In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

Measurement and prediction of solubilities and diffusion coefficients of carbon dioxide in starch–water mixtures at elevated pressures

The solubility and diffusion coefficient of carbon dioxide in intermediate‐moisture starch–water mixtures were determined both experimentally and theoretically at elevated pressures up to 16 MPa at 50 °C. A high‐pressure decay sorption system was assembled to measure the equilibrium CO₂ mass uptake by the starch–water system. The experimentally measured solubilities accounted for the estimated swollen volume by Sanchez–Lacombe equation of state (S‐L EOS) were found to increase almost linearly with pressure, yielding 4.0 g CO₂/g starch–water system at 16 MPa. Moreover, CO₂ solubilities above 5 MPa displayed a solubility increase, which was not contributed by the water fraction in the starch–water mixture. The solubilities, however, showed no dependence on the degree of gelatinization (DG) of starch. The diffusion coefficient of CO₂ was found to increase with concentration of dissolved CO₂, which is pressure‐dependent, and decrease with increasing DG in the range of 50–100%. A free‐volume‐based diffusion model proposed by Areerat was employed to predict the CO₂ diffusivity in terms of pressure, temperature, and the concentration of dissolved CO₂. S‐L EOS was once more used to determine the specific free volume of the mixture system. The predicted diffusion coefficients showed to correlate well with the measured values for all starch–water mixtures. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 607–621, 2006     

Local chemical distribution and electronic structure of Ge1−xTx DMS single crystals (T=Cr,Mn, Fe)

The spatial concentration distribution and local electronic structure of ferromagnetic Ge_1−xT_x (T=Cr, Mn, Fe) DMS single crystals have been investigated by using scanning photoelectron microscopy (SPEM), X-ray absorption spectroscopy (XAS), and photoemission spectroscopy (PES). It is found that doped T ions in Ge_1−xT_x crystals are chemically phase-separated, suggesting that the observed ferromagnetism arises from the phase-separated T-rich phases in Ge_1−xT_x.     

面向对象数据库"联系_选择"查询操作的优化

综合考虑逻辑因素和选择谓词的选择率、谓词本身的复杂度等物理因素后，给出了“联系_选择”及其拓展“联系_选择_投影”两个重要的复合操作的优化算法，提高了查询的执行效率。     

激发态卟啉衍生物研究(Ⅶ)——取代基对卟啉—硝基苯化合物发光特性的影响

本文报导共价链相连的X-P-Y“三合板”型化合物在二甲基甲酰胺(DMF)和苯溶液中的发光特性.结果发现:引入取代基X=Cl—,CH3O—和Y=苯、硝基苯对中心卟啉的吸收和荧光光谱均无明显影响,仅其峰值频率将因溶剂不同而有所偏移.此外,由Cl—取代的卟啉—苯的荧光强度总比CH3O—取代时高;若将Y取代基由苯改换为硝基苯时,将使CH3O—P—Y化合物的荧光增强,但在Cl—P—Y化合物中则出现相反的趋势.不论在何种化合物中,在Y取代基中的苯环上引入NO2—基后,均可使其消光系数减小,而且当硝基在邻位取代时,这一效应更为显著.所有这些变化规律均不因溶剂不同而异.如果我们认为X—P—Y化合物的发光强度变化和其中心的卟啉大环上的π电子云密度偏移有规律性的关联,那么上述的一些取代基效应是可以理解的.进而,我们认为:本文所报导的事实将有助于充实巧妙设计高效利用太阳能的分子体系的科学依据.     

钢丝绳断丝定量检测中径向随机晃动误差的补尝

本文论述了钢丝绳断丝定量检测中径向随机晃动误差存在的必然性及该误差对定量检测的影响,基于模拟实验结果,给出了适用于多种类型钢丝绳的V_H-S数学关系式;提出了波形因素的概念与形式,并用软件实现了钢丝绳断丝定量检测中径向随机晃动误差的补偿。     

用焓法有限元解相变问题的离散化方法

为了消除应用焓法进行含有相变的有限元传热计算结果呈台阶形的现象,本文作者提出“焓计算单元”和“固相分数”的概念,并将几种一维有限元实施方案的计算结果与精确解对比,说明采用所提出的概念,可以使有限元计算得出更为合理的结果。