GISAXS and SAXS studies on the spatial structures of Co nanowire arrays

The spatial structures of magnetic Co nanowire array embedded in anodic aluminium membranes were investigated by grazing incidence small angle X-ray scattering (GISAXS) and conventional small angle X-ray scattering (SAXS) techniques. Compared with SEM observation, the GISAXS and SAXS measurements can get more overall structural information in a large-area scale. In this study, the two-dimensional GISAXS pattern was well reconstructed by using the IsGISAXS program. The results demonstrate that the hexagonal lattice formed by the Co nanowires is distorted (a ≈ 105 nm, b ≈ 95 nm). These Co nanowires are isolated into many structure domains with different orientations with a size of about 2 μm. The SAXS results have also confirmed that the nanopore structures in the AAM can be retained after depositing Co nanowires although the Co nanowires can not completely but only just fill up the nanopores. These results are helpful for understanding the global structure of the Co nanowire array.     

Anchoring properties of substrate with a grating surface

The anchoring properties of substrate with a grating surface are investigated analytically. The alignment of nematic liquid crystal (NLC) in a grating surface originates from two mechanisms, thus the anchoring energy consists of two parts. One originates from the interaction potential between NLC molecules and the molecules on the substrate surface, and the other stems from the increased elastic strain energy. Based on the two mechanisms, the expression of anchoring energy per unit area of a projected plane of this grating surface is deduced and called the equivalent anchoring energy formula. Both the strength and the easy direction of equivalent anchoring energy are a function of the geometrical parameters (amplitude and pitch) of a grating surface. By using this formula, the grating surface can be replaced by its projected plane and its anchoring properties can be described by the equivalent anchoring energy formula.     

Erbium-doped CW and Q-switched fiber ring laser with fiber grating Michelson interferometer

The band-pass characteristic of fiber grating Michelson interferometer is analyzed, which acts as bothband-pass filter and Q-switch. An erbium-doped fiber ring laser based on fiber grating Michelsoninterferometer is implemented for producing single longitudinal mode CW operation with 5 MHz spectrallinewidth and up to 6 mW output power. In Q-switched operation, stable fiber laser output pulses withrepetition rate of 800 Hz, pulse width of 0.6 μs, average power of 1.8 mW and peak power of 3.4 W aredemonstrated. The peak power and average power of the Q-switched pulses are varied with the repetitionrate.     

低进汽压力下超音速两相流升压特性实验研究

本文采用实验方法研究了进汽压力为0.2 MPa以下时,由蒸汽喷嘴、混合腔及相应的阀门和管道组成超音速汽液两相流升压加热装置的运行特性。实验表明在进汽压力为0.1 MPa-0.2 MPa时,超音速汽液两相流升压加热装置都可稳定可靠地运行,且升压效果明显,可满足电力、供暖、轻工等许多行业蒸汽加热的要求。     

固体密度秤

根据杠杆平衡原理,使用杠杆平衡仪设计了固体密度秤.采用与液体密度计读数类似的方法,能够直接读出被测固体的密度.     

生长温度和结构参数对InGaAs／GaAs量子阱光学特性的影响

研究了不同生长温度下制备的In0.15Ga0.85As/GaAs应变量子阱的PL谱,结果表明,生长温度越高,In偏析和In-Ga互混越严重,同时,导致更多的In脱附,PL谱发光峰蓝移。对不同In含量的和不同InGaAs厚度的InGaAs/GaAs量子阱进行PL谱测试,分析表明In含量<0.2,生长温度低于560℃时,In含量和InGaAs层量子阱的厚度对In偏析、脱附和In-Ga互混基本没有影响。     

直流电晕充电下环氧树脂表面电位衰减特性的研究

介质材料表面电荷的积累和衰减行为是制约众多高压直流电力设备研制的关键因素. 薄片状介质试样的表面电荷密度与表面电位近似呈线性关系, 因此常通过表面电位衰减行为研究表面电荷的衰减特性. 基于电晕充电、表面电荷沉积和脱陷、介质体内单极性电荷输运等3个物理过程, 建立表面电位动态响应的物理模型. 通过计算环氧树脂的表面电位衰减行为, 得到栅极电压、相对介电常数和体电导率等对其表面电位衰减特性的影响. 栅极电压越高, 表面电位的衰减速度越快; 环氧树脂材料参数典型值(相对介电常数3.93, 体电导率10^-14 S· m^-1)下, 归一化表面电位的衰减速率随时间变化的曲线可拟合为分段幂函数, 其中, 分段幂函数的特征时间、指数系数与栅极电压分别呈幂函数和线性变化关系. 相对介电常数越大, 表面电位的衰减速度越慢; 环氧树脂相对介电常数典型范围(3–4)内, 表面电位衰减时间常数由1720 s增大到2540 s, 两者呈线性关系. 体电导率越大, 表面电位的衰减速度越快; 环氧树脂体电导率典型范围(10^-15–10^-13 S· m^-1)内, 表面电位衰减时间常数由24760 s 减小到260 s, 两者呈幂函数变化关系.     

简析多次实验与多次测量的作用

物理实验的种类很多，其中测量性实验主要以测量为主；演示性实验主要以观察现象为主；验证性实验和探究性实验既有定性研究又有定量分析的成份，学生不仅要观察现象还要进行测量，并对测量结果分析概括．从物理研究的角度来看，必须经过多次实验才能总结某一结论或归纳某一规律．然而从编写教材与执教的方便考虑，现行课本上的实验在其具体过程中有一部分仅需做一次，但大部分仍安排三次以上，这些实验大都与测量有关．进行多次实验与进行多次测量的作用很多，现分类探讨．     

反铁电相变陶瓷低频发射换能器

在具有高阶形式的广义压电方程基础上,讨论掺镧改性锆锡钛酸铅PbLa(Zr,Sn,Ti)O3(PLZST)反铁电相变陶瓷的非线性机电耦合问题,得到类似传统线性压电方程的近似线性电致伸缩方程,给出了一种解决非线性反铁电相变陶瓷换能器电声转换问题的分析方法,即在直流偏置状态下对PLZST反铁电相变陶瓷的材料参数进行近似线性等效化处理进而分析换能器的电声转换问题.在此基础上,研制了水中谐振频率1.1 kHz新型反铁电相变陶瓷低频弯张换能器.湖上试验结果表明,与同结构同尺寸压电陶瓷弯张换能器相比,目前反铁电换能器样品的发射电压响应约高3dB,声源级高出9dB,并验证了本文所提出的分析非线性反铁电相变陶瓷换能器方法的正确性.