芦荟中多糖的光度测定新方法

利用正交试验考察了芦荟多糖与刚果红显色反应的最佳条件；研究了麦芽糖糊精等多糖、蔗糖等低聚糖和葡萄糖等单糖对显色反应的影响；建立了简便快速、常见糖类基本无干扰的测定芦荟多糖含量的吸光光度法。对芦荟鲜叶和芦荟制品中的多糖进行分析，加标回收率在92％～96％范围内，相对标准偏差≤5％。     

Mitigation of Jahn–Teller distortion and Na+/vacancy ordering in a distorted manganese oxide cathode material by Li substitution

Layered manganese-based oxides are promising candidates as cathode materials for sodium-ion batteries (SIBs) due to their low cost and high specific capacity. However, the Jahn–Teller distortion from high-spin Mn³⁺ induces detrimental lattice strain and severe structural degradation during sodiation and desodiation. Herein, lithium is introduced to partially substitute manganese ions to form distorted P′2-Na_0.67Li_0.05Mn_0.95O₂, which leads to restrained anisotropic change of Mn–O bond lengths and reinforced bond strength in the [MnO₆] octahedra by mitigation of Jahn–Teller distortion and contraction of MnO₂ layers. This ensures the structural stability during charge and discharge of P′2-Na_0.67Li_0.05Mn_0.95O₂ and Na⁺/vacancy disordering for facile Na⁺ diffusion in the Na layers with a low activation energy barrier of ∼0.53 eV. It exhibits a high specific capacity of 192.2 mA h g⁻¹, good cycling stability (90.3% capacity retention after 100 cycles) and superior rate capability (118.5 mA h g⁻¹ at 1.0 A g⁻¹), as well as smooth charge/discharge profiles. This strategy is effective to tune the crystal structure of layered oxide cathodes for SIBs with high performance.

Li-Substitution in P′2-Na_0.67MnO₂ mitigates the anisotropic change of Mn–O bonds and Na/vacancy ordering, and hence significantly promotes its cycling stability and rate capability as a cathode material for sodium-ion batteries.     

Underpotential Deposition Study and Determination of Bismuth on Gold Electrode by Using Voltammetry

ＴｈｅｃｏｍｂｉｎａｔｉｏｎｏｆｓｔｒｉｐｐｉｎｇｖｏｌｔａｍｍｅｔｒｙｗｉｔｈＵＰＤｃａｎｌｅａｄｔｏｔｈｅｉｍｐｒｏｖｅｍｅｎｔｏｆｓｅｎｓｉｔｉｖｉｔｙ ,ｓｅｌｅｃｔｉｖｉ ｔｙａｎｄｒｅｖｅｒｓｉｂｉｌｉｔｙｆｏｒｅｌｅｃｔｒｏａｎａｌｙｔｉｃａｌｐｕｒｐｏｓｅａｎｄａｖｏｉｄｔｈｅｕｓｅｏｆｔｏｘｉｃｍｅｒｃｕｒｙａｓｔｈｅｗｏｒｋｅｌｅｃｔｒｏｄｅ1ａｎｄｔｈｅｎａｎａｌｙｔｉｃａｌａｐｐｌｉｃａｔｉｏｎｓｈａｖｅｂｅｅｎｄｅｓｃｒｉｂｅｄ .2 4 Ｉｎｔｈｉｓｗｏｒｋ ,ｗｅｄｅｖｅｌｏ…     

Rheological Behavior for Mica-filled Polypropylene Composite Melts

The study on rheological properties of a series of mica-filled polypropylene (PP) composites was carried out. The influence of surface-treatment of mica particles on dynamic rheological behavior of the composites were dealt with. The viscosity (η) and dynamic modulus ( G‘ ) of the composite melts were higher than those of PP matrix, especially those for systems treated with silane, which was attributed to the interfacial adhesion enhancement. However, surface-treatment of mica by titanate resulted in lower η and G‘, as compared with the treatment by silane. The reason for this is believed to be the formation of the mono-molecular layer on the mica surface.     

α, α'-二胺基二苄基硒醚的合成

本文以苯骈三氮唑、胺和苯甲基醛为原料,发现Mannich反应,生成胺烷基化的苯骈三氮唑衍生物。在此衍生物中,苯骈三氮唑基是亲核取代反应的良好离去基团,易被强亲核试剂的硒负离子取代,生成对称α,α'-二胺基二苄基硒醚。反应易进行,产率较高,产物均为固体,易提纯。这是合成含氮原子的对称硒醚的较好方法。     

二硫化锡基钠离子电池负极材料的研究进展

二硫化锡由于其理论容量高、氧化还原电位合适，而成为钠离子电池负极材料的研究热点之一。从纯二硫化锡、二硫化锡/碳复合物和二硫化锡/石墨烯复合物等3个方面对二硫化锡负极材料在近5年的发展进行了概述。     

Determination of the apparent standard potential of the Dy/Dy(Ⅲ) system in the LiCl-KCl eutectic

The apparent standard potential of Dy/Dy(III) system in the LiCl-KCl eutectic has been determined by the logarithmic analysis of the semi-integrals of voltammograms, logarithmic analysis of chronopotentiograms and the open circuit potentiometry. The dysprosium equilibrium potentiab for various concentration of dysprosium chloride in the LiCl-KCl eutectic melt between 400-500℃ were first determined experimentally, and the apparent standard potential of this system and its temperature dependance have been calculated.     

脲衍生物对环氧树脂/双氰双胺固化体系潜伏性促进作用研究

本文用DSC、TBA、旋转粘度计等手段对一系列不同结构及不同取代基取代的脲衍生物对环氧树脂/双氰双胺固化体系的潜伏性促进作用作了考察。结果表明,其促进效果随脲的α位取代烷基碳原子数增加而减弱,而其β、γ位上的取代基团变换时对促进作用无明显影响。由此得出4,4-二(N,N-二甲基)脲二苯甲烷(简称M-二甲)和2,4-二(N,N-二甲基)脲甲苯(简称T-二甲)二种脲衍生物在本丈所考察的28种化合物中具有最显著的促进效果,其中T-二甲的促进活性略高于M-二甲,它们均可使上述固化体系的固化温度降至130℃左右,含有此促进剂的固化体系即使在30℃下贮存,其粘度保持基本不变的时间仍可达三个月以上。     

DNA分子在气液界面的组装相变特性及其LB膜结构研究

对十八胺与DNA在气液界面上组装及其相变过程进行了研究，利用AFM观察了不 同压力下转移的DNA复合LB膜结构。发现在低表面压时，DNA复合单分子膜表现为技 术发散的分形结构；随着压力的升高，DNA复合膜逐渐由紧密的网状排布结构变为 团聚的块状和团簇结构。表明通过调节膜压，可使膜内DNA分子的构象发生大的变 化，从而生成具有特定形态的二维纳米图案。这种具有特殊形态和结构的DNA LB膜 可望为合成新型生物纳米结构有序功能体系提供模板。     

锂在共轭双键高分子中的电化学嵌入反应III. 锂嵌入聚噻吩的量子化学计算†

采用Gaussian软件和HF方法, 通过从头计算(ab initio)法选取4-31G基组计算锂离子嵌入聚噻吩过程中结构与结合能的变化关系. 发现噻吩聚合时主要生成三或四聚合物. 聚合物在Li原子(或Li^＋离子)嵌入后, 聚噻吩间距离明显变小, 同时发生电荷转移, 形成稳定嵌合物; 并使噻吩环的C-α—C-β键级变小. 同时, 研究了锂离子(或原子)嵌入后体系的HOMO, LUMO能级. 聚噻吩在嵌入锂离子时LUMO轨道能级变为负值, 成为电池反应得电子的正极. 而金属Li₂ 释放Li^＋后的Li^－的HOMO能级为＋0.7427 eV, 则成为给电子的负极. 由此, 可以完成由锂/聚噻吩在高氯酸锂电解质中组成的放电过程, 并提出嵌合键级概念用来表征锂在聚噻吩间的结合程度.