A viscoelastic constitutive model of rubber under small oscillatory load superimposed on large static deformation considering the Payne effect

The viscoelastic behavior of carbon-black-filled rubber under small oscillatory loads superimposed on large static deformation is dealt with. In this class of problems, as the strain amplitudes of the load increase, the dynamic stiffness decreases, and this phenomenon is known as the Payne effect. Besides the effects of the static deformation and the frequencies of the superimposed dynamic load, the Payne effect is considered in this study. Influence factors are introduced in this model in order to consider the influence of static predeformation, the dynamic-strain-dependent properties, and frequency-dependent properties. For simplicity, separation of the three dominant variables, frequency, prestatic deformation, and dynamic amplitude of strain, is assumed. The Kraus model is used for describing the Payne effect. Dynamic tension tests are executed to obtain the model parameters and also for the verification of the proposed model. The suggested constitutive equation shows reasonable agreement with test data.     

Catalytic allylic transfer reactions of functionalized aldehydes promoted by BINOL-Ti(IV) with synergistic reagent

Practical and efficient catalytic asymmetric allylic transfer reactions of tin reagents promoted by BINOL-Ti[OCH(CF₃)₂]₂ complex by the utilization of t-BuSBEt₂ are successful with a variety of functionalized aldehydes containing ketone, aldehyde, ester, amide, or carbamoyl functionality and affords products in high levels of enantioselectivity.     

Reduction of dislocation density and improvement of optical quality in ZnO layers by MgO-buffer annealing

Optical properties of ZnO thin films with/without MgO-buffer annealing were investigated by low and room temperature photoluminescence measurements. The ZnO films were grown on c-sapphire substrates by plasma-assisted molecular-beam epitaxy employing a thin MgO-buffer layer. Dislocation density of ZnO layer was reduced from 5.3 × 10⁹ to 1.9 × 10⁹ cm⁻² by annealing MgO-buffer prior to the growth of ZnO. The intensity of free exciton emission from the sample with MgO-buffer annealing was almost twice of that from the sample without annealing, while the deep level emission from the sample with MgO-buffer annealing was about 1/3 of that without annealing. The MgO-buffer annealing improves optical quality of overgrown ZnO films.     

Optical characterization of CdTe/ZnSe fractional monolayer structures grown by atomic layer epitaxy

Luminescence properties of CdTe/ZnSe fractional monolayer grown by atomic layer epitaxy have been investigated. To investigate the origin of the highly efficient luminescence, various optical spectroscopic methods such as, photoluminescence (PL), temporal/spatial resolved PL, temperature dependence PL, and excitation power dependence PL have been used. It is found that structural inhomogeneities affect dominant influence on the line width and line shape of luminescence. The luminescence intensity greatly enhanced by the localization of exciton at the disorder induced localized states.     

Efficient and power-awareness query over sensor networks

Sensor networks consisted of low-cost, low-power, multifunctional miniature sensor devices have played an important role in our daily life. Light and humidity monitoring, seismic and animal activity detection, environment and habitat monitoring are the most common applications. However, due to the limited power supply, ordinary query methods and algorithms can not be applied on sensor networks. Queries over sensor networks should be power-aware to guarantee the maximum power savings. The minimal power consumption by avoiding the expensive communication of the redundant sensor nodes is concentrated on. A lot of work have been done to reduce the participated nodes, but none of them have considered the overlapping minimum bounded rectangle (MBR) of sensors which make them impossible to reach the optimization solution. The proposed OMSI-tree and OMR algorithm can efficiently solve this problem by executing a given query only on the sensors involved. Experiments show that there is an obvious improvement compared with TinyDB and other spatial index, adopting the proposed schema and algorithm.     

Investigation of chemometric calibration performance based on different chemical matrix and signal-to-noise ratio.

The chemometric calibration performance was systematically investigated by two parameters (changing the chemical matrix as well as the signal-to-noise ratio) of the NIR (near-infrared) spectrum. Three different analytes (hexane, cyclohexane, toluene) were selected and heptane was used as a solvent. The degree of spectral difference significantly affected the calibration performance. The largest structural difference between the analyte and the solvent provided the best calibration result for a given signal-to-noise ratio. Additionally, the signal-to-noise ratio of the spectra also directly influenced the calibration performance. Overall, the spectral difference and signal-to-noise ratio were the major factors for governing the chemometric calibration performance, especially in the low-concentration range.     

Low-order modeling and dynamic characterization of rapid thermal processing

A low-order model of rapid thermal processing (RTP) of semiconductor wafers is derived. The first-principles nonlinear model describes the static and dynamic thermal behavior of a wafer with approximate spatial temperature uniformity undergoing rapid heating and cooling in a multilamp RTP chamber. The model is verified experimentally for a range of operating temperatures from 400° C to 900° C and pressures of 1 Torr and 1 atmosphere in an inert N₂ environment. Theoretical predictions suggest model validity over a still wider range of operating conditions. One advantage of the low-order model over previous high-order and statistical models is that the proposed model contains a small number of fundamental parameters and functions that, if necessary, are easily identifiable. Furthermore, because of reduced computational complexity, the low-order model can be used in real-time predictive applications including signal processing and process control design. In studying and verifying the model, the dynamic behavior of a semiconductor wafer undergoing rapid temperature changes is characterized. Close comparison between theory and experiment in terms of the wafer eigenvalue and dc gain is demonstrated; the strong nonlinear effects of temperature are shown. Convective heat transfer losses are also examined and are shown to increase with radial position on the wafer.     

Irradiation-induced reduction and luminescence properties of Sm doped in BaBPO5

Usually, Sm²⁺ ions could be reduced by heating the materials in reducing atmospheres. Exposure to ionizing radiations is also known to cause Sm³⁺→Sm²⁺ conversion. In this work, BaBPO₅ doped with the samarium ion was prepared by high temperature solid-state reaction. Sm²⁺ ions were obtained by two different reduction methods, i.e., heating in H₂ reduced atmosphere and X-ray irradiation. The measurements of X-ray diffraction (XRD), and scanning electron microscope (SEM) were investigated. It is found that the conversion of Sm³⁺→Sm²⁺ is very efficient in BaBPO₅ hosts after X-ray irradiation. Sm²⁺ ions under these two reduction methods exhibit different characteristics that were studied by measurements of luminescence and decay. The results showed that the luminescence properties of Sm²⁺ ions in BaBPO₅ were highly dependent on the sample preparation conditions.     

Palladium-catalyzed C-N bond formation: synthesis of 1-aryl-1H-pyrazoles from β-bromovinyl aldehydes and arylhydrazines

Cyclic and acyclic β-bromovinyl aldehydes are cyclized with an array of arylhydrazines in toluene at 125 °C in the presence of a palladium catalyst and a phosphorus chelating ligand together with NaO^tBu to give 1-aryl-1H-pyrazoles in moderate to good yields.     

Local chemical distribution and electronic structure of Ge1−xTx DMS single crystals (T=Cr,Mn, Fe)

The spatial concentration distribution and local electronic structure of ferromagnetic Ge_1−xT_x (T=Cr, Mn, Fe) DMS single crystals have been investigated by using scanning photoelectron microscopy (SPEM), X-ray absorption spectroscopy (XAS), and photoemission spectroscopy (PES). It is found that doped T ions in Ge_1−xT_x crystals are chemically phase-separated, suggesting that the observed ferromagnetism arises from the phase-separated T-rich phases in Ge_1−xT_x.