电化学合成铜配合物的研究

采用金属铜为"牺牲"阳极,首次在无隔膜电解槽中,电化学溶解金属铜一步制备了纳米CuO前体Cu(OEt)2, Cu(OBu)2, Cu(acac)2, Cu(OEt)(acac), Cu(OBu)(acac) (acac为乙酰丙酮基).产物通过红外光谱(FT-IR)、拉曼光谱(Raman spectrum)进行表征.同时讨论了影响电合成铜醇盐及其配合物的关键因素.实验表明,防止阳极钝化,温度控制在30～50 ℃,采用有机胺溴化物为导电盐, 电极电位控制在0.8～1.2 V之间,可以提高电合成效率.实验同时表明Cu(acac)2, Cu(OEt)(acac), Cu(OBu)(acac)可作为制备含铜纳米材料前驱体.     

Selective separations by reactive ion exchange : Part III. Preconcentration and separation of oxo anions

A new procedure for simultaneous preconcentration, separation, and determination of permanganate, chromate and vanadate was developed for aqueous solutions containing p.p.b. levels of these anions (and molybdate). The presence of other (non-complexing) ions in p.p.m. concentrations did not interfere. The procedure consisted of reactive adsorption of all three anions as their reduced cations, on iron(II)-treated resin, followed by elution of vanadium(IV) with 0.01 M HNO₃/H₂O₂, manganese(II) with 0.35 M HCl, and chromium(III) with 4M HCl. Concentration factors of 40 were obtained with 1-l “samples” 10 p.p.b. concentrations were determined with standard deviations of 4–5 % by a.a.s. and conventional spectrophotometry.     

Low-temperature bath/coupled-capillary/sweeping-micellar electrokinetic capillary chromatography for the separation of naphthalene-2,3-dicarboxaldehyde-derivatized dopamine and norepinephrine

The use of a low-temperature (0 degrees C) bath-assisted coupled capillary for the separation of naphthalene-2,3-dicarboxaldehyde (NDA)-derivatized dopamine and norepinephrine using the sweeping-micellar electrokinetic capillary chromatography (MEKC) mode is described. In this technique, a capillary consisting of two portions with different inside diameters is used. Therefore, the field strength inside the capillary is different. Hence, the electrophoretic migration velocities of the analytes and the electro-osmotic flow (EOF) also are different. Furthermore, when a portion of the capillary (wide portion, used for sweeping) is immersed in a low-temperature bath, the viscosity of the buffer and the retention factor of the analytes inside are increased. Thus, not only are the interactions between the SDS micelles and the analytes increased, but the SDS-analytes also move more slowly. As a result, a more complete separation can be achieved, even when the sample injection volume is large, up to approximately 2 microL. In general, when the volume of an injected sample is larger, the effects of sweeping and separation would become insufficient, especially when the retention values (k) of the analytes are quite different. However, this limitation can be improved when the low-temperature bath/coupled capillary/sweeping-MEKC mode is used.     

Adsorption of NH3 onto activated carbon prepared from palm shells impregnated with H2SO4

Adsorption of ammonia (NH3) onto activated carbons prepared from palm shells impregnated with sulfuric acid (H2SO4) was investigated. The effects of activation temperature and acid concentration on pore surface area development were studied. The relatively large micropore surface areas of the palm-shell activated carbons prepared by H2SO4 activation suggest their potential applications in gas adsorption. Adsorption experiments at a fixed temperature showed that the amounts of NH3 adsorbed onto the chemically activated carbons, unlike those prepared by CO2 thermal activation, were not solely dependent on the specific pore surface areas of the adsorbents. Further adsorption tests for a wide range of temperatures suggested combined physisorption and chemisorption of NH3. Desorption tests at the same temperature as adsorption and at an elevated temperature were carried out to confirm the occurrence of chemisorption due to the interaction between NH3 and some oxygen functional groups via hydrogen bonding. The surface functional groups on the adsorbent surface were detected by Fourier transform infrared spectroscopy. The amounts of NH3 adsorbed by chemisorption were correlated with the contents of elemental oxygen present in the adsorbents. Mechanisms for chemical activation and adsorption processes are proposed based on the observed phenomena.     

Waterborne polyurethane assembly multifunctional coating for hydrophobic and antibacterial fabrics

Surface modification of fabrics is a powerful strategy that can endow fabrics with desired effects while keeping the intrinsic properties. Herein, an ordinary strategy, dipping-drying based layer-by-layer self-assembly (LbL) coating, is reported to functionalize fabrics’ surfaces. Firstly, the novel cation waterborne polyurethanes (QAHDPU) and anion waterborne polyurethanes (HDPU) are successfully designed and synthesized. By incorporating targeted molecule, hydantoin diol (HD) and quaternary ammonium salt with long alkyl chain (DOQA), the QAHDPU are antibacterial and hydrophobically functionalized. Taking advantage of strong adhesion, waterborne polyurethanes (WPUs) are physically bonded to surfaces of fabrics to generate durable antibacterial and hydrophobic fabrics. The QAHDPU with long alkyl chain combined with rough and porous fabric surface fabricates hydrophobic fabric surface, which can prevent bacteria from adhering to the fabrics. Furthermore, the coated fabrics present excellent antibacterial properties after chlorination, forming a second barrier against bacteria. The chlorinated coated fabrics, can inactivate 85.0–99.9% of Staphylococcus aureus and 85.0–97.7% of Escherichia coli with contact time of 60 min. The hydrophobic properties of coated fabrics are greatly improved with water contact angles of 122.0°–141.1°. In addition, the proposed method is applicable for a variety of fibers and expected to be used for industrial production.

Graphical abstract

     

Inspection of the reversal of enantiomer migration order in ligand exchange micellar electrokinetic capillary chromatography

Enantiometers of D,L-phenylalanine were separated by capillary electrophoresis based on the principle of ligand exchange. Copper (II) complex of 4-hydroxy-L-proline was used as chiral selector. The separation and the migration order of D- and L-phenylalanine were strongly affected by adding an anion surfactant sodium dodecylsulfate (SDS). Without SDS in the electrolyte, the separation was also carried out but the resolution was very small. With SDS added into the electrolyte, the resolution decreased with increasing concentration of SDS until 5.0 mM. When the concentration of SDS in the electrolyte was over 5.0 mM, inversion of the migration order of DL-phenylalanine was observed and the resolution was also increased with increasing concentration up to 20 mM. It was interesting to find that the inversion of the migration order took place not only in the enantioscparation but also in the positional isomers. A family of a fluorinated amino acid, o-, m- and p-fluoro-D,L-phenylalanine was separated and the inversion of the migration order is discussed.     

Instrumental neutron activation analysis of large samples: A pilot experiment

A large sample INAA (LS-INAA) was conducted based on available experimental conditions. Four different materials, e.g., a quartz-sand and three wastes from an incineration plant were analyzed on sample size of 1 kg. The neutron flux spatial distribution was determined by irradiation of flux monitors in the sample. The gamma-ray apparent counting efficiency was evaluated based on the effective-solid angle concept, using linear attenuation coefficients calculated from an iteration process. The k ₀- and the modified monostandard methods were modified for the LS-INAA. To check the LS-INAA performance, a conventional small sample INAA was carried out for the quartz sand and a waste. All detected elements in the LS-INAA are presented and the discussion is conducted to explore the sources of errors in the LS-INAA. As a pilot experiment, the information from this work will be used in constructing irradiation and counting devices for the new FRM-II neutron source in Garching, Germany.     

Development of a new reaction system for the synthesis of highly optically active alpha,gamma-substituted gamma-butyrolactones

A highly useful method for the synthesis of optically active alpha,gamma-substituted gamma-butyrolactones has been developed. The SmI(2)-induced reductive coupling of chiral 2-alkyl acrylates derived from isosorbide with ketones in the presence of (1S)-(-)-2,10-camphorsultam as a proton source give the chiral alpha,gamma-substituted gamma-butyrolactones in good yields and high enantiomeric purities (up to >99% ee for trans and 75% ee for cis). The reaction system has been investigated with various ketones, and it is demonstrated that this system is very effective for trans-alpha,gamma-substituted gamma-butyrolactones. Both the chiral auxiliary and the hindered proton source in this system are necessary for the observed excellent ee values of the products. The absolute configuration of the trans products is assigned on the basis of the X-ray crystal structure.     

pH-sensitive polyelectrolyte complex gel microspheres composed of chitosan/sodium tripolyphosphate/dextran sulfate: swelling kinetics and drug delivery properties

Porous chitosan (CS) polyelectrolyte complex (PEC) hydrogel microspheres were prepared via either wet phase-inversion or ionotropic crosslinking with sodium tripolyphosphate (Na+ - TPP) and dextran sulfate (DS). The resulting microspheres were characterized using scanning electron microscopy (SEM) and elemental analysis (EA). The controlled release behavior of ibuprofen (IBU) from these microspheres was investigated. The PEC microspheres were about 700-950 microm in diameter with large pores and open porous structure. The CS/TPP/DS microspheres resisted hydrolysis in strong acid and biodegradation in enzymatic surroundings. The swelling kinetics for CS microspheres was close to Fickian diffusion, whereas those for CS/TPP and CS/TPP/DS were non-Fickian. Furthermore, the equilibrium water content (EWC) and water diffusion coefficient (D) increased with the pH of the media. The release profiles of IBU from CS/TPP/DS microspheres were slow in simulated gastric fluid (SGF, pH 1.4) over 3 h, but nearly all of the initial drug content was released in simulated intestinal fluid (SIF, pH 6.8) within 6 h after changing media. Overall the results demonstrated that CS/TPP/DS microspheres could successfully deliver a hydrophobic drug to the intestine without losing the drug in the stomach, and hence could be potential candidates as an orally administered drug delivery system.     

Dispersion state of CuO on CeO2

XRD and XPS are used to study the dispersion state of CuO on ceria surface. The dispersion capacity values of CuO measured by the two methods are consistent, which are of 1.20 mmol CuO/100 m² CeO₂. In addition, the results reveal that highly dispersed Cu²⁺ ions are formed at low CuO loadings and that increasing the CuO content to a value higher than its dispersion capacity produces crystalline CuO after the surface vacant sites on CeO₂ are filled. The atomic composition of the outermost layer of the CuO/CeO₂ samples has been probed by using static secondary ion mass spectroscopy (SSIMS), and the ratim of Cu/Ce are found to be 0.93 and 0.46 for the 1.22 and 0.61 mmol CuO/CeO₂ samples respectively. Temperature-programmed reduction (TPR) profile with two reduction peaks at 156 and 165°C suggests that the reduction of highly dispersed Cu²⁺ ions consists of two steps and is easier than that of CuO crystallites, in which the TPR profile has only one reduction peak at about 249°C. The above experimental results are in good agreement with the prediction of the incorporation model. Project supported by the National Natural Science Foundation of China.