of indium dimers

Multireference configuration interaction calculations are carried out on 11 Λ-S low-lying electronic states of indium dimers. The states are investigated with spin-orbit pseudopotentials via the state-interacting method, and characterized by fitted spectroscopic constants based on computed potential energy curves. The vibrational structures of the double-potential well 0+g (I) ( 3 Σ g ) state are also analyzed. The experimentally observed absorption spectrum centred at ～ 13000cm-1 is simulated and assigned to X 3 Πu (v=0)-3Πg transition according to the present ab initio calculations on transition energies and dipole moment functions.