Mechanical properties of polyester polymer-concrete

The properties of a polymer-concrete composed of polyester matrix and locally available rock aggregate are investigated. The formula of the concrete is found by an experimental-calculation approach in such a way as to attain a closer packing of the aggregate particles on the one hand, and to ensure the needed processing characteristics (placeability) of the mix on the other. It is shown experimentally that the material obtained has a rather high compression strength. Under prolonged compression loads, the polymer-concrete exhibits a noticeable creep behavior with a linear relation between the creep strains and stresses. After the action of half the ultimate load over 3000 h, the total strains exceed the instantaneous ones by 2.0 to 2.2 times. The accumulation of irreversible strains is also observed; however, their contribution to the total strain is small. It is found that the stress-strain relation can be represented by the equation of linear hereditary creep theory.Institute of Polymer Mechanics, University of Latvia, Riga, LV-1006, Latvia. Translated from Mekhanika Kompozitnykh Materialov, Vol. 35, No. 2, pp. 147–162, March–April, 1999.     

Selective photoconductivity induced in PbTe(Ga) by a local phonon mode

Selective photoconductivity at frequency ω=155 cm⁻ was discovered in PbTe(Ga) narrow-gap semiconductors at liquid-nitrogen temperatures. The corresponding energy is much lower than all characteristic energies of the electronic spectrum of the semiconductor. The effect is attributed to optical excitation of a local vibrational mode of an impurity center leading to delocalization of the electrons. Pis’ma Zh. éksp. Teor. Fiz. 63, No. 5, 342–346 (10 March 1996)     

Application of differential electrolytic potentiometry for detection in flow injection analysis

The applicability of differential electrolytic potentiometry as a detection system in flow injection analysis is investigated. A computer-controlled injector which delivers precise volumes of sample solutions in a reproducible manner was developed. Conditions such as current density employed, the concentrations of the solutions used and the flow rate were optimized. Chloride in water was determined by means of this system. The relation between chloride concentration and the measured signal was found to be Nernstian for solutions of concentrations above 6 μg ml⁻¹ chloride. For solutions below this concentration, the relation is linear.     

GIPKh catalysts

In the Russian Scientific Center Applied Chemistry catalysts have been developed for the gas-phase fluorination of organics, including chlorine-containing substances, hydrogenation and reductive amination of organic substances, decomposition of liquid substances to gases, complete oxidation and reduction, suitable for environment at protection.     

Investigation of the conditions for feeding filamentary silicon crystals,growing in a reactor with hot walls

An estimate of the factors which influence the rate of growth of filamentary silicon crystals in a standard chloride system using a quartz reactor with hot walls is given. It is shown that a diffusion form of crystallization is observed under the conditions investigated.Voronezh State Technical University. Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 10, pp. 22–26, October, 1995.     

Numerical integration of ordinary differential equations on manifolds

Summary This paper is concerned with the problem of developing numerical integration algorithms for differential equations that, when viewed as equations in some Euclidean space, naturally evolve on some embedded submanifold. It is desired to construct algorithms whose iterates also evolve on the same manifold. These algorithms can therefore be viewed as integrating ordinary differential equations on manifolds. The basic method “decouples” the computation of flows on the submanifold from the numerical integration process. It is shown that two classes of single-step and multistep algorithms can be posed and analyzed theoretically, using the concept of “freezing” the coefficients of differential operators obtained from the defining vector field. Explicit third-order algorithms are derived, with additional equations augmenting those of their classical counterparts, obtained from “obstructions” defined by nonvanishing Lie brackets.     

Phasenbeziehungen und Natriumionenleitung im quasi-binären System Na2SiF6/Na3AlF6

Phase Relations and Sodium Ion Conductivity within the Quasi-binary System Na₂SiF₆/Na₂AIF₆ . The phase diagram of the Na₂SiF₆/Na₃AlF₆ system has been determined by means of x-ray powder diffraction, thermal analysis and conductivity measurements in the sub-solidus region. Na₃AlF₆ accomodates up to 73 mol.-% Na₂SiF₆ maintaining the crystal structure type. The sodium ion conductivity increases by about five orders of magnitude upon doping Na₃AlF₆ with Na₂SiF₆.     

The lead tetraacetate oxidation of bisacylhydrazones of α-diketones: A scope re-assesment

Oxidation of the title compounds yields, besides the reported isoimides 3 and/or the amides 4 , also the imides 5 . The observed product dichotomy is considered as the result of an intramolecular nucleophilic attack on the aroyl group, of the pressumed zwitterionic intermediate 2 , by O or N present in the ambident N-aroylimine site of 2 . The results of AM1 calculations agree with the product studies and both permit the formulation of a set of rules correlating structure and selectivity.     

Spin effects in instanton models

Nonperturbative nolocal structure of QCD vacuum is well described by instanton model. Specific helicity and flavor structure of zero modes of quarks, in instanton field allows simultaneously to explain some important features of low-and high-energy hadron phenomemology. The basic characteristics of hadron spectrum, partonic sum rules, heavyquark potential etc within the instanton liquid model are briefly discussed.