交通灯控制下城市主干道双车道多速元胞自动机交通流模型研究

提出一个城市主干道双车道多速元胞自动机交通流模型，此模型采用开放性 边界条件，在考虑诸多实际因素影响情况下，研究了主干道中车站的设置、交通灯绿信比对 车流量和车流速度的影响.计算机模拟所得到的基本图（流量 速度图）能较好地反映在交 通灯控制下城市主干道交通流真实状况. 关键词： 元胞自动机模型 交通流 主干道     

磁性Salisbury屏的高频响应

研究了利用磁性薄膜构造Salisbury屏的可能性及其在微波频段的反射率频率特性.结果表明，利用铁磁性材料在铁磁共振频率附近磁化率具有χ″>χ′的特性，可以构造出对电磁波有良好吸收性能的磁性Salisbury屏.通过对铁磁材料高频磁谱物理机理的分析后指出，具有弛豫型共振磁谱的铁磁材料可以构造出薄膜型Salisbury屏，其厚度为微米甚至亚微米量级.反射率的频率特性与磁性材料的特征阻抗z-r有关，它取决于铁磁共振频率和静态磁化率.反射率的频率响应显示磁性薄膜Salisbury屏具有较宽的吸收带宽. 关键词： 磁性Salisbury屏 反射率 频带响应 磁性薄膜     

多壁碳纳米管膜湿敏特性的研究

研究了多壁碳纳米管(MWNTs)薄膜的湿敏特性，实验所用的多壁碳纳米管是用热灯丝化学气相沉积法(CVD)合成的.分别对未修饰和修饰的多壁碳纳米管膜温度和湿度特性进行研究后发现，修饰的多壁碳纳米管对温度和湿度非常敏感，且对湿度的响应时间和恢复时间短，重复性好.而未修饰的多壁碳纳米管对温度和湿度不太敏感.对修饰多壁碳纳米管的湿敏特性进行了理论分析，给出了其理论表示式. 关键词： 多壁碳纳米管 化学修饰 湿敏特性 物理吸附     

掺杂偶氮苯聚合物光致异构Z扫描测量及其理论解释

用He_Ne激光对掺有偶氮苯聚合物DR 13的PMMA薄膜样品进行Z扫描研究 ,发现其折射率改变量与光强的关系存在着饱和效应 ,且线偏振光引起的折射率改变明显大于圆偏振光引起的折射率改变 .对于这些现象 ,用光致异构的角烧孔机理进行解释     

ns脉冲激光对K9玻璃的破坏实验

 采用高速PIN光电探测器和高带宽的数字存储示波器，实时检测透射光脉冲和散射光脉冲的变化特征，并将之用作材料破坏的光学判据，测量得到K9玻璃在1.06μm纳秒脉冲激光作用下的能量损伤阈值约18mJ，相应的能量密度阈值为1.0kJ/cm²。通过分析透射光脉冲和散射光脉冲的特征，给出了材料的破坏时刻，并推断出K9玻璃所能承受的极限光强为10¹⁵W/m²。研究了能量透过率与泵浦能量的关系，并初步探讨了透明材料的破坏机理。结果表明：在多纵模激光的作用下，透明光学材料破坏是电离击穿与自聚焦效应综合作用的结果。     

连续照明时成像对比度与气象条件的关系

 通过同轴激光连续照明成像模型分析了大气后向散射对成像对比度的影响，得出了考虑散射因素时成像对比度的计算公式。基于不同气象条件下大气粒子散射特点，讨论了霾和雾两种不同天气时成像对比度随照明距离的变化规律，并与实验结果进行了对比，计算结果与实验吻合较好。     

一种新的永久周期磁铁聚焦的高功率宽带放大器

 提出了一种新的高功率宽带放大器，它由速调管和自由电子脉塞组成，用永久周期磁铁聚焦。研究了这种器件的电子束聚焦、群聚和辐射。在速调管提供一阶调制系数为30%，波导管的半径1.51cm，摇摆器的磁场振幅0.16T，周期7.92cm，电子束的电压490kV，电流50A和半径0.368cm的条件下，预估这种器件的辐射波频率为11.4GHz，输出辐射功率为18MW，输出辐射带宽为44%。     

Ceramic Films via Organometallic Complex as Single Source Precursor

Fe2(CO)6(μ-S2) was used as a single source precursor in attempt to produce FeS film via MOCVD. Pyrolysis of Fe2(CO)6(μ-S2) at temperature below 500℃ produced Fe1-xS or Fe7S8 powder as indicated by its powder X-ray spectra. At 750 ℃, polycrystalline FeS powder was obtained. In film deposition, polycrystalline Fe1-xS or Fe7Ss films were obtained on Si(100) and Ag/Si(100) substrates below 500 ℃. SEM micrographs showed the film on Si(100) substrate containing whisker like grains. However, pillar like grains were obtained on Ag/Si(100) substrate.Deposition rates are also different for different substrates as evaluated by the thickness of the films, which were obtained by SEM micrographs of the cross section of the films. At 750℃, similar polycrystalline Fe1-xS or Fe7S8 film was obtained.     

Synthesis of 5,6-Dihydro-OSW-1 and Its Antitumor Activities

5,6-Dihydro-OSW-1 (1) was synthesized following our previous procedure for the total synthesis of OSW-1. This compound demonstrated slightly stronger potency than that of OSW-1 against the growth of cancer cells.     

Isolation of 2-Chloro-5-methylpyridine from its Isomer 2-Chloro-3-methylpyridine by Formation of its Copper(II) Complex

2-Chloro-5-methylpyridine is an important intermediate for the preparation of biological active compounds, especially insecticides1, e.g. imidacloprid2, and is usually manufac- tured from 3-methylpyridine N-oxide. However, the manufacturing process also forms the by-products: 3-methylpyridine and its isomer 2-chloro-3-methylpyridine3. The pro- perties of the isomers are similar, it is difficult to separate by ordinary methods, such as distillation. Scheme 1 79.4%13.6%5.2%NClCH3NCH3ClNC…