Determination of Synthetic Phenolic Antioxidants in Vegetable Oil and Oil-Enriched Foods by High-Performance Liquid Chromatography with Electrochemical Detection

Three synthetic phenolic antioxidants, tertiary butyl hydroquinone, butylated hydroxytoluene, and butylated hydroxyanisole, were determined in vegetable oil and oil-enriched food by high-performance liquid chromatography (HPLC) with electrochemical detection. The separation was achieved using a reverse-phase column and gradient elution with methanol and 1% acetic acid. The limits of detection and quantification of the analytes were 2–120 lower, higher than those obtained by diode-array detection. The recoveries were 103.3% for tertiary butyl hydroquinone, 97.3% for butylated hydroxyanisole, and 95.2% for butylated hydroxytoluene. The results showed that HPLC with electrochemical detection is suitable for the quantification of low concentrations of phenolic antioxidants in vegetable oil and oil-enriched food with high sensitivity and accuracy.     

Determination and Characterization of the Uptake of Voriconazole in Human Lung Epithelial Cells by High-Performance Liquid Chromatography–Tandem Mass Spectrometry

Voriconazole is used to prevent invasive pulmonary aspergillosis. However, little is known about the concentrations of voriconazole in human lung epithelial cells (A549), which is the target for preventing invasive pulmonary aspergillosis. The goal of this study was to develop a high-performance liquid chromatography–tandem mass spectrometry method to quantify voriconazole in A549 cells. A triple-quadrupole mass spectrometer in selected reaction monitoring mode was used with positive electrospray ionization. The total duration of each run was 5?min. The calibration curves fit a least squares model for the voriconazole concentration ranging from 0.625 to 160?ng/mL. Intraday and interday coefficients of variation were less than 10%. Recoveries at the concentrations of the quality control samples where greater than 85%, and the matrix effects showed that the ratios of the peak response exhibited a 15% suppression of the signal in the matrix compared to water. Voriconazole may penetrate A549 cells. However, the voriconazole uptake was slow in A549 cells, reaching a plateau at 2?h, where the dose-dependent intracellular voriconazole concentrations were 1.98?±?0.38, 4.43?±?0.54, and 8.14?±?0.52?ng/mg protein for extracellular voriconazole concentrations of 5, 10, and 20?µg/mL, respectively. The uptake of voriconazole by A549 cells was linear at extracellular concentrations from 0 to 20?µg/mL. This study established a rapid and sensitive method suitable for determining voriconazole in A549 cells and described the kinetic properties of the absorption of voriconazole by A549 cells.     

Acid-mediated domino reaction of ortho-carbonylated alkynyl-substituted arylaldehydes with phenols: Rapid access to fused indeno[2,1-c]chromen-7-one derivatives

Acid-mediated domino reaction of ortho-carbonylated alkynyl-substituted arylaldehydes with phenols is described. The implement of this reaction can provide directly a variety of tetracyclic indeno[2,1-c]chromen-7-one products in good yields. The mechanism was proposed to be a domino indanone ring formation/ortho-alkylation of phenols/dehydrated cyclization for the formation of polycyclic skeleton. In addition, several interesting dimeric products containing a pentacyclic scaffold were also afforded stereoselectively albeit in moderate yields. The present transformations feature the use of simple acid catalyst, short reaction time and good substrate scope.     

Solubility and Solution Thermodynamic Properties of 4-(4-Hydroxyphenyl)-2-butanone (Raspberry Ketone) in Different Pure Solvents

The solubility of 4-(4-hydroxyphenyl)-2-butanone (raspberry ketone) in six pure solvents was experimentally determined at temperatures ranging from 283.15 to 313.15 K under the pressure 0.10 MPa by employing a gravimetrical method. The experimental results indicate that the solubility of raspberry ketone in all studied solvents is temperature dependent, a rise in temperature brings about an increase in solubility. The experimental solubility data of raspberry ketone in six pure solvents (acetone, ethanol, ethyl acetate, n-propyl alcohol, n-butyl alcohol, and distilled water) was correlated by using several commonly used thermodynamic models, including the Apelblat, van’t Hoff and λh equations. The results of the error analysis indicate that the van’t Hoff equation was able to give more accurate and reliable predictions of solubility with root-mean-square deviation less than 0.56%. Furthermore, the changes of dissolution enthalpies (Δ_diss H°), dissolution entropies (Δ_diss S°) and dissolution Gibbs energies (Δ_diss G°) of raspberry ketone in the solvents studied were estimated by the van’t Hoff equation. The positive value of Δ_diss H°, Δ_diss S°, and Δ_diss G° indicated that these dissolution processes of raspberry ketone in the solvents studied were all endothermic and enthalpy-driven.     

Effect of cold plasma process on the surface wettability of NBR and the kerosene resistance of NBR/PTFE composites

In this study, first the acrylonitrile‐butadiene rubber (NBR5080) was modified by argon (Ar), air, and oxygen plasma at low temperature, and the effect of plasma process (power, time, and pressure) on the surface properties of NBR5080, the interfacial properties, physical properties, and the mechanical properties of NBR5080/polytetrafluoroethylene (PTFE) composites were investigated. The state contact angle and the surface free energy were applied to characterize the surface wettability of NBR5080. The scanning electron microscope and the atomic force microscope were used to observe the surface morphology of the NBR5080. The chemical changes on the NBR5080 surface were verified by X‐ray photoelectron spectroscopy. The average water contact angle the NBR5080 declined obviously when NBR5080 was treated by Ar (100 W/600 s/30 Pa). The active oxygen groups were introduced onto the surface of NBR5080 by cold plasma treatment and more active group containing oxygen were observed on the samples treated by Ar plasma. The peel strength between the NBR5080 and the PTFE was increased obviously, which increased from 0 to 44.2 N?m^?1 for Ar plasma treatment. The mass and the dimension of NBR5080 increase sharply after immersing in kerosene, whereas the NBR5080/PTFE composites changed a little. The mechanical properties of NBR5080 and NBR5080/PTFE composites decreased as the immersion time in kerosene increased, but the decreased degree of NBR5080 is higher than NBR5080/PTFE composites.     

基于内滤效应的YVO4∶Eu荧光纳米探针测定色氨酸

采用溶剂热法合成了发光性能和水溶性良好的YVO4∶Eu纳米探针(YVO4∶Eu NPs).由于YVO4∶Eu NPs的激发光谱与色氨酸的吸收光谱有很大程度的重叠,二者可发生荧光内滤效应,其中色氨酸为吸光体、YVO4∶Eu NPs为荧光体,YVO4∶Eu NPs的发光被猝灭.基于此,建立了基于YVO4∶Eu NPs内滤效应测定色氨酸含量的方法.对YVO4∶Eu NPs的加入量、反应溶液pH值和反应时间进行了优化,在最佳反应条件下,本方法测定色氨酸的线性范围为4.0×10-6~4.0×10-4 mol/L,检出限为1.0 ×10-6 mol/L(3σ).采用本方法测定了酱油中色氨酸的含量,回收率为95.2%和97.3%.本方法具有简便快速、灵敏准确的特点.     

Improving the softness of BOPP films: From laboratory investigation to industrial processing

Young's modulus of biaxially oriented polypropylene (BOPP) films prepared with homemade film stretcher was investigated,which can be used to indicate the softness of fihns.It was found that the modulus of films was decreased by about 69％ as the content of polyethylene (PE) added into polypropylene (PP) reached 30％.Also,increasing draw temperature can induce lower stress level during stretching,which may lead to the formation of crystals with low orientation level and thus decreased modulus of films.Based on laboratory study,BOPP films produced on commercial line were studied by differential scanning calorimetry (DSC),wide and small-angle X-ray scattering (WAXS,SAXS) with varying contents of PE.SAXS results show that the crystals are oriented in both machine direction (MD) and transverse direction (TD),and the crystals are more oriented in TD than MD according to the WAXS results for all films.Also,the orientation parameter of crystal along TD increases from 0.68 to 0.83 as the contents of PE increase from 0％ to 25％.Meanwhile,the modulus of films in MD declines with increase of PE contents generally,improving the film softness.Orientation of crystals is thus an effective structure parameter to adjust the film softness.The relationship of processing-structure-property is also established.     

Synthesis of self-assemble pH-responsive cyclodextrin block copolymer for sustained anticancer drug delivery

Well-defined p H-responsive poly(ε-caprolactone)-graft-β-cyclodextrin-graft-poly(2-(dimethylamino)ethylmethacrylate)-co-poly(ethylene glycol) methacrylate amphiphilic copolymers(PCL-g-β-CD-g-P(DMAEMA-co-PEGMA)) were synthesized using a combination of atom transfer radical polymerization(ATRP),ring opening polymerization(ROP) and "click" chemistry.Successful synthesis of polymers was confirmed by Fourier transform infrared spectroscopy(FTIR),proton nuclear magnetic resonance(1H-NMR),and gel permeation chromatography(GPC).Then,the polymers could selfassemble into micelles in aqueous solution,which was demonstrated by dynamic light scattering(DLS) and transmission electron microscopy(TEM).The p H-responsive self-assembly behavior of these copolymers in water was investigated at different p H values of 7.4 and 5.0 for controlled doxorubicin(DOX) release,and these results revealed that the release rate of DOX could be effectively controlled by altering the p H,and the release of drug loading efficiency(DLE) was up to 88%(W/W).CCK-8 assays showed that the copolymers had low toxicity and possessed good biodegradability and biocompatibility,whereas the DOX-loaded micelles remained with high cytotoxicity for He La cells.Moreover,confocal laser scanning microscopy(CLSM) images revealed that polymeric micelles could actively target the tumor site and the efficient intracellular DOX release from polymeric micelles toward the tumor cells further confirmed the anti-tumor effect.The DOX-loaded micelles could easily enter the cells and produce the desired pharmacological action and minimize the side effect of free DOX.These results successfully indicated that p H-responsive polymeric micelles could be potential hydrophobic drug delivery carriers for cancer targeting therapy with sustained release.     

Air Atmospheric Dielectric Barrier Discharge Plasma Induced Germination and Growth Enhancement of Wheat Seed

Air atmospheric dielectric barrier discharge plasma (DBD) was attempted to pretreat wheat seed to improve its germination and growth in this study. The effects of the DBD plasma treatment on the wheat seed germination, seedling growth, osmotic-adjustment products, lipid peroxidation level, and antioxidant enzymes activity were investigated. The experimental results showed that the DBD plasma treatment with an appropriate time scale could promote the wheat seed germination and seedling growth. The germination potential, germination rate, germination index, and vigor index increased by 26.7, 9.1, 16.9, and 46.9% after 7 min’s DBD plasma treatment, respectively; the root length, shoot length, fresh weight, and dry weight of the seedlings also increased after the DBD plasma treatment. The osmotic-adjustment products, proline and soluble sugar contents, in the wheat seedlings were significantly enhanced after the DBD plasma treatment with an appropriate time scale, while the malondialdehyde content decreased. Moreover, the activities of superoxide dismutase and peroxidase also increased after the DBD plasma treatment. The DBD plasma treatment led to etching effect on the wheat seed coat, resulting in the improvement of its water absorption capacity.     

Analysis of temperature and stress field in Al alloy’s twin wire welding

By analyzing the shape of twin wire welding’s arcs and the track of droplets’ transition, the phenomenon that the twin wire welding’s fore arc and rear arc all deflect to the middle of the two arcs is found. Based on this the double ellipsoid heat source model is amended, and a heat source model which can apply to calculate the twin wire welding’s temperature field is put forward. This model is testified by actual experiment of temperature sampling. By comparing the temperature field of twin wire welding and single wire welding, the results show that twin wire welding has slender weld pool the end part of which is ellipsoid, and its HAZ is narrower than that of single wire welding. So, twin wire welding can not only reduce the Al alloy generating hot crack, but can also weaken the “overaging” softened phenomenon of heat treated strengthening Al alloy. In the end, the evolving rules of 2219 Al alloy’s longitudinal and transverse stress when welded with twin wire welding are analyzed.