基于吸收系数的生脉注射液中聚山梨酯80含量测定新方法

聚山梨酯80又名吐温80，为一种亲水型非离子表面活性剂，是食品、保健品和药品中常用的辅料，作为增溶剂和澄清剂广泛用于中药注射剂。近年来，不良反应的发生使得聚山梨酯80的质量和应用愈加受到重视，有研究认为其加入可能引起注射剂不良反应增加。为避免超量使用，有必要对该辅料的投料加以严格控制。中药注射剂中聚山梨酯80的含量测定是当下研究的热点和难点，可以通过分光光度法、分子排阻-蒸发光散射检测法(SEC-ELSD)、液质联用法(LC-MS)直接测定，也可以水解后法经液相色谱-紫外检测法(HPLC-UV)或气相色谱法(GC)间接测定。但由于聚山梨酯80为聚氧乙烯聚合数目不同的混合物、不同厂家生产的聚山梨酯80化学组分及比例存在较大差异，难以采用统一的转换公式或对照品准确定量。此外，中药注射剂的复杂基质造成的假阳性干扰也对定量提出了挑战。为解决以上问题，以生脉注射液为例，提出基于吸收系数的中药注射剂中聚山梨酯80含量测定新方法。优化检测波长、显色剂种类、液液萃取过程振荡和静置时间，在6个不同品牌仪器上测得聚山梨酯80-硫氰酸钴配合物的吸收系数(E1%_{1 cm})为104.23，相对标准偏差(RSD)为2.08%。生脉注射液稀释10倍后，精密量取供试品溶液1.0 mL，精密加入硫氰酸钴溶液10 mL，二氯甲烷20 mL，涡旋振荡3 min。将混合液移至分液漏斗中，静置30 min，取下层二氯甲烷液，将前1 mL弃去，接收约15 mL，在320 nm处测定吸光度，再根据Lambert-Beer定律，利用获得的吸收系数计算得到聚山梨酯80的含量。方法阴性无干扰，精密度和重复性相对标准偏差均低于3%，平均回收率为98.42%。为进一步验证方法的准确性，分别采用吸收系数法和标准曲线法测定了2个厂家的10批生脉注射液，并与实际投料量比较。配对t检验结果表明，当置信度为95%时，两种方法无显著性差异，吸收系数法测得结果与企业生产中聚山梨酯的实际投料量也无显著性差异。研究采用前人未采用的、灵敏度更高的320 nm为检测波长，显著降低了基质干扰，克服了中药注射剂中聚山梨酯80测定结果与实际投料量难以吻合的问题。吸收系数法无需使用对照品，亦不用制备标准曲线，可为中药注射剂中聚山梨酯80的检查标准提供切实可行的解决方案。所建方法灵敏、准确、快速、简便，为含聚山梨酯80制剂的质量控制提供了关键常数及新的思路。     

锡苯和铅苯二聚反应的理论研究

采用密度泛函理论B3LYP方法,研究了锡苯和铅苯的[2+2],[4+2]及[4+4]二聚反应的微观机理和势能剖面,考察了Sn(Pb)原子上的2,4,6-三甲基苯基(Mes)取代基对反应势能剖面的影响.研究结果表明,所有反应均为协同过程,且大多数情况下,2个C—Sn(Pb)键同步形成.[2+2]和[4+2]反应在热力学和动力学上均比相应的[4+4]反应容易进行,而[4+2]反应在动力学上比相应的[2+2]反应有利.Sn(Pb)原子上的Mes取代基在热力学和动力学上均不利于反应的进行.铅苯的动力学稳定性与锡苯相当,但其热力学稳定性高于锡苯.     

Development of an LC‐MS/MS method for determining the pharmacokinetics of clonidine following oral administration of Zhenju antihypertensive compound

Zhenju antihypertensive compound (ZJAHC) is a combined Chinese–Western medicine formula including clonidine (CLO), hydrochlorothiazide (HCT), rutin, Chrysanthemum indicum extract and pearl powder. Compared with CLO preparations, ZJAHC shows improved activities and decreased adverse effects. It is believed that the side effects of CLO are caused by its high peak plasma concentration. Hence, study of the influence of ZJAHC on the pharmacokinetic behaviors of clonidine seems essential. In present study, the plasma concentrations of CLO were determined with a liquid chromatography–tandem mass spectrometry (LC‐MS/MS) method. The MS/MS transitions monitored for clonidine and internal standard were 230.2 → 213.1 and 152.2 → 110.2, respectively. The analyte was quantified in a single run within 3 min. The pharmacokinetic study showed that the area under the plasma concentration–time curve of CLO in ZJAHC (60 µg/kg CLO) was similar to that of CLO‐HCT‐high (120 µg/kg CLO) but the peak concentration was much lower than that in CLO‐HCT‐high. ZJAHC could enhance the bioavailability without greatly increasing peak concentration of clonidine. This comprehensive effect of enhancing the bioavailability and avoiding the high peak plasma concentration for CLO might mainly result from the co‐contribution of Western medicine and traditional Chinese medicine (TCM), while the effect of TCM was stronger than that of Western medicine. Copyright © 2014 John Wiley & Sons, Ltd.     

三维打印器件后处理液研究

分析了不同的填充强化剂(后处理A液)、不同的后处理B液基料、后处理B液中水性环氧乳液的掺量及后处理液浸泡时间对石膏基打印器件耐水性、抗压强度、尺寸偏差、表面微观结构的影响.结果表明:经纳米硅超硬固化剂处理后的打印器件抗压强度大幅提高,纳米硅超硬固化剂最适宜作为后处理A液;水性聚氨酯乳液PU-202B最适宜作为后处理B液的基料;后处理B液中加入水性环氧乳液,处理后打印器件的抗压强度增加、吸水率降低,但水性环氧乳液含量增加到一定程度后会出现尺寸偏差;后处理A、B液最佳浸泡时间分别为130 s和35 s;先浸泡后处理A液、后浸泡后处理B液的打印器件具有抗压强度高、吸水率小、表面较光滑、不脱粉等优良性能.     

中国大气颗粒物污染与致癌研究进展

 室外空气污染和污染空气中的颗粒物是一类致癌物，而近年中国的大气颗粒物污染仍然维持在较高浓度水平。通过综述中国近年大气颗粒物污染现状和开展的颗粒物致癌机制研究，分析中国研究中颗粒物有关实验动物致癌性的证据和颗粒物致癌的人群流行病学线索，阐述大气颗粒物与癌症的关系，提出中国亟需开展相关研究。     

Directing-Group-Free C7-Alkylations of N-Alkylindoles Mediated by Cationic Zirconium Complexes: Role of Brønsted Acid for Catalytic Manifold

Highly position selective alkylations of N-alkylindoles at C7-positions have been enabled by cationic zirconium complexes. The strategy provides a straightforward access to install alkyl groups at C7-positions of indoles without a complex directing group. Mechanistic studies provided support for the importance of Brønsted acids in the catalytic manifold.     

Twining Poly(polyoxometalate) Chains into Nanoropes

Organic polymers and inorganic clusters belong to two different disciplines and have completely different properties and structures. When a cluster is attached to the backbone of a polymer as a pendant, the resultant hybrid polymers (polyclusters) exhibit unique behaviours totally different from those of conventional polymers owing to the nanoscale size of the cluster and its particular interactions. Herein, the aggregation of a poly(polyoxometalate)—a polynorbornene backbone with inorganic polyoxometalate cluster pendants—upon addition of a non-solvent to its dilute solution is reported. A three-dimensional network of tangled and snake-like nanothreads was observed. Direct visualisation of individual nanoscale clusters enabled identification of single chains within the nanothreads. These observations suggest that during the process of aggregation, the hybrid polymer forms curved or extended chains as a consequence of an armouring effect in which the collapsed cluster pendants wrap around the backbone. The collapse occurs because they become less soluble in the solvent/non-solvent mixture. The extended chains then become entwined and form nanoropes consisting of multiple chains wound around each other. This study provides a deeper understanding of the nature of polyclusters and should also prove useful for their future development and application.     

The visible and ultraviolet organic light-emitting diodes with germanium dioxide as facile solution-processed anode buffer layer

Germanium dioxide (GeO₂) aqueous solutions are facilely prepared and the corresponding anode buffer layers (ABLs) with solution process are demonstrated. Atomic force microscopy, X-ray photoelectron spectroscopy and ultraviolet photoelectron spectroscopy measurements show that solution-processed GeO₂ behaves superior film morphology and enhanced work function. Using GeO₂ as ABL of organic light-emitting diodes (OLEDs), the visible device with tris(8-hydroxy-quinolinato)aluminium as emitter gives maximum luminous efficiency of 6.5 cd/A and power efficiency of 3.5 lm/W, the ultraviolet device with 3-(4-biphenyl)-4-phenyl-5-tert-butylphenyl-1,2,4-triazole as emitter exhibits short-wavelength emission with peak of 376 nm, full-width at half-maximum of 42 nm, maximum radiance of 3.36 mW/cm² and external quantum efficiency of 1.5%. The performances are almost comparable to the counterparts with poly (3,4-ethylenedioxythiophene):poly (styrenesulfonate) as ABL. The current, impedance, phase and capacitance as a function of voltage characteristics elucidate that the GeO₂ ABL formed from appropriate concentration of GeO₂ aqueous solution favors hole injection enhancement and accordingly promoting device performance.