Heat transfer from a rarefied plasma flow to a metallic or nonmetallic particle

Heat transfer from a plasma flow to a metallic or nonmetallic spherical particle is studied in this paper for the extreme case of free-molecule flow regime. Analytical expressions are derived for the heat flux due to, respectively, atoms, ions, and electrons and for the floating potential on the sphere exposed to a two-temperature plasma flow. It has been shown that the local or average heat flux density over the whole sphere is independent of the sphere radius and approximately in direct proportion to the gas pressure. The presence of a macroscopic relative velocity between the plasma and the sphere causes substantially nonuniform distributions of the local heat flux and enhances the total heat flux to the sphere. The heat flux is also enhanced by the gas ionization. Appreciable difference between metallic and nonmetallic spheres is found in the distributions along the oncoming flow direction of the floating potential and of the local heat flux densities due to ions and electrons. The total heat flux to the whole sphere is, however, almost the same for these different spheres. For a fixed value of the electron temperature, the heat flux decreases with increasing temperature ratio T_e/T_h.     

Growth of porous single-crystal Cr2O3 in a 3-D mesopore system

Single-crystal Cr2O3 with regular mesopores has been synthesized using mesoporous silica KIT-6 as a template and characterized by using XRD, HRTEM and nitrogen adsorption/desorption.     

稀土掺杂的(K, Sr)Cl·SiO2复合凝胶的荧光性能

采用sol gel法制备了单掺铕及共掺铕、铈的(K,Sr)Cl·SiO2复合凝胶,研究了复合凝胶的荧光性能。根据荧光测试结果,复合凝胶中,Eu3+在没有还原剂的作用下,可以与基质作用形成还原态的Eu2+,复合凝胶表现出相应的Eu2+荧光性能;研究认为,Ce3+,Eu3+共掺杂时,复合凝胶激发光谱与发射光谱峰位基本不变,但强度有所不同。330nm处的激发光谱明显增强,且发射光谱随Ce3+的掺杂量增加而增强。当Ce3+掺杂浓度为3.0%(原子分数)时,复合凝胶具有最大的荧光发射强度,表明Ce3+具有很好的敏化作用。在Ce3+,Eu3+共掺杂复合凝胶体系中,复合凝胶荧光强度增大的原因既可能是电子转移过程,也可能是Ce3+→Eu2+的能量传递过程所致。     

Ge—132对小鼠H22肝癌移植瘤的影响

Ｇｅ－１３２对小鼠Ｈ２２肝癌移植瘤的实验研究证明：１．Ｇｅ－１３２对Ｈ２２肝癌移植瘤有一定的抑制作用，３００ｍｇ／ｋｇ体重剂量抑瘤率达到３６．１９％；２．增强机体的抗氧化作用，抑制脂质的过氧化物水平；３．促进免疫功能，当Ｇｅ－１３２和环磷酰胺联合使用时，可抵抗环磷酰胺的免疫抑制作用，而且并不减弱其抑制瘤作用。     

Light-emitting diode-induced fluorescence detection of native proteins in capillary electrophoresis

A continuous-wave 280 nm light-emitting diode (LED) was used as the excitation source for native fluorescence detection of proteins in CE. The operating current and temperature of the LED were optimized in order to achieve high luminescence power. It was found that a forward current of 30 mA and a temperature of approximately 5 degrees C gave the best S/N. By using a set of two ball lenses to focus light from the LED, we achieved a spot of approximately 200 mum with a power of 0.1-0.2 mW on the detection window. Fluorescence was collected with a ball lens at 90 degrees angle through a bandpass filter onto a photomultiplier tube. In CZE an LOD of 20 nM for conalbumin was reached. In capillary gel electrophoresis all eight proteins from a commercial standard kit were detected with high S/N. For a 10 microg/mL total protein mixture, S/N was better than 3 for all proteins in solution. Further improvement in LOD should be possible on utilization of an LED with higher luminescence power.     

Electrochemical properties and synthesis of LiAl0.05Mn1.95O3.95F0.05 by a solution-based gel method for lithium secondary battery

The cathode materials, LiMn₂O₄, LiAl_0.05Mn_1.95O₄ and LiAl_0.05Mn_1.95O_3.95F_0.05 were firstly prepared by a simple solution-based gel method using the mixture of acetate and ethanol as the chelating agent. The synthesized samples were investigated by X-ray diffraction, scanning electronic microscope and differential and thermal analysis. The as-prepared powders were used as positive materials for lithium-ion battery, whose discharge capacity and cycle voltammogram properties were examined. The results revealed that LiAl_0.05Mn_1.95O_3.95F_0.05 synthesized by the solution-based gel method had higher initial capacity than LiAl_0.05Mn_1.95O₄ and better capacity retention rate (92%) than that of LiAl_0.05Mn_1.95O₄ and LiMn₂O₄, which revealed that Al and F dual-doped LiMn₂O₄ could gain better electrochemical properties of LiMn₂O₄ than only the Al-doped LiMn₂O₄.     

黄烷类衍生物的合成及其生物活性研究

An efficient and feasible synthetic approach was developed for the synthesis of an array of new flavane derivafives from the substituted benzaldehyde with the reduction of chalcones and subsequent cyclization as the key steps. The purity and structure of the products were confirmed by the elemental analysis and a combination of its IR, ^1H and ^13C NMR, and mass spectra. These synthetic compounds were tested for xanthine oxidase （XO） inhibitions and antifungal actions against Candida albicans, Cryptococcus neoformans, Aspergillus sp. and Trichophyton rubrum. 7-Hydrazinocarbonylmethoxy-4＇-methoxyflavane （9） was found to be the most XO inhibitory with IC50=76.4 μmol/L, and the most potent antifungal compound was 4＇-hydrazinocarbonylmethoxyflavane （12） with minimal inhibition concentration MIC=8 μg/mL against Trichophyton rubrum.     

Study the reactions of fluoroalkanesulfonyl azides with N-alkylindoles

The reactions of fluoroalkanesulfonyl azides R_fSO₂N₃1 with N-alkylindoles 2 have been studied in detail. It was found that both solvent and the amount of the azides seriously affected the product distribution. 1 reacted with equimolar of 2 in ether or 1,4-dioxane affording 2-(N-substituted-indolinylidene)fluoroalkane sulfonylimines 3 as major product; While, treatment of 2 with 2 equiv. of 1 in ethanol, an unexpected product N-substituted-2-fluoroalkanesulfonimino-3-diazo-indolines 4 were obtained in good yield. The reaction mechanism was discussed.     

Prepared Low Stress Cubic Boron Nitride Film by Physical Vapor Deposition

We present low stress cubic boron nitride (cBN) films with a transition layer deposited on the metal alloy substrates by tuned substrate radio-frequency magnetron sputtering. The films were characterized by Fourier transform infrared spectroscopy and transmission electron microscopy (TEM). The IR peak position of cubic boron nitride at 1006.3 cm⁻¹, which is close to the stressless state, indicates that the film has very low internal stress. The TEM image shows that pure CBN phase exists on the surface of the film. Several phases of boron nitride were found at the medium implantation dose. It is believed that the transition from the low ordered phases to cBN phase occurred during implantation.     

Spectrophotometric determination of microamounts of scandium with o-chlorophenylfluorone and cetyltrimethylammonium bromide

The reaction of scandium(III) with o-chlorophenylfluorone (o-CIPF) in the presence of cetyltrimethylammonium bromide (CTMAB) has been studied. In an acetate buffer at pH 4.4, a red-purple complex is obtained, with maximum absorption at 569 nm and a molar absorptivity of 1.31 x 10(5)1.mole(-1).cm(-1). The composition of the complex is found to be 1:2:2 Sc-o-CIPF-CTMAB. Beer's law is obeyed over the range 0-12 mug/25 ml scandium. The proposed method has been used for determination of trace scandium in tungsten ores after its prior separation by solvent extraction.