不同色浆质量分数的水性聚氨酯涂料对聚氯乙烯表皮低温爆破性能的影响

本文制备了一系列不同色浆质量分数的水性聚氨酯涂料,并将其喷涂在汽车仪表板聚氯乙烯(PVC)表皮的背面形成复合材料。 用旋转流变仪表征了涂料的粘度以评价其喷涂性能;用差示扫描量热仪表征了材料的玻璃化转变温度(T_g);利用万能材料试验机表征了材料在-30 ℃条件下的拉伸性能及抗撕裂性能;用动态热机械分析仪表征了材料的损耗比随温度的变化。 结果表明:不同色浆质量分数的涂料都能喷涂,含有涂层材料PVC表皮在-30 ℃低温爆破性能与涂层材料的T_g、低温拉伸性能、抗撕裂性能的关系并不大,而与涂层材料的阻尼性能直接相关。 材料的阻尼性能越好,其低温爆破性能越好。     

典型全氟有机酸类化合物的样品前处理与分析方法研究进展

全氟辛烷磺酸（PFOS）和全氟辛烷羧酸（PFOA）是两种典型的全氟有机酸类化合物,也是全氟化合物（PFCs）前体物的最终降解产物,具有肝毒性、胚胎毒性、生殖毒性、神经毒性,检出率最高。在各种被污染的介质中,PFOS和PFOA含量往往很低,基体复杂多样,快速高效的样品前处理技术成为测定的关键环节。目前,国际上对PFOS和PFOA的测定无统一标准,而我国关于PFCs的分析研究落后于国际发展水平。该文介绍了PFOS和PFOA的特性,系统总结和评述了前处理技术（液液萃取、固相萃取、固相微萃取、超声萃取和QuEChERS法）及分析方法（色谱-质谱方法、光谱法、酶联免疫法和电化学法）,以期为PFOS和PFOA的分析监测及标准制定提供参考。     

双金属氮化物Co3W3N/CNTs纳米复合材料的制备及其室温常压氮还原性能

采用水热法并经氨气保护热处理制备了双过渡金属氮化物Co3W3N/CNTs复合材料,得到了价格低廉且拥有良好氮电化学还原性能(NRR)的催化剂。通过调节已经预氧化的CNTs与过渡金属氮化物前驱体CoWO4的比例以及氨气热处理温度,实现了Co3W3N在CNTs表面的均匀负载。扫描电子显微镜(SEM)及透射电子显微镜(TEM)测试结果显示该电化学活性纳米微粒均匀地分散于CNTs表面,表明经预氧化的CNTs由于表面富集了较多的活性基团,有利于双过渡金属氮化物的分散生长。热处理后CNTs表面的Co3W3N微粒尺寸约为20 nm,相较于无载体的Co3W3N尺寸(100 nm)有明显减小。室温条件下,在N2饱和的0.01 mol·L^-1 H2SO4溶液中测试了该纳米复合材料在不同过电位下的NRR,该材料在-0.3 V(vs RHE)时的产氨率及法拉第效率分别可达12.73μg·h^-1·cm-2和13.59%,对比同样条件下,纯相Co3W3N的产氨率及法拉第效率仅为1.08μg·h^-1·cm^-2和1.76%。结果表明,通过水热反应和氨气保护热处理的Co3W3N/CNTs纳米复合材料具有良好的NRR性能。     

介孔SBA-15棒负载的Pd3Cl催化剂催化Sonogashira偶联反应（英文）

通过静电吸引策略将具有高度分散性的原子精确纳米团簇[Pd3Cl(PPh2)2(PPh3)3]+(Pd3Cl)负载在介孔SBA-15棒上。结构明确的Pd3Cl/SBA-15催化剂在以水作为溶剂以及温和的反应条件下对催化Sonogashira碳-碳偶联反应展现了较好的催化性能以及循环性。在此基础上,我们研究了Pd3Cl团簇结构与性能之间的关系,并证实内核的Pdδ+(0<δ<2)与配体之间的协同效应是催化反应的关键。     

Preparation of MnO2 Loaded Hydrothermal Carbon-coated Electrospun PAN Fiber Membranes for Highly Efficient Adsorption and Separation of Cationic Dye

Hydrothermal carbonaceous materials and MnO₂ have been proved to be promising adsorbents to remove organic dyes from wastewater. In this study, flexible MnO₂ loaded hydrothermal carbon-coated electrospun poly-acrylonitrile(AC/MnO₂/PAN) fiber membranes were fabricated by a facile one-step hydrothermal method and activated by NaOH solution. The composite fibers exhibited large adsorption capacity toward cationic dyes and excellent mechanical properties. The adsorption performance can be fitted well with pseudo-second-order model and Langmuir isotherm model. The maximum adsorption for methylene blue(MB), methyl violet(MV) and malachite green(MG) are 1173.27,1106.31 and 1129.89 mg/g, respectively, according to Langmuir fitting. The AC/MnO₂/PAN fiber membrane also showed satisfactory performances for selective adsorption and recyclability. In addition, based on selective adsorption, the AC/MnO₂/PAN fiber membranes that are repulsive to the anionic dye methyl orange(MO) can separate the MB/MO mixture solution by dynamic filtration. Thus, this work not only provides a facile strategy to fabricate large capacity adsorbents, but also demonstrates the potential applications in the dye wastewater treatment field.     

Preparation and characterization of n-octadecane-based reversible gel as form-stable phase change materials for thermal energy storage

Journal of Thermal Analysis and Calorimetry - In this study, a series of gelators (Gn, n is the number of carbon atoms of used fatty alcohol, n?=?2, 4, 6, 8, 10, 12, 14, 16 and 18) were...     

Determination of carbapenems in water samples by UHPLC–MS/MS

A rapid and reliable method for the detection of five carbapenems (biapenem, imipenem, doripenem, meropenem, and faropenem) in water was developed and validated. After acidification of water samples with acetic acid, carbapenems were isolated using a Bond Elut PPL cartridge. The target compounds were separated using ultra high performance liquid chromatography with a chromatographic run time of 5 min and detected on a triple quadrupole mass spectrometer operated in positive electrospray ionization and multiple reaction monitoring mode. Mean recoveries were in the range of 76.6–106.5%, with satisfactory intraday and interday relative standard deviations lower than 10.0 and 10.8%, respectively. The limits of detection and quantification were in the ranges of 0.05–0.2 µg/L and 0.1–0.5 µg/L, respectively, depending on the analyte. The proposed method was applied to the analysis of river samples and wastewater samples from swine farms, and no carbapenems were detected in the collected samples.     

Comprehensive separation of iridoid glycosides and triterpenoid saponins from Dipsacus asper with salt‐containing solvent by high‐speed countercurrent chromatography coupled with recycling mode

The roots of Dipsacus asper Wall as a commonly used traditional Chinese medicine are used for tonifying liver and kidney and strengthening bones and muscles. However, an effective separation strategy for comprehensive and rapid separation of the main active compounds from the roots of D. asper is nonexistent. This investigation provided an effective separation method based on AB‐8 macroporous resin column chromatography using different ratios of ethanol in water and two different modes of high‐speed countercurrent chromatography with salt‐containing solvent system for rapid enrichment and separation from the roots of D. asper. The macroporous resin column chromatography was performed on AB‐8 resin using ethanol in water ratios of 10, 30, 40, 50, and 80% as the optimized enrichment conditions for iridoid glycosides and triterpenoid saponins with different polarities. For high‐speed countercurrent chromatography separation, the conventional and recycling modes were combined together to develop a strategy for 12 compounds ( 1 – 12 ) from the enriched parts of 30, 40, and 80% ethanol, including six high‐polarity iridoid glycosides ( 1 – 6 ) using inorganic salt‐containing solvent system and six triterpenoid saponins ( 7 – 12 ). Recycling high‐speed countercurrent chromatography separation was successfully applied to separate two isomers ( 9 and 10 ) after 11 cycles.     

Families of gap solitons and their complexes in media with saturable nonlinearity and fractional diffraction

Nonlinear Dynamics - We demonstrate the existence of various types of gap localized modes, including one- and two-dimensional (1D and 2D) single solitons and soliton clusters, as well as the...     

内蒙古地区4种林分类型UVB屏蔽效应研究

选取内蒙古大兴安岭地区和呼和浩特市兴安落叶松、油松、樟子松和白杆4种典型针叶林,利用PC-2型太阳辐射记录仪进行UVB辐射日进程测定,以获得4种典型性针叶林的UVB屏蔽效应;对4种林分UVB屏蔽效率与枝下高、郁闭度等冠层特征因子进行相关分析.结果表明,(1)4种林分对UVB辐射均产生显著消减作用,其屏蔽效应分别为:落叶松(91.2%)、白杆(90.2%)、油松(88.9%)、樟子松(88.2%);但林分类型和时间段的不同对UVB的屏蔽效应均无显著影响.(2)UVB屏蔽效应与林分郁闭度呈正相关关系,相关系数0.635,与冠层呈负相关关系,相关系数0.966,而与林分平均树高,平均枝下高相关性不显著.