Rhombohedral-scalenohedral calcite transition produced by adjusting the solution electrical conductivity in the system Ca(OH)2-CO2-H2O

This work is aimed to investigate the effects of the adjustment of the electrical conductivity (kappa25) during the semicontinuous carbonation of Ca(OH)2 suspension (slaked lime) on the morphology of the precipitated calcite (CaCO3) particles. The experiments were carried out at 30, 45, and 60 degrees C. A gradual morphological change from rhombohedral to scalenohedral shapes was produced with an increase of kappa25 from 1 to 7 mS/cm at each temperature. The explanation of this morphological change is given in terms of the increase of both the supersaturation and the ratio between concentrations of charged species containing calcium and carbonate ([Ca]ch/[CO3]ch) in the aqueous phase as the kappa25 set-point increases, prior to the precipitation process. In addition to the rise of the supersaturation this change most probably takes place because the increase of the [Ca]ch/[CO3]ch ratio affects the growth rate of the rhombohedral {104} and scalenohedral {21-1} faces in a different manner: (i) favoring the equality between the surface coverage of Ca2+ and CO3(2-) on the stoichiometric {104} face, thus enhancing the formation of CaCO3(0) growth units and then its growth rate and (ii) inhibiting the growth of the {21-1} face by adsorption of the excess calcium species.     

Spectroscopy and coordination chemistry of a new bisnaphthalene-bisphenanthroline ligand displaying a sensing ability for metal cations

A new fluorescent macrocyclic structure (L1) bearing two naphthalene units at both ends of a cyclic polyaminic chain containing two phenanthroline units was investigated with potentiometric and fluorescence (steady-state and time-resolved) techniques. The fluorescence emission spectra show the simultaneous presence of three bands: a short wavelength emission band (naphthalene monomer), a middle emission band (phenanthroline emission), and a long-wavelength band. All three bands were found to be dependent on the protonation state of the macrocyclic unit (including the polyaminic and phenanthroline structures). The existence of the long-wavelength emission band is discussed and is shown to imply that a bending movement involving the two phenanthroline units leads to excimer formation. This is determined by comparison with the excimer emission formed by intermolecular association of 1,10-phenanthroline. With ligand L1, excimer formation occurs only at pH values above 4. At very acidic pH values, the protonation of the polyamine bridges is extensive leading to a rigidity of the system that precludes the bending movement. The interaction with metal cations Zn(II) and Cu(II) was also investigated. Excimer formation is, in these situations, increased with Zn(II) and decreased with Cu(II). The long-emission band is shown to present a different wavelength maximum, depending on the metal, which can be considered as a characteristic to validate the use of ligand L1 as a sensor for a given metal.     

Continuous flow system for lead determination by faas in spirituous beverages with solid phase extraction and on-line copper removal

A continuous flow system for the determination of lead in home made spirituous beverages was developed. The determination was based on the formation of a neutral chelate of the element with ammonium pyrrolidine dithiocarbamate, its adsorption onto a minicolumn packed with sodium faujasite type Y synthetic zeolite, followed by elution with methyl isobutyl ketone and determination by flame atomic absorption spectrometry. Ethanol and copper interfere strongly in the determination and therefore, must be separated prior to the analysis. Copper is removed by precipitation with rubeanic acid, while ethanol is eliminated by rotaevaporation. Sample solutions containing Pb²⁺ in the concentration range from 5 to 120 μg l⁻¹ at pH 2.5 could be analyzed, by using a preconcentration time of 3 min. Preconcentration factors from 80 to 140 were achieved for a sample volume of 6 ml and the detection limit varied from 1.4 to 3.5 μg l⁻¹, depending on the matrix composition. The relative standard deviations for 60 μg l⁻¹ Pb was 3.2% (n = 10) and the recovery of spikes (20, 40, 60 and 80 μg l⁻¹) added to the samples was estimated within 92–105% range, suggesting that lead can be quantitatively determined in such samples. Determining lead in several samples by an alternative technique further checked the accuracy. Finally, the concentrations of Pb²⁺ determined in 28 samples of Venezuelan spirituous beverages were in 12.6–370.0 μg l⁻¹ range, depending on the fermenting material based on different mixtures of agave, raw sugar cane and white sugar.     

Evaluation of protein-A chromatography media

In process-scale antibody purification, protein-A affinity chromatography is commonly used as the initial purification step. In this paper, two different protein-A media were evaluated. These adsorbents have a porous glass backbone with different pore sizes: 700 A and 1000 A. Adsorption equilibrium data of human immunoglobulins on these media were measured via a batch technique and correlated using the Langmuir isotherm model. A larger static capacity was found for the smaller pore size material, which is probably a result of the larger specific surface area and associated higher ligand concentration. The protein uptake kinetics were also obtained via a stirred tank experiment using different initial protein concentrations. A surface layer model was used to represent the protein uptake by the media and to estimate values of a concentration-independent effective diffusivity within the particle. Experimental breakthrough curves were also obtained from packed beds operated under different conditions. Calculated breakthrough profiles were found to be in good agreement with the experimental results. Experimental breakthrough data were used to determine the dependence of the dynamic capacity of the media as a function of the fluid residence time. A larger dynamic capacity was also found for the smaller pore size media. The permeability of large scale packed beds was also reported and used in conjunction with the dynamic capacity to calculate the process production rate.     

Cyclic vinyl p-tolyl sulfilimines as chiral dienophiles: theoretical study on the stereoselectivity, Lewis acid catalysis, and solvent effects in their Diels-Alder reactions

The theoretical study reported in the present work deals with chiral cyclic vinyl sulfilimines and their reactivity as dienophiles in [4 + 2] cycloaddition reactions, using B3LYP/6-31G(d)//AM1 and B3LYP/6-31G(d)//B3LYP/6-31G(d) model chemistries. Consideration of Lewis acid catalysis, illustrated by BF(3), decreases the activation energies of the cycloaddition process while the charge transfer from the diene to the sulfilimine is augmented. The [4 + 2] cycloaddition reactions of sulfilimines with both furan and cyclopentadiene occur in the gas phase with endo stereoselectivity, which is more pronounced with the latter diene. Endo-exo energy differences in the gas phase with the B3LYP/6-31+G(d)//B3LYP/6-31+G(d), B3LYP/6-31G(d)//B3LYP/6-31G(d), and B3LYP/6-31G(d)//AM1 model chemistries are almost the same. Solvent effects are responsible for the inversion of the stereoselectivity in the reactions of sulfilimines with furan because of the great difference in the dipole moments in endo and exo approaches.     

Retention process in reversed phase TLC systems with polar bonded stationary phases

The retention of a solute in RP chromatography is a very complex process which depends on many factors. Therefore, the study of the influence of a mobile phase modifier concentration on the retention in different reversed phase chromatographic systems is very important for understanding the rules governing retention and mechanisms of substance separation in a chromatographic process. Composition changes and the nature of mobile phases enable tuning of the separated analytes' retention over a wide range of retention parameters and optimization of the chromatographic process as well. Optimization of the chromatographic process can be achieved by several different methods; one of them is the so-called interpretative strategy. The key approach adopted in this strategy is the implementation of adequate retention models that couple the retention of solute with the composition of a mixed mobile phase. The use of chemically bonded stationary phases composed of partially non-bonded silica matrix and organic ligands bonded to its surface in everyday chromatography practice leads to questions of the correct definition of the retention model and the dominant retention mechanism in such chromatographic systems. The retention model for an accurate prediction of retention factor as a function of modifier concentration and the heterogeneity of the adsorbent surface should be taken into consideration. In this work the influence of mobile-phase composition on the retention of sixteen model substances such as phenols, quinolines, and anilines used as test analytes in different RP-TLC systems with CN-, NH2-, and Diol-silica polar bonded stationary phases has been studied. The aim of this study is to compare the performance of three valuable retention models assumed as the partition, adsorption/partition, and adsorption mechanism of retention. All the models were verified for different RP-TLC systems by three statistical criteria. The results of investigations presented in this work demonstrate that the best agreement between the experimental and calculated Rf values was obtained by the use of new-generation retention models, which assume heterogeneity of adsorbent surface. The results reported here show that heterogeneity of the adsorbent surface may be important in analysis of the elution process in liquid chromatography. Consideration of the goodness of fit for the experimental data to the examined retention models is in conformity with the adsorption mechanism of retention on all polar bonded stationary phases in most eluent systems for most investigated compounds.     

Development of a new flow-through bulk optode for the determination of manganese(III)

A flow-through bulk optode based on the use of 1-(2-pyridylazo)-2-naphthol (PAN) immobilized in a plasticized poly(vinyl chloride) membrane entrapped in a cellulose support, in conjuntion with the flow injection analysis technique, is proposed for the determination of manganese(II). The calibration graph obtained at 570 nm was linear in the range 0.27-27.5 mg L(-1) (5 x 10(-6)-5 x 10(-4) M) Mn(II) with a detection limit of 0.18 mg L(-1). The coefficients of variation of the sensor response for 5.5 mg L(-1) of Mn(II) were +/-0.22% for consecutive measurements (n = 10), +/-0.48% between days (n = 5) and +/-0.38% between different membranes (n = 6). The sensor was readily regenerated with the carrier acetic acid/acetate buffer of pH 4.5. The method was applied to the determination of manganese in steels, waters and lemon tree leaves.     

The effect of green laser light irradiation on whole blood platelets

BACKGROUND: Laser light irradiation is assumed to have biostimulating effect in various cell types. However, there is still a lack of information concerning response of blood platelets to laser light irradiation. METHODS: In our study we used flow cytometry to monitor the effect of a green Nd-YAG laser (532 nm, 30 mW) irradiation on platelet activation and the expression of activated GPIIbIIIa glycoprotein complex (fibrinogen receptor) of whole blood platelets stained with fluorolabelled monoclonal antibody PAC-1. Also the formation of platelet microparticles and aggregates in a population of whole blood platelets following such irradiation was evaluated. RESULTS: Effects of laser light on platelet activation and reactivity were significant over a wide range of applied energies (p<0.01). While low and medium laser light energies (18 and 54 J) increased platelet activation, the irradiation with a high-energy laser light (108 J) resulted in depressed platelet reactivity and attenuated platelet response to activators. In addition, laser light irradiation had significant influence on the formation of platelet microparticles in either resting (p<0.05) or ADP-activated (p<0.05) platelets, while no significant effect was observed in collagen-activated platelets. On the other hand, laser light irradiation significantly increased the formation of platelet aggregates both in resting (p<0.01) and agonists-activated (p<0.05) platelets. CONCLUSIONS: Our results clearly point that the laser light irradiation of blood platelets can trigger signal transduction, leading to platelet activation, as well as the gradual loss of natural platelet reactivity and platelets' ability to respond to activating agents.     

Microwave assisted extraction of polycyclic aromatic hydrocarbons from atmospheric particulate samples

For several years, microwave assisted extraction (MAE) was applied to extract organic compounds such as polycyclic aromatic hydrocarbons (PAHs), polychlorinated biphenyls, etc., from soils, sediments and standard reference materials. Very few authors applied this methodology for the extraction of PAHs from atmospheric particulate matter. In the present study, MAE of polycyclic aromatic hydrocarbons with hexane/acetone (1:1) from real atmospheric particulate samples was investigated and the effect of microwave energy and irradiation time studied. The yields of extracted compounds obtained by microwave irradiation were compared with those obtained using traditional Soxhlet extraction. MAE was evaluated using spiked real atmospheric particulate samples and two standard reference materials. Analytical determinations of PAHs were carried out by high performance liquid chromatography (HPLC) with ultraviolet and fluorescence detection. The best recoveries were achieved with a microwave energy of 400 W and an irradiation time of 20 min.     

Magnetism of cyano-bridged hetero-one-dimensional Ln3+-M3+ complexes (Ln3+ = Sm,Gd, Yb; M3+ = FeLS,Co)

The reaction of Ln(NO(3))(3).aq with K(3)[Fe(CN)(6)] or K(3)[Co(CN)(6)] and 2,2'-bipyridine in water led to five one-dimensional complexes: trans-[M(CN)(4)(mu-CN)(2)Ln(H(2)O)(4) (bpy)](n)().XnH(2)O.1.5nbpy (M = Fe(3+) or Co(3+); Ln = Sm(3+), Gd(3+), or Yb(3+); X = 4 or 5). The structures for [Fe(3)(+)-Sm(3+)] (1), [Fe(3)(+)-Gd(3+)] (2), [Fe(3)(+)-Yb(3+)] (3), [Co(3)(+)-Gd(3+)] (4), and [Co(3)(+)-Yb(3+)] (5) have been solved; they crystallize in the triclinic space P1 and are isomorphous. The [Fe(3+)-Sm(3+)] complex is a ferrimagnet, its magnetic studies suggesting the onset of weak ferromagnetic 3-D ordering at 3.5 K. The [Fe(3+)-Gd(3+)] interaction is weakly antiferromagnetic. The isotropic nature of Gd(3+) allowed us to evaluate the exchange interaction (J = 0.77 cm(-)(1)).