Total synthesis of a conformationally constrained didemnin B analog

The total synthesis of a didemnin B analogue containing a conformationally constrained replacement for the isostatine moiety is reported. Synthetic highlights include an improved preparation of 2-hydroxy-3-cyclohexenecarboxylic acid and a new strategy for accessing the macrocycle.     

Facile synthesis of exfoliated and highly conductive poly(arylene disulfide)/graphite nanocomposites

Exfoliated graphite has been synthesized by first synthesizing H₂SO₄ intercalated compound in a H₂O₂‐H₂SO₄ mixture, followed by exfoliation under microwave irradiation. Poly(arylene disulfide)/graphite nanocomposites were then fabricated by absorbing cyclic(arylene disulfide) oligomers into the pores of exfoliated graphite. Subsequently, the nanocomposite precursor was subjected to heat treatment to carry out the in situ ring‐opening polymerization of the oligomers via free radical mechanism. The as‐prepared nanocomposite exhibited a exfoliated nanostructure as evidenced by transmission electron microscopy (TEM) observation. The nanocomposite with a very small amount of graphite, 5 wt%, possesses a highly electrical conductivity of 4 S/cm, therefore, many applications can be found as conductive materials. Copyright © 2004 John Wiley & Sons, Ltd.     

Photopolymerization induced by a benzophenone derivative photoinitiator

A benzophenone derivative photoinitiator, HBP-TDI-HQ-TDI-HBP （HTCTH）, was synthesized based on 4-hydroxy benzophenone （HBP）, toluene-2,4-diisocyanate （TDI） and hydroquinone （HQ）. HTCTH was a more effective photoinitiator which had longer wavelength absorption in the UV-vis absorption spectra than the low molecular counterpart benzophenone （BP）. It showed that both rate of polymerization （Rp） and final conversion （P） increased with increase of amine and HTCTH concentration in photopolymerization.     

3-(Triethoxysilyl)propionitrile sol-gel coating

3-(Triethoxysilyl)propionitrile (TESPN) sol-gel has been prepared under different conditions. It was employed for coating the surfaces of quartz and aluminum. Infrared (IR) and Raman spectra of TESPN and TESPN sol-gels have been recorded in the study of the sol-gel process. Transmission and reflection absorption IR (RAIR) spectra of TESPN sol-gel coated quartz and aluminum have also been collected for better understanding the film formation on the substrate surfaces. Spectra collected at different temperatures indicated that the silane film on quartz decomposes at 700 degrees C. Results from thermal gravimetric analysis (TGA) supported this result. Based on the group frequencies and the spectral behavior in different states, some vibrational modes were assigned to the observed bands. The anticorrosion behavior of the sol-gel coated aluminum in comparison with the uncoated metal was evaluated by measuring the potentiodynamic polarization and electrochemical impedance spectra (EIS).     

A Large Conformational Change of a Bridged β-Cyclodextrin Dimer in Aqueous Solution

A novel bridged β-CD dimer in which two β-cyclodextrins were linked by a naphthalene at positions 2 and 7 has been synthesized. 1H and 13CNMR measurements showed that a large change in the conformation of the dimer occurred in aqueous solution. The dimer interacted with methyl and ethyl orange to form stable inclusion complexes via "induced fit" mechanism.     

论测量不确定度

讨论了测量不确定度的基本概念及应用。分析了误差和不确定度两个概念的区别，探讨了不确定度及分量的评定方法。     

镍氢动力电池用AB5型贮氢合金热处理工艺的研究

本文对镍氢动力电池用AB5型纳米晶贮氢合金热处理工艺进行了研究.分别采用X射线衍射、金相、PCI测试手段分析热处理后贮氢合金的微观结构与吸放氢动力学性能.贮氢合金的电性能测试结果表明,经过950℃×6 h热处理的贮氢合金,10C放电比容量可以达到241mAh/g,循环寿命大于500次,分别以7C,10C放电,高倍率放电率(HRD)为92.5%,85.2%.将贮氢合金粉组装成电池进行测试,2min后,放电平台电压为1.143V,以10C放电,300次循环后,电池容量衰减率较小.     

Preparation and characterization of nitrogen-doped TiO2 photocatalyst in different acid environments

Nitrogen-doped TiO₂ powders were successfully prepared by a wet method, i.e., a micro-emulsion-hydrothermal method, in different acid environments. Several characterization techniques, X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and UV-visible diffuse reflectance spectra, were combined to determine the crystal phase, concentration and chemical states of the nitrogen doped in TiO₂. The high photocatalytic activity of the nitrogen-doped TiO₂ was evaluated through the decomposition of rhodanmine B under visible light irradiation. It was suggested that the doped nitrogen formed oxynitride (NO) and produced impurity states at higher above the valence band of TiO₂. Therefore, the nitrogen doping could enhance the response of photocatalyst to the visible light and improve the photocatalytic activity because of the narrowing of band gap of TiO₂.     

Separation of salidroside from Rhodiola crenulata by high-speed counter-current chromatography

High-speed counter-current chromatography (HSCCC) was used to purify salidroside from an extract of Rhodiola crenulata with two steps using a two-phase solvent system composed of ethyl acetate-n-butanol-water (1:4:5, v/v) in the first run and chloroform-methanol-isopropanol-water (5:6:1:4) in the second run. The method yielded 21.9 mg of salidroside from 1.216 g of the crude sample at 98% purity determined by HPLC analyses. Identification was performed by 1H NMR, 13C NMR, and MS.