1.54μmEr3+,Yb3+共掺玻璃激光器的速率方程及数值分析

LD抽运共掺Er,Yb玻璃激光器中的跃迁过程较复杂,针对双掺离子之间的能量传递和Er3+的多种跃迁过程,给出了详细的准三能级系统的速率方程,在合理简化后进行了数值分析,分析了Er3+掺杂浓度和介质长度、抽运光斑、输出镜透过率、谐振腔长、抽运光的椭圆度等因素对激光阈值及斜率效率的影响. 关键词： 1.54μm激光 Er3+玻璃 速率方程 数值分析     

Surface analytical characterization of oxide-free Si(100) wafer surfaces

Summary Wet-chemical cleaning procedures of Si(100) wafers are surface analytically characterized and compared. Hydrophobic surfaces show considerably less native oxides in comparison to hydrophilic surfaces.The growth of the oxide is determined as a function of exposure to air by means of XPS measurements. The chemically shifted Si2p XPS signal is utilized for the quantification of the growth kinetics.One hour after cleaning no chemically shifted Si2p XPS peak is discernible on the hydrophobic surfaces. Assuming homogeneous oxide growth, the detection limit of native oxides is estimated to be below 0.05 nm using an emission angle of 18° with respect to the wafer surface. The calculation of the oxide thickness from the chemically shifted and nonchemically shifted Si2p XPS peak intensities is carried out according to Finster and Schulze [1]. For more than a day after cleaning no surface oxides can be identified on the hydrophobic surfaces. The oxide growth kinetics is logarithmic. The very slow oxidation rate cannot be attributed to fluorine residues since no fluorine is seen by XPS. We explain the slow oxidation rate by a homogeneous hydrogen saturated Si(100) wafer surface.

---

Oberflächenanalytische Charakterisierung oxidfreier Si(100)-Waferoberflächen

     

Effects of Nb2O5 on thermal stability and optical properties of Er3+-doped tellurite glasses

Er³⁺-doped tellurite glasses with molar compositions of xNb₂O₅-(14.7-x)Na₂O--10ZnO--5K₂O--10GeO₂-- 60TeO₂--0.3Er₂O₃ (x=0, 3, 5, 7 and 9) have been investigated for developing 1.5~μm fibre and planar amplifiers. The effects of Nb₂O₅ on the thermal stability and optical properties of Er³⁺-doped tellurite glasses have been discussed. It is noted that the incorporation of Nb₂O₅ (x=5) increases the thermal stability of tellurite glasses significantly. Er³⁺-doped niobium tellurite glasses exhibit a large stimulated emission cross-section (7.2\times 10^-21- 10.7×10^-21~cm² and the gain bandwidth, FWHM×\sigma_e^{\rm peak} (274\times 10^-28 - 480×10^-28~cm³), which are significantly higher than that of silicate and phosphate glasses. In addition, the intensity of upconversion luminescence of the Er³⁺-doped niobium tellurite glasses decreases rapidly with increasing Nb₂O₅ content. As a result, Er³⁺-doped niobium tellurite glasses might be a potential candidate for developing laser or optical amplifier devices.     

利用微悬臂梁表面应力研究聚N-异丙基丙烯酰胺分子的构象转变

提出了一种基于微悬臂梁传感技术研究大分子折叠/构象转变的新方法.通过分子自组装的方法将热敏性的聚N-异丙基丙烯酰胺(PNIPAM)分子链修饰到微悬臂梁的单侧表面，用光杠杆技术检测温度在20—40℃之间变化时由于微悬臂梁上的PNIPAM分子在水中的构象转变所引起的微悬臂梁变形.实验结果显示：在升温过程中，微悬臂梁的表面应力发生了变化并且导致微悬臂梁产生了弯曲变形，这个过程对应着微悬臂梁上的PNIPAM分子从无规线团构象到塌缩小球构象的构象转变.在降温过程中，微悬臂梁发生了反方向的弯曲变形，这对应着PNIPA 关键词： 构象转变 聚N-异丙基丙烯酰胺分子链 表面应力 微悬臂梁     

LD抽运Cr~(4 )∶YAG高重复率被动调QNd∶YVO_4激光器

采用Cr4 ∶YAG晶体作为可饱和吸收体,实现连续激光二极管(LD)端面抽运的Nd∶YVO4激光器的高重复率被动调Q·在注入抽运功率为8.8W时,得到重复频率23.8kHz、平均功率1.21W的调Q脉冲序列;每个脉冲能量为51μJ、脉宽为25ns、峰值功率达到2.03kW·实验上研究了脉冲重复频率、平均输出功率、脉冲宽度、单脉冲能量与抽运功率、输出镜透过率的关系·实验结果表明,当抽运功率较大时,脉冲重复频率和输出平均功率随着抽运功率的增加而减小,对此进行了合理的理论解释·     

溶胀后的弹性印章进行毛细微模塑

用溶胀后的聚二甲基硅氧烷弹性印章进行毛细微模塑,得到了聚苯乙烯丙酮溶液的微四方点阵图案．较少的PS溶液滴加量会造成孤立不相连的微点阵图形．同时还获得了由于在收缩过程中各部分溶剂挥发速度不一造成的特殊的微点阵图案．     

Raman spectroscopic study of ceramic Sr2Bi4Ti5O18

Raman spectra of ceramic Sr2Bi4Ti5O18 （SBTi5） are reported to consist of four different Raman bands. Temperature-dependent spectra reveal the relationship between the lattice vibration and the material＇s structure. There appears a relatively large change in structure of the material at about 273K, The anharmonic potential of the material has a great influence on its phonon mode full width at half maximum （FWHM）, which can be expressed by a function of temperature. Theoretical fittings of the FWHMs for the two modes at around 312 cm^-1 and 464cm^-1 indicate that the latter phonon mode is more anharmonic than the former one.     

DIELECTRIC EFFECT ON THE RADIO-FREQUENCY CHARACTERISTICS OF A RECTANGULAR WAVEGUIDE GRATING TRAVELING WAVE TUBE

A new type of partial-dielectric-loaded rectangular waveguide grating slow-wave structure (SWS) for millimeter wave traveling wave tube (TWT) is presented in this paper. The radio-frequency characteristics including the dispersion properties, the longitudinal electric field distribution and the beam-wave coupling impedance of this structure are analyzed. The results show that the dispersion of the rectangular waveguide grating circuit is weakened, the phase velocity is reduced and the position of the maximum E _z is basically invariant after partially filling the dielectric materials in the rectangular waveguide grating SWS. Although the coupling impedance decreases a little, it still keeps above 40 Ω.     

Study on anti-emission materials for non-emitting grid applications in microwave power tubes

Hafnium and platinum were deposited onto molybdenum grids by ion-beam assisted deposition method. Electron-emission characteristics from molybdenum grids with Hf and Pt films, which were contaminated by active electron-emission substances (Ba, BaO) of the cathode, were measured using analogous diode method. The surfaces of grids were analyzed by X-ray diffraction. The results revealed that the reaction between BaO and Hf formed BaHfO₃ compound, which greatly reduced the accumulation of BaO on the surface and accordingly decreased grid emission. In contrast, Ba were formed by the decomposition of BaO on the surface of Pt film under high temperature and re-evaporated from its surface, which reduced the active electron-emission substances on the surface of the grid and effectively restrained grid emission. Their mechanisms for grid-emission suppression are discussed and a good method to develop new grid-coating materials is suggested.     

由大学多媒体教学实践所引发的深入思考

多媒体技术是物理教学良好的辅助工具，多媒体技术的应用为大学物理教学开辟了一片广阔天地。它能大大增加物理教学的信息量，图形形象直观、生动活泼，有着传统教学无法比拟的优势，但是，多媒体技术使用不当也会给物理教学带来一些负面影响。