Extraction of Americium(III) and Europium(III) with Two Open-Chain Crown Ethers of Amide Type

The extraction of Am³⁺ and Eu³⁺ from aqueous picric acid solution by N, N-dinaphthyl-N, N-diphenyl-3,6-dioxaoctanediamide (L^I) and 1, 1-(3, 6, 9-trioxaundecanedionyl)diphenothiazine (L^II) was investigated by a radioactive tracer technique. Extraction distribution ratios of Am³⁺ and Eu³⁺ have been measured as a function of pH, picric acid concentration, extractant concentration, diluent and temperature. The extraction of Am³⁺ is preferred to that of Eu³⁺ for both L^I and L^II, and the latter gives larger separation factor than the former. The equilibrium constants and thermodynamic parameters of extraction reactions were also calculated.     

聚甲醛自然老化的SEM研究

对户外曝晒3～36个月的聚甲醛(POM)老化形态进行了研究,讨论了老化层厚度,裂纹宽度、裂纹深度及断口形态与老化时间的关系。结果表明:POM的老化导致了材料内部结构由韧性变成脆性而几乎完全丧失物理机械性能。     

溶剂萃取法制备碳酸盐的热力学讨论

向金属氯化物(Ⅰ)的水溶液中通入CO_2气体,以期制备相应的碳酸盐和酸式碳酸盐,在常温常压下,体系的△G>0,反应几乎是不可能的。向反应体系中加入有机溶剂(S),使生成的HCl即被萃取,可促进Ⅰ的继续转化。分析计算表明,S对HCl必须有很强的萃取能力,其K_萃须在10~5以上。研究了加入有机溶剂N_(235)前后,体系的热力学状态、函数及其变化。加入N_(235)后,K_萃值增大了5个数量级。考察了温度、时间和通气次数对系统热力学性质的影响。根据反应的耦合原理和热力学分析,提出萃取剂选择的原则。结合实验数据的估算说明:溶剂萃取法由Ⅰ和CO_2制备碳酸盐的工艺路线是可行的。     

涂层对热电偶热电性能及大气中寿命的影响

在难熔金属热电偶表而施加涂层的目的,旨在使原仅限和真空、中性及还原气氛中测量的热电偶能在大气中使用.本文讨论涂层对难熔金属热电偶在氧化气氛的"热电势—温度","热电势—时间"的关系及其寿命的影响.具有涂层的W/M.热电偶在氧化气氛(常压下1500℃取得263小时±1%t的最高记录,而W-Re热电偶存1500℃试验的前70小时偏差也在1%t内.而没有涂层的热电偶仅支持数分钟便破坏.     

THE SEPARATION,PURIFICATION AND DECOLORIZATION OF NEW ANTIBIOTICS-MILUPEINAN USING ADSORPTION RESIN

1. INTRODUCTION Fig.1 The Chemical Structure of Milupeinan As a new type of antibiotics Milupeinan, not only possesses antibacterial activities against a wide range of Gram-positive and Gram-negative bacteria, but also higgh stability under th…     

微乳液介质—1—（2—吡啶偶氮）—2—萘酚光度法测定汽油中环烷酸铁的含量

本研究了微乳液为介质时，铁与１－（２－吡啶偶氮）－２－萘酚（ＰＡＮ）的显色反应。选择７３０ｎｍ处为测定波长，ε为１．４×１０＾４Ｌ．ｍｏｌ＾－＾１．ｃｍ＾－＾１，铁量在０－５０μｇ／２５ｍｌ范围内符合比耳定律，该法适用于汽油中环烷酸铁的测定。     

One-pot synthesis of N-protected α-amino aldehyde acetals from three-component reaction of fluoroalkanesulfonyl azide, vinyl ether and alcohol

A facile one-step method has been developed for the synthesis of N-protected α-amino aldehyde acetals in moderate to good yields by three-component reaction of fluoroalkanesulfonyl azides, vinyl ethers and alcohol at 0 °C within 10 min. This practical synthetic method provides a convenient and expeditious access to N-per(poly)fluoroalkanesulfonyl α-amino aldehyde acetals.     

Synthesis of gramicidin S and its analogues via an on-resin macrolactamization assisted by a predisposed conformation of the linear precursors

A simple and efficient preparation of gramicidin S and its analogues is described. It involves solid-phase peptide synthesis and on-resin macrolactamization without side chain protection, affording cyclic products in high yield and high purity. The high specificity of the cyclization reaction was shown to originate in the formation of a pre-organized conformation of the linear biosynthetic precursor of gramicidin S. This facile method will provide convenient access to the analogues of the natural product for functional optimization to counter microbial resistance.     

Method development for the quantitation of ABT-578 in rabbit artery tissue by 96-well liquid-liquid extraction and liquid chromatography/tandem mass spectrometric detection

Quantitative determination of drug concentrations in tissue samples can provide critical information for drug metabolism, kinetics, and toxicity evaluations. For analysis of tissue samples using liquid chromatography/tandem mass spectrometric (LC/MS/MS) detection, homogenization is a critical step in achieving good assay performance. Assay performance can be closely evaluated by spiking the drug directly into tissue samples prior to homogenization. It is especially important to include this assay evaluation for the analysis of artery tissue samples because artery tissue is very elastic, making it quite a challenge to develop an effective procedure for homogenization. An LC/MS/MS assay in 96-well format using liquid-liquid extraction was developed for analyzing ABT-578 in rabbit artery samples. Tissue quality control samples were prepared by spiking ABT-578 stock solutions directly into the tissue before homogenization. The usage of the tissue control samples gives a thorough evaluation of the sample preparation process that includes both homogenization and sample extraction. A 20% blood in saline solution was used as a homogenization solution. Calibration standards were made by spiking ABT-578 into rabbit whole blood. Blood quality control samples were also prepared by spiking ABT-578 into rabbit whole blood. These blood QC samples were used to confirm the validity of the calibration curve. A lower limit of quantitation of 0.050 ng/mL was achieved. The linear dynamic range of blood standards was from 0.050-30.3 ng/mL with the correlation coefficient (r) ranging from 0.9969-0.9996. Overall %CV was between 1.3 and 7.0%, and analytical recovery was between 98.2 and 105.8% for blood QC samples. The %CVs for tissue QC samples were between 6.7 and 13.0%, and analytical recovery after correction was between 93.5 and 114.3%.     

苯丙水溶胶的合成与性能研究(I) 聚合工艺和反应组分对聚合稳定性和胶体性能的影响

用一次投料法、半连续滴加法和单体预乳化法三种聚合工艺，合成了苯丙乳液聚合物，并加氨微细化，转化成水溶胶，考察了聚合工艺和反应组分（乳化剂，功能单体等）对苯丙乳液及其水溶胶反应稳定性和粒子大小及分布等胶体性能的影响。