改善20CrMnTiH淬透性的研究

莱钢特钢厂20CrMnTiH钢材成分波动较大,淬透性带HRC8～10,范围较大,制约了齿轮钢质量的进一步提高.通过研究,发现铸坯中心偏析尤其是碳偏析为主要问题.通过工艺优化采取各项措施,尤其增加电磁搅拌后,中心碳偏析得到明显改善;C控制在0.19%～0.20%的炉次达到了95.6%;淬透性带控制在HRC6内的达到了92.1%;在HRC4内的达到了86.2%;提高了产品质量,满足了用户需求.     

对教考分离工作的思考

教考分离工作是高校考试工作改革的必然趋势。本文从实施教考分离的模式入手,阐述了教考分离模式、完善教考分离的措施、实效及教考分离存在的问题,对当前教考分离工作的实施具有一定的借鉴作用。     

The Squeezing Effect in a Mesoscopic RLC Circuit

Using the path integral method we derive quantum wave function and quantum fluctuations of charge andcurrent in the mesoscopic RLC circuit. We find that the quantum fluctuation of charge decreases with time, oppositely,the quantum fluctuation of current increases with time monotonously. Therefore there is a squeezing effect in the circuit.If some more charge devices are used in the mesoscopic-damped circuit, the quantum noise can be reduced. We also findthat uncertainty relation of charge and current periodically varies with the period π/2 in the under-damped case.     

A New Simple Ultrahigh Speed Decoding Algorithm for BCH Code

1　Ｉｎｔｒｏｄｕｃｔｉｏｎ　　Ｍｏｄｅｒｎｄｉｇｉｔａｌｃｏｍｍｕｎｉｃａｔｉｏｎｓｙｓｔｅｍｓｏｆｔｅｎｒｅｑｕｉｒｅｅｒｒｏｒ ｆｒｅｅｔｒａｎｓｍｉｓｓｉｏｎ .Ｅｒｒｏｒｃｏｎｔｒｏｌｃｏｄｉｎｇｔｅｃｈｎｏｌｏｇｙｈａｓｂｅｅｎｕｓｅｄｗｉｄｅｌｙｉｎｃｏｍｍｕｎｉｃａｔｉｏｎｓｙｓｔｅｍ .Ａｎｄｉｔｈａｓｂｅｅｎｉｍｐｒｏｖｉｎｇｔｈｅｐｅｒｆｏｒｍａｎｃｅｏｆｃｏｍｍｕｎｉｃａｔｉｏｎｓｙｓｔｅｍ ｇｒｅａｔｌｙ ,ｅｓｐｅｃｉａｌｌｙｉｎｗｉｒｅｌｅｓｓｃｏｍｍｕｎｉｃａｔｉｏｎｓｓ…     

分叉问题的几何描述及其计算方法

本文通过一个构造的向量场,建立了非线性代数方程组的解流形与对应向量场的不变流形之间的等价关系,把解流形的分叉问题转化为对向量场奇点附近局部性态的研究。这种思路具有几何直观性,并为解流形的跟踪与分叉计算提供了一套新的数值方法。     

新型金属杂冠醚配合物18-MC-6[Mn6(4-Amashz)6(DMF)6]·12DMF的合成

合成了一种新型金属杂冠醚配合物[Mn6(4-amashz)6(DMF)6]·12DMF,并用X射线衍射法对其结构进行了表征.研究了该化合物修饰金电极催化氧还原的性质,结果表明,该化合物具有平面碟状结构,对在碱性溶液中的氧有显著的催化还原作用.     

多段构件组成的压杆平面内稳定

分析由若干段等截面或者变截面构件组成的压杆平面内稳定问题．从由三段等截面构件组成的压杆平面内稳定问题出发，对两端为变截面、中间为等截面构件组成的压杆的平面内稳定问题进行了分析，得出和两端为等截面构件情况类似的屈曲荷载计算公式．并对两端固接的情况进行了研究分析．     

Effect of Nonradiative Recombination on Carrier Dynamics in GaInNAs/GaAs Quantum Wells

The nonradiative recombination effect on carrier dynamics in GalnNAs/GaAs quantum wells is studied by timeresolved photoluminescence （TRPL） and polarization-dependent TRPL at various excitation intensities. It is found that both recombination dynamics and spin relaxation dynamics strongly depend on the excitation intensity. Under moderate excitation intensities the PL decay curves exhibit unusual non-exponential behaviour. This result is well simulated by a rate equation involving both the radiative and non-radiative recombinations via the introduction of a new parameter of the effective concentration of nonradiative recombination centres in the rate equation. In the spin dynamics study, the spin relaxation also shows strong excitation power dependence. Under the high excitation power an increase of spin polarization degree with time is observed. This new finding provides a useful hint that the spin process can be controlled by excitation power in GaInNAs systems.     

p型导电掺In的SnO_2薄膜的制备及表征

采用溶胶 凝胶提拉法成功地制备了p型导电掺In的SnO2 薄膜 .x射线衍射测试结果表明 ,掺In的SnO2 薄膜保持SnO2 的金红石结构 .吸收谱测试结果表明 ,掺In的SnO2 禁带宽度为 3 8eV .霍尔测量结果表明 ,空穴浓度与热处理温度有很大的关系 ,5 2 5℃为最佳热处理的温度 .铟锡原子比在 0 0 5— 0 2 0范围内 ,空穴的浓度与In的含量有直接的关系 ,并随In含量的增加而增加     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。