All-optical broadcast and multicast technologies based on PPLN waveguide

All-optical 1 ×4 broadcast and 1 ×3 multicast experiments of a 40-Gb/s return-to-zero on-off keying （RZ- OOK） signal based on a periodically poled lithium niobate （PPLN） waveguide are demonstrated in this letter. Clear opened eye diagrams and error-free performance are achieved for the broadcast signals at 1541.3, 1543.7, 1548.5, and 1550.9 nm. Multicast technology uses cascaded second-harmonic generation and difference-frequency generation in a Ti：PPLN waveguide. An error-free operation with a negligible power penalty is achieved for the three wavelength-division multiplexing multicast signals at 1533, 1537, and 1541 nm.     

基于X射线的空间语音通信系统

提出了栅控X射线源作为发射器和基于微通道板的X射线单光子探测器作为接收器的X射线通信方案. 搭建了基于X射线的空间语音通信系统, 详细介绍了信号调制发射器、基于微通道板的X射线单光子探测器及信号接收解调器的设计及工作原理. 报道了基于X射线的空间语音通信系统的初步实验结果, 实现了优于20 kbit/s的基于语音信号调制的X射线通信. 实验分析了在不同X射线强度、信号整形时间和阈值设置下通信性能影响, 得出了X射线发射功率限制X射线通信速率的结论, 提出了下一步提高X射线通信性能的改进方案. 关键词： X射线通信 X射线源 探测器     

Theoretical analysis of the performance of a single side band multicarrier source based on a re-circulating frequency shifter influenced by an optical bandpass filter

An optical bandpass filter （OBF） is an important element whose properties considerably influence the output performance of a single side band multicarrier source based on a re-circulating frequency shifter. The influence of the OBF in the loop on the output spectrum is theoretically analyzed. Numerical simulations and experiments are Mso carried out. Results show that the steepness and deepness of a nonflat-top filter influence the stability of the spectrum of an output multicarrier. To obtain multicarrier output with tone to noise ratio （TNR） 〉26 dB and error vector magnitude （EVM） 〈0.25, the steepness ratio of the filter should be greater than 0.75 and deepness should be larger than 0.99.     

Diode-Side-Pumped Passively Q-Switched Mode-Locked 532 nm Laser with a Nd:YAG/Cr4+:YAG/YAG Composite Crystal

We present a diode-side-pumped Q-switched mode-locked (QML) laser operating at 532 nm for the first time employing a composite crystal Nd:YAG/Cr⁴⁺:YAG/YAG and a KTP. The experimental results show that, using a suitable cavity and crystals, one can obtain high-quality QML laser output at 532 nm with a side-pumped system. We measure and analyze the QML performance of the fundamental frequency laser and the green laser. Under a pump power of 127 W, we obtain a QML laser operating at 532 nm with an average power of 4.97 W and a repetition rate of 0.2 GHz for the mode-locked pulses; the corresponding depth of modulation is close to 100%.     

非最小偏向角测棱镜折射率合成不确定度的探讨

阐述了非最小偏向角法测量棱镜折射率的实验原理,并用广义正交参量作多元回归求灵敏系数法(THM)计算了结果的合成不确定度.     

附面层吸除对带间隙的高负荷压气机叶栅流动特性影响的实验研究

将附面层吸除技术应用于带间隙的高负荷压气机叶栅中,并在低速平面叶栅风洞里,实验研究了附面层吸除对带间隙的高负荷压气机叶栅流动特性的影响。实验采用五孔气动探针测量了叶栅出口截面参数,得到了该截面的二次流速度矢量分布,并对叶栅壁面进行了墨迹流动显示。结果表明,采用恰当的附面层吸除设置可以大幅改善流动,降低损失;在吸力面附近和间隙内采用附面层吸除(本文的方案1、2和4)都将削弱间隙泄漏流动的动能,从而影响吸力面再附线和端壁分离线的长度和位置,达到对相应区域三维流动分离的控制,并大幅降低总损失,其中方案1的损失下降达到20.8%。     

编码光系统的颜色耦合与颜色失衡校正

为了减小编码光系统中的颜色耦合与颜色失衡的干扰,提高形状与颜色重建的准确度,建立了彩色编码光系统,并对其所采用的编解码方法、颜色重建的两个相关环节及颜色校正方法进行了研究。首先,给出了系统的彩色梯形相移强度比编解码法,分析了编解码过程中存在的RGB基色相互耦合现象,设计了应用Caspi模型硬件标定的颜色耦合校正方案;然后,给出了系统的逐点颜色重建法,分析了颜色重建过程中由表面曲率导致的颜色失衡现象,设计了利用表面几何信息校正颜色失衡的方案。实验结果表明：校正后单一绿色图像中的红色分量值约为校正前的1/10;单色表面色差约为0.1,趋近于人眼颜色分辨率,远低于校正前的0.4;重建的单色复杂被测表面颜色均匀、视觉效果良好,符合实际情况。提出的方法符合编码光系统抗干扰能力强的要求,有助于提高形状与颜色重建的准确度。     

Reanalysis of the photoassociation spectrum of 133Cs2 （6P3/2） lg state

Reanalysis of the photoassociation spectrum of the weakly binding （6S1/2 ＋ 6P3/2） lg 133Cs2 levels, reported in the previous study [J. Mol. Spectro. 255 （2009） 106], is performed by using a Lu-Fano graph coupled to the improved LeRoy- Bernstein formula including two additional modified terms. A more accurate coefficient （c3） is obtained for the leading long-range potential （-c3/R3） of a diatomic molecule.     

Ecological optimization for an irreversible magnetic Ericsson refrigeration cycle

An irreversible Ericsson refrigeration cycle model is established, in which multi-irreversibilities such as finite-rate heat transfer, regenerative loss, heat leakage, and the efficiency of the regenerator are taken into account. Expressions for several important performance parameters, such as the cooling rate, coefficient of performance （COP）, power input, exergy output rate, entropy generation rate, and ecological function are derived. The influences of the heat leakage and the time of the regenerative processes on the ecological performance of the refrigerator are analyzed. The optimal regions of the ecological function, cooling rate, and COP are determined and evaluated. Furthermore, some important parameter relations of the refrigerator are revealed and discussed in detail. The results obtained here have general significance and will be helpful in gaining a deep understanding of the magnetic Ericsson refrigeration cycle.     

Significant photoelectrical response of epitaxial graphene grown on Si-terminated 6H-SiC

Photoelectrical response characteristics of epitaxial graphene (EG) films on Si- and C-terminated 6H-SiC, and transferred chemical vapor deposition (CVD) graphene films on Si-terminated 6H-SiC have been investigated. The results show that upon illumination by a xenon lamp, the photocurrent of EG grown on Si-terminated SiC significantly increases by 147.6%, while the photocurrents of EG grown on C-terminated SiC, and transferred CVD graphene on Si-terminated SiC slightly decrease by 0.5% and 2.7%, respectively. The interfacial buffer layer between EG and Si-terminated 6H-SiC is responsible for the significant photoelectrical response of EG. Its strong photoelectrical response makes it promising for optoelectronic applications.