THF—FER沸石的系列研究—1．晶体结构稳定性

四氢呋喃（THF）-Na2O-SiO2-Al2O3-H2O体系水热合成的THF-FER沸石，经酸交 换-焙烧脱THF（Ⅰ）或焙烧脱THF-酸交换（Ⅱ）的不同方式处理，均可制得低钠H- FER沸石。经XRD，^27Al与^29Si MAS NMR,低温氮吸附等表征证明，通过1273K高温 的热处理和1073K饱和水蒸气下的水热处理，H-FER沸石骨架保持高度稳定。在高温 水蒸气作用下，Si(2Al）容易从骨架上脱离，而Si(1Al）则保持相对稳定，以（Ⅱ ）方法处理，制备的H-FER沸石在水热条件下易产生较多的硅差劲基缺陷。经高温 热和水热处理后，H-FER沸石孔道结构基本保持完美、开放。     

用钛系载体高效催化剂进行乙烯-丙烯-1-丁烯三元共聚合的研究 Ⅰ.聚合条件对共聚合反应的影响

用多组份改性钛系载体催化剂TiCl_4,Ti(OBu)_4/MgCl_2/Ethylbenzeate(EB)/φ_2SiCl_2/AlEt_3进行了乙烯-丙烯-1-丁烯三元共聚合的研究。考察了单体进料比、聚合温度,烷基铝浓度和催化剂浓度等条件对共聚合的影响。发现本催化剂对乙丙丁三元共聚合有极高的催化效率,聚合1h达8.6×10~4g共聚物/g-Ti。共聚合速率衰减符合动力学方程:R_s=R_s+(R_0—R_s)_e~(βs)。     

气相色谱法测定阳离子表面活性剂合成体系中脂肪烷基二甲基叔胺

选用HP-NINOWax毛细管色谱柱及氢火焰离子化检测器（FID），采用程序升温，建立了4种脂肪烷基二甲基叔胺的分析方法。结果表明，4种脂肪烷基二甲基叔胺质量浓度在0.005~1.0 g/L范围内，其峰面积与质量浓度有良好的线性关系，相关系数（R²）在0.9996以上。检出限（LODs，信噪比为3）在0.001~0.002 g/L之间，定量限（LOQs，信噪比为10）在0.003~0.005 g/L之间，回收率在90%~130%之间，相对标准偏差为1.3%~6.9%（n=6）。方法的线性范围宽、回收率高、选择性好，可用于叔胺的产品质量分析及生产过程控制分析。利用该方法对阳离子表面活性剂合成反应中十六烷基二甲基叔胺进行监测，结果很好地符合双分子亲核取代反应。该方法比滴定分析法更快速、精确，与液相色谱法相比，不需要进行柱前衍生或者使用色谱-质谱联用仪器。     

2,5-二甲基-4-羟基-3(2H)呋喃酮的合成

以乙酰丙酮(1)为原料，经电解氧化偶联，Paal-Knorr闭环，Baeyer-Villiger氧化，水解等步骤，合成了一种重要的杂环香料，2,5-二甲基-4-羟基-3(2H)呋喃酮(6)。     

新型液晶／高聚物复合富氧膜的富氧性能及结构表征Ⅰ．液晶／高聚物复合膜的富氧性能研究

研究用烃橡胶和聚二甲基硅氧烷分散α、ω－对乙氧羰氧基苯甲酸聚乙二醇酯而得到聚合物分散液晶复合膜。用这种复合膜进行富氧分离，当ＰＥＥＣＢ－４．０５（４．０５为聚醚软段的数均聚合度ＤＰ）的含量超过某一临界值（约２３．０％ｗｔ）时，室温下ＳＢＲ／ＰＥＥＣＢ－４．０５／ＰＤＭＳ体系膜的氧气透过系数ＰＯ２值达７０－６３４ｂａｒｒｅｒ），增加约６０倍，分离系数仍较高。考察了各种影响因素对膜透气性能的影响。     

聚合物支载相转移催化剂的研究2.聚苯乙烯支载苯并-15-冠-5-与无环冠醚

本文报道了三种聚苯乙烯支载苯并-15-冠-5与两种聚苯乙烯支载无环冠醚的合成,并研究了它们对K~+与Na~+的络合性能与相转移催化性能。     

1,4-双(4''''-溴苯酰基)苯的合成工艺改进

以对苯二甲酰氯和溴苯为原料,无水氯化铝粉末为催化剂,合成了1,4-双(4'-溴苯酰基)苯,其结构经1H NMR,IR和DSC表征.     

Exposure dose assessment and discussion on radioisotope production and application

The exposure dose status on radioisotope production and application in China has been assessed in the paper. The average annual occupational exposure dose received by workers in the radioisotope production is about one tenth of the annual dose limit in normal situation. It is less than one twentieth for workers in the radioisotope applications. However, the annual collective dose for the latter is higher than the former by one oder of magnitude due to the larger number of workers in the application field. Although the output of radioisotopes increased doubly in 1980's as compared with 1970's, the increase on the annual collective dose was not obvious. For exposure to the public,¹³¹I for example, the collective dose in the radioisotope production decreased by one to two orders of magnitude and the releasing factor reduced by two orders of magnitude. Therefore, the exposure dose received by workers in radioisotope production and application is lower in normal situation. However, the facts worth paying attention to are that there were many events and accidents which happened in the radioisotope applications, especially at the irradiation facilities. The probability of fatal accident was as high as 10^–3 per irradiator year. In order to improve the radiation safety situation, it is imperative to conduct the safety assessment for irradiation facilities, to enhance management of the radioactive wastes and spent sources and to establish the experience feedback system.     

聚苯胺纳米点阵列的制备和库仑台阶现象

本文制备了PANI纳米点阵列, 利用导电原子力显微镜(C-AFM)表征了其形貌和导电性能, 在室温下观察到PANI纳米点的库仑台阶(Coulomb staircase)现象, 并利用库仑阻塞效应的理论进行了初步的分析.     

ZnO纳米线的电化学制备研究

High-quality ZnO nanowires have been synthesized at relatively low temperature via one-step electrochemical anodization technique. In this method, Zn sheet acted as the anode and Pb sheet served as the counter electrode, and the complex solution of HF-C₂H₅OH-H₂O was used as electrolyte. ZnO nanowires were characterized by Field Emission Scanning Electron Microscopy (FE-SEM), Transmission Electron Microscopy (TEM) and Selected Area Electron Diffraction (SAED) and X-ray Diffraction (XRD). The results show that the nanowires were wurtzite crystalline ZnO, and the ZnO nanowires with the diameters of 70 nm and 30～40 nm were obtained by adjusting preparation conditions, respectively.