Asymmetric total synthesis of the antileukaemic lignan precursor (-)steganone and revision of its absolute configuration

A total synthesis of (-)steganone, correlating it with L-glutamic acid, shows it to have the opposite configuration to that assigned by Kupchan.     

Mass spectral rearrangements of N,N-bis(4′-arylthio-2′-butynyl)anilines and N,N-bis(4′-arylsulfonyl-2′-butynyl)anilines

The title compounds display unusual modes of fragmentation under electron impact. One of the dominant modes is the concerted elimination of the two arylthio and arylsulfonyl moieties followed by further extrusion of the C₆H₄ unit as a cumulene. No elimination of SO₂ is observed from any of the sulfones nor an expulsion of the C₄H₄ fragment. Such behavior contrasts strikingly with that of 1,4-diarylsulfonyl-2-butynes and of the 1,6-diarylsulfonyl-2,4-hexadiynes.     

Reactive intermediates in asymmetric cross-coupling catalysed by palladium P-N chelates

The palladium dibromide complexes of (S,R)-(1,1′-bis-diphenylphosphino)-2-ferrocencylthyldimethylamine and (S,R)-(1-diphenylphosphino)-2-ferrocenylethyldimethylamine have been reduced with dilithiocyclooctatetraene to form the corresponding Pd⁰ cyclooctatetraene complexes. Their reactions with E-4-methoxy-2′-bromophenylethene, and then benzylmagnesium chloride at −60 to −30°C, provide information on the structure of intermediates in asymmetric cross-coupling.     

Gas-phase copolymerization of sulfur dioxide and butene-1

Mixtures of sulphur dioxide and butene-1 have been polymerized in the gas phase to the 1:1 alternating copolymer by electron irradiation. The rate of polymerization, measured by the decrease in gas pressure, decreased with increase in temperature over the range ?20 to +30°C. The initial G(-monomer) values decreased from 500 to 50 giving an Arrhenius activation energy of ?30 kJ mol^?1. These results are consistent with a ceiling temperature-pressure relationship. The ceiling temperature is about 60°C lower than that observed previously in the liquid phase in accord with thermo-dynamic prediction.     

Analysis of partially resolved liquid chromatographic peaks using dynamic modeling with the kalman filter

Establishing a calibration model is an important part of any mathematical method for multi-component determination. Use of a calibration model based on single spectra is subject to error, because the model spectrum chosen may not be representative of the response over the full range of the calibration. Alternative calibration models require more time to establish calibration, an these may not be convenient for real-time determinations. A novel calibration method is reported for use with Kalman filters. The method, dynamic modeling, is based on the use of libraries of calibration spectra. The set of used to describe the model at any time is based on component concentrations, estimated for the multi-component mixture, as determined from the Kalman filter, so that several spectra can be used to best describe a varying response. Through application of the dynamic modelingt to simulated and real chromatograms, it is demonstrated that use of the method decreases estimation errors cause by model data mismatches, and that full benefit can be obtained from relatively small libraries.     

The isomerization of optically-active propargyl alcohols to terminal acetylenes.

The isomerization of optically-active secondary propargyl alcohols, RCHOHCC(CH₂)_nCH₃, to terminal acetylenic alcohols, RCHOH(CH₂)_n+1 C=CH, by potassium 3-aminopropylamide (KAPA) proceeds without loss of configuration at the hydroxy center.     

Recherches sur la synthese totale des alcaloides appartenant a la serie de la carpaine et de la cassine—V : Synthese totale de l'acide (±) carpamique

The total synthesis is described of (±) 6-(7-carboxy hept-1-yl) 3-hydroxy 2-methyl piperidine [(±) carpamic acid] in five steps from 1-ethoxycarbonyl 6-methyl hept-5-en-2-one.     

Amperometric detection of hydrazine by cyclic voltammetry and flow injection analysis using ruthenium modified glassy carbon electrodes

Glassy carbon electrodes modified with (5-amino-1,10-phenanthroline)bis(bipyridine)ruthium(II) chloride hydrate, [(bpy)₂Ru(5-phenNH₂)]Cl₂·H₂O, are shown to oxidize hydrazine with excellent sensitivity. The presence of an amine group on the ruthenium complex facilitates electropolymerization onto the electrode surface. Using cyclic voltammetry, a large catalytic current is observed upon oxidation of hydrazine in phosphate buffer (pH 5.0), compared to the current obtained from the ruthenium-modified electrode with no hydrazine present. The sensitivity of cyclic voltammetry is sufficient for obtaining a linear calibration curve for hydrazine over the range of 10⁻⁵ to 10⁻² M. Hydrodynamic amperometry was used to determine the working potential for flow injection analysis. The limit of detection for hydrazine was determined to be 8.5 μM using FIA. The thickness of these films was shown to increase linearly with the number of electropolymerization cycles, in the range of 1000-2500 nm for 5-20 cycles, respectively, using Rutherford backscattering spectrometry (RBS). RBS analysis also suggests that the film is multilayered with the outermost layers containing a high ruthenium concentration, followed by layers where the concentration of ruthenium decreases linearly and approaches zero at the electrode surface.     

Electron binding energies of aqueous alkali and halide ions: EUV photoelectron spectroscopy of liquid solutions and combined ab initio and molecular dynamics calculations

Photoelectron spectroscopy combined with the liquid microjet technique enables the direct probing of the electronic structure of aqueous solutions. We report measured and calculated lowest vertical electron binding energies of aqueous alkali cations and halide anions. In some cases, ejection from deeper electronic levels of the solute could be observed. Electron binding energies of a given aqueous ion are found to be independent of the counterion and the salt concentration. The experimental results are complemented by ab initio calculations, at the MP2 and CCSD(T) level, of the ionization energies of these prototype ions in the aqueous phase. The solvent effect was accounted for in the electronic structure calculations in two ways. An explicit inclusion of discrete water molecules using a set of snapshots from an equilibrium classical molecular dynamics simulations and a fractional charge representation of solvent molecules give good results for halide ions. The electron binding energies of alkali cations computed with this approach tend to be overestimated. On the other hand, the polarizable continuum model, which strictly provides adiabatic binding energies, performs well for the alkali cations but fails for the halides. Photon energies in the experiment were in the EUV region (typically 100 eV) for which the technique is probing the top layers of the liquid sample. Hence, the reported energies of aqueous ions are closely connected with both structures and chemical reactivity at the liquid interface, for example, in atmospheric aerosol particles, as well as fundamental bulk solvation properties.     

Rhodopsin reconstituted into a planar-supported lipid bilayer retains photoactivity after cross-linking polymerization of lipid monomers

Transmembrane proteins (TMPs), particularly ion channels and receptors, play key roles in transport and signal transduction. Many of these proteins are pharmacologically important and therefore targets for drug discovery. TMPs can be reconstituted in planar-supported lipid bilayers (PSLBs), which has led to development of TMP-based biosensors and biochips. However, PSLBs composed of natural lipids lack the high stability desired for many technological applications. One strategy is to use synthetic lipid monomers that can be polymerized to form robust bilayers. A key question is how lipid polymerization affects TMP structure and activity. In this study, we have examined the effects of UV polymerization of bis-Sorbylphosphatidylcholine (bis-SorbPC) on the photoactivation of reconstituted bovine rhodopsin (Rho), a model G-protein-coupled receptor. Plasmon-waveguide resonance spectroscopy (PWR) was used to compare the degree of Rho incorporation and activation in fluid and poly(lipid) PSLBs. The results show that reconstitution of Rho into a supported lipid bilayer composed only of bis-SorbPC, followed by photoinduced lipid cross-linking, does not measurably diminish protein function.